Engineering

Electrical EngineeringQ&A LibraryA motor having a suitable control circuit develops a torque given by the relationship Ty = bw? +4, where b is constant. This motor is used to drive a load whose torque is expressed as T, = aw + 3. where a is positive constants. The total inertia of rotating masses is J. (1) Under these conditions, the motor can be starting? (i) Calculate the equilibrium speed.Start your trial now! First week only $4.99!*arrow_forward*

Question

A motor having a suitable control circuit develops a torque given by the relationship Ty = bw? +4, where b is constant. This motor is used to drive a load whose torque

is expressed as T, = aw + 3. where a is positive constants. The total inertia of

rotating masses is J.

(1) Under these conditions, the motor can be starting? (i) Calculate the equilibrium speed.

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: In the circuits , the Zener breakdownvoltages of the collector-base and emitter-basejunctions of the...

A: Circuit diagram is given as, Here, in the circuit the collector terminal and base terminal are conn...

Q: Use the node-voltage method to find the power dissipated in the 5 Ω resistor in the circuit shown.

A: Redrawing the circuit diagram,

Q: The magnetic circuit shown in Figure P13.11 hastwo parallel paths. Find the flux and flux density in...

A: Given values N = 1000 turns, I = 0.2 A, lg1 = 0.02 cm, lg2 = 0.04 cm, µr = 1 Expression of reluctanc...

Q: Find :ResponsesSteady stateSteady state errorRouth stability

A: Click to see the answer

Q: The npn transistor is connected in an alternate“diode” configuration. Use the transport model equati...

A:

Q: How to write code for sonar sensor? Write down the code to display the reading of a sonar sensor in ...

A: An ultrasonic sensor works on the principles of the sonar and is often termed as the sonar sensor. T...

Q: The rotor winding current for a four-pole synchronous ac generator with a distributed rotor winding ...

A: poles =4, winding factor=0.9, air gap length =0.6 mm, number of turns =263, peak flux density =1.6 T...

Q: Suppose that a certain npn transistor has VBE=0.7 V for IE = 10 mA. Compute VBE for IE = 1 mA. Repea...

A: Given:

Q: A 120-V-rms 60-Hz sinusoidal voltage appears across a 500-turn coil. Determine the peak and rms valu...

A: Given: f = 60 Hz; Erms = 120 V; N = 500 turns Calculate other parameters, The sinusoidal voltage a...

Q: what is Special purpose transistors and drivers applications, types , uses disadvantages and advanta...

A: The transistor is a semiconductor device which amplifies switch electronic signals and electric powe...

Q: The transistor having the characteristics shown in Figure P12.18 is operating with iC=8 mA and vCE =...

A: Given ic = 8 mA, VCE = 12 V Locating operation point on input characteristic at ib = 20 µA, graph sh...

Q: The current flowing into the collector lead of a certain bipolar junction transistor (BJT) is measur...

A: Current of 1 nA flows into the collector lead for 1 min(= 60 sec). Charge, Q = current x time

Q: Questions: 1. Are the experimental and theoretical values of voltages and currents match? Indicate t...

A: Part (1): The experimental value is the measured value during the experiment. Whereas the theoretica...

Q: calculat the thevnin equvalent in the circuit of terminal ab

A: Modified circuit is:

Q: Draw the electrical analogue of the mechanical system shown. (Hint: Draw the loops corresponding to ...

A: Let xm be the displacement of mass m, and xA be the displacement of point A. Draw the free body diag...

Q: Suppose you are asked to generate the waveforms as shown in figure 1, continuous over time, using th...

A: Click to see the answer

Q: The line-to-neutral voltage at the terminals of the balanced threephase load in the circuit shown is...

A: Click to see the answer

Q: How many resistors and comparators are required to implement a 10-bit flash ADC?

A: Number of bits in flash type ADC is given, n=10 Number of comparator used in flash type ADC is given...

Q: What is an ideal diode? Draw its volt–ampere characteristic. After solving a circuit with ideal diod...

A: Click to see the answer

Q: 4. Design a 1C555 timer based automatic water tap mechanism with the following conditions: Water flo...

