A parallel-plate capacitor has a plate separation d%34 mm. A potential difference V=1758 volts exists between the plates. What is the magnitude of the force (in Newton) on a proton between the plates?. The charge of proton e=1.6*10-19 C. A. None B. 4.136-10-15 C. 9.096-10-8 D. 8.273-10-15 E. 1.655-10-14

A parallel-plate capacitor has a plate separation d%34 mm. A potential difference V=1758 volts exists between the plates. What is the magnitude of the force (in Newton) on a proton between the plates?. The charge of proton e=1.6*10-19 C. A. None B. 4.136-10-15 C. 9.096-10-8 D. 8.273-10-15 E. 1.655-10-14

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter16: Electrical Energy And Capacitance

Section: Chapter Questions

Problem 7P: Oppositely charged parallel plates are separated by 5.33 mm. A potential difference of 600. V exists...

See similar textbooks

Similar questions

In nuclear fission. a nucleus splits roughly in half. (a) What is the potential 2.00 10-14 m from a fragment that has 46 protons in it? (b) What is the potential energy in MeV of a similarly charged fragment at this distance?
(a) What is the final speed of an electron accelerated from rest through a voltage of 25.0 MV by a negatively charged Van de Graff terminal? (b) What is unreasonable about this result? (c) Which assumptions are responsible?
From a distance of 10 cm, a proton is projected with a speed of v=4.0106 m/s directly at a large, positively charged plate whose charge density is =2.0105 C/m2. (See below.) (a) Does the proton reach the plate? (b) If not, how far from the plate does it turn around?
(a) Calculate the number of electrons in a small, electrically neutral silver pin that has a mass of 10.0 g. Silver has 47 electrons per atom, and its molar mass is 107.87 g/mol. (b) Imagine adding electrons to the pin until the negative charge has the very large value 1.00 mC. How many electrons are added for every 109 electrons already present?
A lightning bolt strikes a tree, moving 20.0 C of charge through a potential difference of 1.00102 MV. (a) What energy was dissipated? (b) What mass of water could be raised from 15 °C to the boiling point and then boiled by this energy? (c) Discuss the damage that could be caused to the tree by die expansion of the boiling steam.
An electrostatic paint sprayer has a 0.200-m-diameter metal sphere at a potential of 25.0 kV that repels paint droplets onto a grounded object. (a) What charge is on the sphere? (b) What charge must a 0.100-mg drop of paint have to arrive at the object with a speed of 10.0 m/s?
(a) Find the potential difference VB required to stop an electron (called a slopping potential) moving with an initial speed of 2.85 107 m/s. (b) Would a proton traveling at the same speed require a greater or lesser magnitude potential difference? Explain. (c) Find a symbolic expression for the ratio of the proton stopping potential and the electron stopping potential, Vp/Ve. The answer should be in terms of the proton mass mp and electron mass me.
A simple and common technique for accelerating electrons is shown in Figure 7.46, where there is a uniform electric field between two plates. Electrons are released, usually from a hot filament, near the negative plate, and there is a small hole in the positive plate that allows the electrons to continue moving, (a) Calculate the acceleration of the electron if the field strength is 2.50104 N/C . (b) Explain why the electron will not be pulled back to the positive plate once it moves through the hole. Figure 7.46 Parallel conducting plates with opposite charges on them create a relatively uniform electric field used to accelerate electrons to the right. Those that go through the hole can be used to make a TV or computer screen glow or to produce X- rays.
A research Van de Graaff generator has a 2.00-rn- diameter metal sphere with a charge of 5.00 mC on it. (a) What is the potential near its surface? (b) At what distance from its center is the potential 1.00 MV? (C) An oxygen atom with three missing electrons is released near the Van de Graatf generator. What is its energy in MeV at this distance?
(a) Find the potential difference VB required to stop an electron (called a slopping potential) moving with an initial speed of 2.85 107 m/s. (b) Would a proton traveling at the same speed require a greater or lesser magnitude potential difference? Explain. (c) Find a symbolic expression for the ratio of the proton stopping potential and the electron stopping potential, Vp/Ve. The answer should be in terms of the proton mass mp and electron mass me.
Figure CQ16.3 shows equipotential contours in the region of space surrounding two charged conductors. Find (a) the work WAB in electron volts done by the electric force on a proton that moves from point A to point B. Similarly, find (b) WAC, (c) WAD, and (d) WAE. Figure CQ16.3
An electron is to be accelerated in a uniform electric field having a strength of 2.00106 V/m. (a) What energy in keV is given to the electron if it is accelerated through 0.400 m? (b) Over what distance would it have to be accelerated to increase its energy by 50.0 GeV?