A mixture of 5.0 g A, 5.0 g B, and 5.0 g C were separated by recrystallization using ethyl acetate as the recrystallization solvent. Shown below are the solubilities (in g/100 mL solvent) of A, B, and C in ethyl acetate. A B cold hot cold hot cold Hot 1.7 2.5 2.2 3.6 1.6 5.3 What is the percent purity of the obtained crystal after one recrystallization?

A mixture of 5.0 g A, 5.0 g B, and 5.0 g C were separated by recrystallization using ethyl acetate as the recrystallization solvent. Shown below are the solubilities (in g/100 mL solvent) of A, B, and C in ethyl acetate. A B cold hot cold hot cold Hot 1.7 2.5 2.2 3.6 1.6 5.3 What is the percent purity of the obtained crystal after one recrystallization?

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 29QRT

See similar textbooks

Similar questions

Although other solvents are available, dichloromethane(CH₂Cl₂) is still often used to “decaffeinate” drinks because thesolubility of caffeine in CH₂Cl₂ is 8.35 times that in water.(a) A 100.0-mL sample of cola containing 10.0 mg of caffeine is extracted with 60.0 mL of CH₂Cl₂. What mass of caffeine re-mains in the aqueous phase? (b) A second identical cola sampleis extracted with two successive 30.0-mL portions of CH₂Cl₂.What mass of caffeine remains in the aqueous phase after each extraction? (c) Which approach extracts more caffeine?
Below is a solubility table for an unknown organic soli. The solid is white with a melting point of 75°C . Which of the solvent would you use for recrystallization? Explain your choice
Cyclonite, also known as RDX (Research Department Explosive), is used to make Semtex, a plastic explosive, when mixed with PETN. Semtex was used in the bomb that brought down PanAm flight 103 over Lockerbie, Scotland in 1988 killing 270 people. RDX is typically recrystallized from acetone. 1 gram of RDX is soluble in 100 mL of cold acetone (0 0C) and in 25.0 mL of boiling acetone. A student performed recrystallization starting with using 5.0 mL of acetone. a. What is the maximum amount of crude RDX the student can purify given this volume of acetone in order to maximize the % recovery? b. A student reported 65% recovery from the process of recrystallization after using 5.0 mL of acetone and the mass that can be used with that volume (part a). Is 65% the maximum % recovery of RDX using the volume you calculated in part a? Show your work.
If you know that sodium bicarbonate has a solubility of 8.4 g in 100g water at 18 °CI. Calculate (a) the molarity and (b) the molality of 8.4 g of Sodium bicarbonate in water II. if you had 200 mls of water, what is the minimum amount of Sodium bicarbonate that you will require to achieve supersaturation? III. If 150 mls of a stock solution of sodium bicarbonate having a concentration of 0.5 M was diluted to 300 mls. What will be the final concentration of the diluted solution?
A nearly saturated solution of 0.40 g L-ascorbic acid in 75 mL water is to be extracted into 75 mL diethyl ether. How much percentages of L-ascorbic acid would be extracted using multiple extraction of three equal portions of fresh diethyl either? (Taking the ratio of the compound's solubility in diethyl ether compared to water gives an approximate K of 5). Show your calculation steps in the answer.
Students were tasked to conduct a recrystallization experiment to test the ability of the newly discovered solvents in their laboratory to purify and separate a mixture containing compounds X and Y. The solubility of the two compounds in g/50 mL of hot and cold solvents are given by the photo.
50.0 mL of a 0.60 M solution of pyridine in ethanol is to be prepared by measuring out a known volume of pure liquid pyridine and diluting to 500 mL with ethanol. The molar mass of pyridine is 79.1 g/mol, and its density at room temperature is 0.982 g/mL. What volume of pyridine is required for this solution?
The generic metal hydroxide M(OH)2 has Ksp = 8.45×10−12. (NOTE: In this particular problem, because of the magnitude of the Ksp and the stoichiometry of the compound, the contribution of OH− from water can be ignored. However, this may not always be the case.) What is the solubility of M(OH)2 in a 0.202 M solution of M(NO3)2?Express your answer with the appropriate units.
The solubility of InF3 is 4.0 x 10-2 g/100mL Ksp was solved to be 7.6 x 10-10 with MW (InF3): 172g/mol and the equation InF3 --> In3+ + 3F- If 0.050 moles of potassium fluoride are added, what is the solubility of InF3?
The solubility of a novel compound at 25 °C is 5.00 g/mL in water and 25.00 g/mL in ether. Calculate Kd
The aqueous solubility of AgOCN at 20°C is 7.00 mg/100mL. What is the Ksp of AgOCN at 20°C?
How much 1.0 M sodium bicarbonate solution (in mL) is needed to stoichiometrically react with 25 mL of 4.5% (w/v) acetic acid? Molecular weight of sodium bicarbonate = 84.007 gmol, molecular weight of acetic acid = 60.052 g/mol please provide explanation