A new design of Saturn 10 rocket with mass 1.08 x106 kg has a propulsion engine that can eject gases at a constant speed of 245.26 m/s (vGas) by burning fuel at a rate of 3.74  x10 5  kg/s (dmdT). In full tank, the rocket can carry a fuel of mass 46.95  x10 6  kg. If this design exceeds the velocity of 11,200 m/s it can can successfully escape Earth's gravity. Determine if this is so. Find its maximum velocity

Q: Air flows steadily at the rate of 30 kg/min through an air compressor entering at a velocity of 7 m/…

A: Given,  Mass flow rate, m˙=30 kg/min Inlet velocity, v1=7 m/s Inlet pressure, p1=100 kPa Inlet…

Q: A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0…

A: Given, Speed,  N=1480 rpm Volume rate, Q=6m3/min Inlet pressure, P1=950 m bar Inlet Temperature,…

Q: A fluid moves in a steady flow manner between two sections in a flow line. At the entrance section…

A:

Q: Water flowing steadily at a rate of 0.16 m3/s is deflected downward by an angled elbow as shown. For…

A: The point 2 is taken as reference point as shown in figure below :

Q: Water flowing steadily at a rate of 0.17 m3/s is deflected downward by an angled elbow and exits to…

A: Given: ρ=1000kg/m3D=30cm=0.3md=10cm=0.1mh=50cm=0.5mVelbow=0.03m3Q=0.17m3/s

Q: Commercially available large wind turbines have blade span diameters larger than 100 m and generate…

A: Given data: Blade span diameter, d = 75 m Radius of blade, r = 37.5 m Wind velocity, v = 25 km/h =…

Q: Air flows in a steady manner through a converging tube. At the inlet there are 690kPaa and…

A: A steady flow occurs when the amount of liquid flowing per second through any segment remains…

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: Water is flowing through a 10-cm-diameter water pipe at a rate of 0.1 m3/s. Now a diffuser with an…

A: Given: The of pipe at the section of bolt, d = 10 cm The diameter of the pipe at the exit, D = 20 cm…

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: 6-38 Water flowing in a horizontal 25-cm-diameter pipe at 8 m/s and 300 kPa gage enters a 90° bend…

A:

Q: at a point upstream of the throat in a converging-diverging nozzle the velocity temperature and…

A: Given Datau1=192m/sT1=41°Ck=1.4A'=0.03m2P1=282kPa

Q: the exhaust of a turboject engine the nozzle is operating steadily and heat loss is assumed…

A:

Q: If velocity of entering air and jel are 150 m/ s and 350 m/s, the thrust power will be equal to…

A:

Q: At the exhaust of a turboject engine the nozzle is operating steadily and heat loss loss is assumed…

A: given data enthalpy at inlet = 3224 KJ/kg velocity at inlet = 278 km/hr inlet area = 0.21 m^2…

Q: A pipe carrying water has an inlet of diameter 0.18 m and an outlet which is 1.11 m below the inlet…

A:

Q: Consider water flow through a horizontal, short garden hose at a rate of 30 kg/min. The velocity at…

A: Given: The mass flow rate of the water, m = 30 kg/min The inlet velocity of the water, v1 = 1.5 m/s…

Q: A Pelton wheel turbine is a type of turbine that transforms the kinetic energy of water jet to…

A:

Q: Water is flowing through a 15-cm-diameter pipe that consists of a 3-m-long vertical and 2-m-long…

A: Given Data: The diameter of pipe is d = 15 cm. Velocity of water leaving is v = 5 m/s. The mass of…

Q: A U-tube acts like a water siphon. The elbow in the tube is 1 m above the water surface, the tube…

A:

Q: The air with a density of 1.1 kg / m^3 enters the duct of the air conditioning system with a flow…

A:

Q: At the exhaust of a turboject engine the nozzle is operating steadily and heat loss is assumed…

A:

Q: How can you define impulsive force in terms of momentum.

A:

Q: Consider water flow through a horizontal, short garden hose at a rate of 30 kg/min. The velocity at…

A: Given, mass flow rate of water, m˙=30 kg/min=0.5 kg/s Velocity of the flow at inlet and outlet of a…

Q: A hydraulic turbine is used to generate power by using water in a dam. The elevation difference…

A:

Q: Consider water flow through a horizontal, short garden hose at a rate of 0.5 kg/s. The velocity at…

A:

Q: A water jet strikes a stationary vertical plate horizontally at a rate of 7 kg/s with a velocity of…

A: Given: The mass flow rate of the water is m=7 kg/s. The velocity of the water strike is v=35 km/h.

Q: Methane, with a density of 0.52 kg/m3, enters a burner with a velocity of 30 m/s through a…

A:

Q: Water vapor enters the tub with an inlet cross section of 0.02 m2 at 20 bar pressure and a density…

A: Given dataArea of cross section of nozzle at inlet = 0.02m2Pressure at inlet P1 = 20barDensity at…

Q: What is the overall efficiency of the turbine if the power developed is 15,000 kW at a head of 150…

A:

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves the same stage with…

A: Given Data⇒ Properties of steam at entry of turbine : h1=3628KJkgv1=70ms Properties of steam at exit…

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: is 11.75 m/s. The hose makes a 180° turn before the water is discharged. Disregard the weight of the…

A:

Q: A 3-cm-diameter horizontal pipe attached to a surface makes a 90° turn to a vertical upward…

A: Given data D=0.03 mV=9 m/sec

Q: An end-burning rocket motor has a chamber diameter of 10 cm and a nozzle exit diameter of 8 cm. The…

A:

Q: When is the conservation of linear momentum often applied?

A: In physics, the term conservation refers to something which doesn't change. This means that the…

Q: Nitrogen is expanded isentropically in a nozzle from a pressure of 2000 kPa, at a temperature of…

A:

Q: Methane, with a density of 0.52 kg/m3, enters a burner with a velocity of 30 m/s through a…

A: The density of the methane is d1=0.52 kg/m3. The velocity of methane entering the burner is V1=30…

Q: At the exhaust of a turboject engine the nozzle is operating steadily and heat loss is assumed…

A:

Q: The type of steady flow system in which, two streams of fluids m1 and m2 are entering and one stream…

A:

Q: Water flowing steadily at a rate of 0.16 m3/s is deflected downward by an angled elbow as shown. For…

A: Consider the following control volume. Let Fx and Fy be the forces by the flange on the control…

Q: Consider water flow through a horizontal, short garden hose at a rate of 40 kg/min. The velocity at…

A: Given data: The flow rate, ṁ = 40 kg/min. The velocity at inlet, Vin = 1.5 m/s. The velocity at…

Q: The shaft power from a 90 percent-efficient turbine is 500 kW. If the mass flow rate through the…

A: Given data: The efficiency of the turbine, η = 90%. Output shaft power, Pout = 500 kW. The mass…

Q: A reducing elbow in a horizontal pipe is used to deflect water flow by an angle 0 = 56° from the…

A:

Q: A certain amount of air, which is at rest, enters a fan suction at a pressure of 95 kPa and a…

A: Given that, Pressure of air, P1=95 kPa,Temperature of air, T1=85 °C,Discharge pressure, P2=150…

Q: 36 - Water flows at a speed of 0.75 m/s in a 6 cm diameter pipe. What is the mass flow rate of the…

A:

Q: Consider a turbojet powered airplane flying at a standard altitude of 8.5 km at a velocity of 108…

A: