A plastic board with length X and mass Y is leaning against a frictionless wall. The plastic b. made an angle of 65º w/ resp. to the rough floor. The plastic b. is in static eqlbrium hence the board does not slip. Calculate the minimum friction coefficient between the plastic b. and the ground. Please write the solutions clearly and completely. Thank you.

Q: In open heart surgery a much smaller amount of energy will defibrillate the heart. (a) What voltage…

A:

Q: A spring-loaded Nerf gun can shoot a foam bullet 11.0 m straight up into the air when the spring is…

A:

Q: The two mirrors illustrated in the figure below meet at a right angle. The beam of light in the…

A:

Q: Two forces F1 and F2 act on a 5.00kg object. Taking F 1= 20.0N and F 2 =15.0N, find the…

A: We have two forces of magnitude F1=20 N and F2=15 N acting on an object of mass m=5 kg. The…

Q: An object is a distance of 1.44 m from a converging lens, and is 25.0 cm long (see diagram to the…

A: Given:object distance, u = −1.44 mobject height, ho = 25.0 cm = 0.250 mimage height, hi = 15.0 cm =…

Q: Determine the tension at cable AB and force F in the loading system below for equilibrium. *

A: Given: The mass of the object is 500 kg. The system is in equilibrium.

Q: A tennis player serves the ball with an initial speed of 23.6 m/s, from a height of 2.37 m above the…

A:

Q: A battery does 25.7 Joules of work for every 1.73 Coulombs of charge that it encounters during a…

A:

Q: Two pendulums of equal length l = 1.15 m are suspended from the same ceiling and are hanging side by…

A:

Q: Two children on opposite sides of a 13 kg door (I = 1/3 mL2) apply a force to the door. The first…

A: in this question we determine door's angular acceleration.

Q: Describe the magnetic field that exists between the plates of a charging or discharging capacitor…

A: Magnetic field arises between two parallel plates in a parallel plate capacitor during charging and…

Q: 20) What is the magnitude and direction of the force in each of the following situations? a) b) v =…

A:

Q: Water of density 1000 kg/m^3 is flowing through a horizontal pipe as shown below. If the speed v1 is…

A:

Q: 18. A store clerk pulls three carts connected with two horizontal cords to move products from the…

A:

Q: The largest operating wind Lakes generator in the world has a rotor diameter of almost 100m. This…

A:

Q: If you were an observer on Mars looking at the earth through a telescope would you see the earth…

A: To find: If you were an observer on Mars looking at the earth through a telescope would you see…

Q: Which of the following energy transformations occurs when electric current passes through a…

A: Introduction: The current flow in the circuit is due to electrical energy, resistance is a passive…

Q: At some instant the velocity components of an electron moving between two charged parallel plates…

A: As per our guidelines, we will solve only first question for you. To get remaining question solved…

Q: A skier starts from rest on the 40° slope at time t-0 and is clocked at t - 2.96 s as he passes a…

A:

Q: 1- A particle is pushed along a horizontal surface in such a way that it starts with a velocity of…

A: As per guidelines only first question is solved here. Given, initial velocity, u = 12 m/s…

Q: For the given positive charge distribution with uniform volume charge density p., determine the…

A:

Q: large football player student (1.0 x 102  kg) applies a 6.0 x 102  N force to another equally burly…

A: Given  Mass of large football player student , m1 = 1.0×102 kg  Force applied by m1, F1 = 6.0×102 N…

Q: How to calculate escape velocity of Planet?

A:

Q: A plastic board with length X and mass Y is leaning against a frictionless wall. The plastic b. made…

A: The free body diagram is shown below Where the length of board is X and O is its midpoint.