A: Click to see the answer

Q:

A: Click to see the answer

Q: i)With a well labelled and logic diagram , and a well drawn truth table describe and explain the mod...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: The Position of a moving vector point in s pace i S given by 3/2 RCE) =t cost i + Esint j + 3. Tind ...

A: Position vector at t = 0, Position vector at t = ∏,

Q: Assume that the switch in the circuit of has been inposition a for a long time and that at t=0 it i...

A: Since we only answer up to 3 sub-parts, we will answer the first 3.Please resubmit the question and ...

Q: 40 The transistor shown in Figure P10.40 has Vy = 0.6 V. Determine values for R1 and R2 such that a....

A: Click to see the answer

Q: Find the equivalent capacity between x and y ??

A: Click to see the answer

Q: Find the slope of the voltage transfer characteristic(i.e., the voltage gain) at the input voltage f...

A: Click to see the answer

Q: Using the parts listed in TableP13.36 , design a single-op-amp differential amplifier having a nomin...

A: Differential amplifier with instrumentation quality

Q: Q: Explain in details with all figures and equations the modulation index of Amplitude Modulation (A...

A: Click to see the answer

Q: Q2/ Find the dimensions of arectamgular box oPen at the top having Volume of 32m

A: Given volume of rectangular box Surface area of rectangular box open at the top

Q: Find the positive common-mode input voltage range for the differential amplifier as shown if VCC = V...

A: Given VCC = VEE = 15 V, RC = REE Calculating common mode input voltage gain

Q: A periodic function is represented by a Fourier series that has afinite number of terms. The amplitu...

A: Click to see the answer

Q: 9] and the value for the density function in this interval is 0.5. Find the value of a. (a) 7 (b) 9 ...

A: According to the question Given interval is [a, b]=[a,9] Calculate value of a

Q: Find C/R for the following system using Mason's gain rule G9 G8 G7 G5 G6 G2 G3 G4

A: Click to see the answer

Q: Please, I need to solve this question

A: given function F=A'C+AB'C'+B'C

Q: A digital resonator is required to be designed including 3 dB bandwidth, with frequency Na, that yie...

A: Digital Resonator: A digital resonator is a special kind of bandpass filter having a pair of complex...

Q: The three parallel loads in the circuit shown can bedescribed as follows: Load 1 is absorbing an ave...

A: The voltage across each load is same as VO because all the loads are connected in parallel. The angl...

Q: Compare full wave bridge rectifier with two diode rectifier ?

A: Below table shows the comparison between full wave bridge rectifier and full wave two diode rectifie...

Q: A perfect gas undergoes isothermal compression, which reduces its volume by 1.80 dm3. The final pres...

A: Since the gas is a ideal gas and undergoes isothermal process, The temperature is constant, when we ...

Q: Plotting the Amplitude and Phase Spectra for a Periodic Voltage Suppose that for the periodic voltag...

A: The expression for the complex exponential Fourier series expansion is given by:

Q: What is the resonant frequency

A: The mutual inductance is determined as:

Q: List the probable causes if the armature dos notable release after the magnetic starter is de - ener...

A: Upon de-energizing the magnetic starter, the armature should release.

Q: Calculate S, S, and S for the high-pass filter described by Eq. (12.26).

A: Click to see the answer

Q: S.4) the length of a three-phase power transmission line with a Nominal operating voltage of 69 kV i...

A: Given: Nominal operating voltage, Transmission line impedance, Length of transmission line, Power of...

Q: What made communication at silver lines more effective initially?

A: Interpersonal communication made communication more effective at silver lines. Interpersonal communi...

Q: 5. Determine the short - circuit current of the following circuit. a) 2 mA

A: Click to see the answer

Q: The gate resistor RG shown is said to be “bootstrapped” by the action of the source follower. (a) As...

A: Click to see the answer

Q: Design a logic circuit for a 3-bit message to be transmitted with an even parity bit.

A: It is a logic circuit that receives a three bits treams and outputs an extra bit along with the data...

Q: Q1: Comment on each step you need to obtain the second order transfer function which gives the follo...

A: Click to see the answer

Q: Find the expression similar to Eq. (17.200) for the output voltage for the mixer as shown if input υ...

A: