A piece of wire of length 31.5 cm and cross-sectional area 227.4 cm² is made into a resistor of resistance 713.8 ohm. What is the resistivity of the material used to create the resistor? O a. 5113020.78 ohm-metre O b. 10.04 ohm-metre O c. 5152.96 ohm-metre Od. 98.88 ohm-metre O e. 51.53 ohm-metre Of. 515295.62 ohm-metre O g. 0.10 ohm-metre h. 0.99 ohm-metre

A piece of wire of length 31.5 cm and cross-sectional area 227.4 cm² is made into a resistor of resistance 713.8 ohm. What is the resistivity of the material used to create the resistor? O a. 5113020.78 ohm-metre O b. 10.04 ohm-metre O c. 5152.96 ohm-metre Od. 98.88 ohm-metre O e. 51.53 ohm-metre Of. 515295.62 ohm-metre O g. 0.10 ohm-metre h. 0.99 ohm-metre

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 71AP: A nichrome rod that is 3.00 mm long with a cross sectional area of 1.00 mm2 is used for a digital...

See similar textbooks

Similar questions

The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
(a) Of what material is a wire made, if it is 25.0 m long with a diameter of 0.100 mm and has a resistance of 77.7 at 20.0C ? (b) What is its resistance at 150.0C ?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
a) Of what material is a wire made, if it is 25.0 m long with a 0.100 mm diameter and has a resistance of 77.7at 20,0°C ? (b) What is its resistance at 150°C ?
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
A nichrome rod that is 3.00 mm long with a cross sectional area of 1.00 mm2 is used for a digital thermometer, (a)What is the resistance at room temperature? (b)What is the resistance at body temperature?
A car battery with a 12-V emf and an internal resistance of 0.050 is being charged with a current of 60 A. Note that in this process the battery is being charged. (a) What is the potential difference across its terminals? (b) At what rate is thermal energy being dissipated in the battery? (c) At what rate is electric energy being converted to chemical energy? (d) What are the answers to (a) and (b) when the battery is used to supply 60 A to the starter motor?
(a) What is the resistance of a 1.00 102-O, a 2.50-k O, and a 4.00-kresistor connected in series? (b) In parallel?
A flashlight uses batteries that add up to 1.5 V and has a power output of 0.42 W. (a) How much current is drawn from the batteries? A(b) What is the effective resistance of the flashlight? Ω
A flashlight uses batteries that add up to 1.5 V and has a power output of 0.53 W. (a) How much current is drawn from the batteries? A (b) What is the effective resistance of the flashlight? Ω
Answer the following 1. A voltage of 120V generates an IR drop across two resistors connected in series. If the voltage drop across R1 is 30V, what is the voltage drop across R2, in Volts? a) 80 b) 40 c) 100 d) 90 2. Three resistors R1, R2 and R3 of 20, 40 and 60 ohms are connected in parallel through the 120 V power line. What is the total current in the power line? a) 10A b) 12A c) 11A d) 15A 3. Resistors in a circuit are generally used to: a) increase the flow of the current b) decrease the flow of current c) avoid overvoltage d) decrease the power in the circuit
A flashlight uses batteries that add up to 4.5 V and has a power output of 0.35 W. (a) How much current is drawn from the batteries?A(b) What is the effective resistance of the flashlight?Ω