Q: The figure below shows the path of a light beam through several slabs with different indices of…

A: Given : n1= 1.6 n2= 1.4 n3= 1.2 n4= 1.01

Q: A force of 720 newtons stretches a spring 4 meters. A mass of 45 kilograms is attached to the end of…

A: Given: The applied force is 720 N. The displacement in the spring is 4 m. The initial condition.…

Q: What is the repulsive force between two pith balls that are 10.0 cm apart and have equal charges of…

A: Given: distance between the charges, r=10 cm=0.1 m charges, q1=-39 nC =-39*10-9 C…

Q: Calculate the Impulse of a force of 50 N acting for 0.1s.

A: Given data:  Force (F) = 50 N Time (t) = 0.1 s Required: Impulse (I)

Q: electron is accelerated through 2.05 x 103 V from rest and then enters a uniform 2.90-T magnetic…

A:

Q: What is the magnitude (in N/C) and direction of an electric field that exerts a 3.50 ✕ 10−5 N upward…

A: Given data: Force (F) = 3.50×10-5 N, upward  Charge (q) = -1.50 μC = -1.50×10-6 C Required: The…

Q: If the tension on the horizontal string is 35.0N, what is the mass of the hanging object as shown in…

A:

Q: What total capacitances (in uF) can you make by connecting a 5.60 mF and an 8.90 MF capacitor…

A: Given C1 = capacitance 1 = 5.60 mF C2 = capacitance 2 = 8.90 MF We have to calculate it's equivalent…

Q: wo forces act on a 16- kg object. The first force has a magnitude of 68N and is directed 24o north…

A: Given: The mass of the object is 16 kg. The first force on the object is 68 N directed to 24o north…

Q: A positive charge of magnitude Q1 = 0.45 nC is located at the origin. A negative charge Q2 = -6.5 nC…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 36 A 600-nm-thick soap film (n = 1.40) in air is illuminated with white light in a direc- tion…

A:

Q: Problem 2: Determine the speed at which the basketball at A must be thrown at the angle of 30° s…

A: Given:- A ball is thrown with the angle of θ= 30o as shown in the figure Horizontal distance d = 10…

Q: Calculate the voltage if the resistance is 14.03 ohms and the current is 8 A ?

A: Given data :      Resistance   =  R      Current   =   I      Required,             Voltage

Q: A 2.00-kg particle moves from the origin to position, having coordinates x = 4.00 m and y = 4.00 m…

A:

Q: Show all working @ A particular electronic-code lock provides over 500 billion Combinations.…

A: Note: As per the guidelines, we can only answer first question of multiple question. Sorry for the…

Q: A knife thrower throws a knife toward a 300 g target that is sliding in her direction at a speed of…

A: Given Data:- Mass of the target is M=300g =300g×10-3 kg1 g=0.300 kg Initial speed of the target is…

Q: Two cars collide at an icy intersection and stick together afterward. The first car has a mass of…

A:

Q: 3) In the question above, when a light ray enters glass (n = 1.52), what is the speed of light in…

A:

Q: Problem 1. Four point charges are placed at the corners of a 4.00 cm x 4.00 cm square as shown on…

A: Required  magnitude and direction of electric field at point P

Q: A bike is moving at the rate of 30 m/s carrying a momentum of 5000 kgm/s. Determine its mass.

A: Given data,     Momentum  =  p      Velocity  =  v      To find,         Mass

Q: Three charges are located as shown in the figure, with values q1 = 4.3 × 10-16C, q2 = -1.1 × 10-16…

A: The charge,  q1=4.3×10-16C The charge, q2=-1.1×10-16C The charge, q3=6.5×10-16C The distance between…

Q: Find the total capacitance in micro farads of the combination of capacitors shown in the figure…

A: Given data: Two capacitors are connected in parallel C1 = 10 μF and C2 = 2.5 μF Third capacitor C3 =…

Q: 23. An object is moving along a circular path of radius 3ft and has an angular velocity of 6 rad/s.…

A: Given data:  Radius (r) = 3 ft Angular velocity (ω) = 6 rad/s Required: The centripetal acceleration…

Q: and cite at least 10 examples of how it is being used including the pros and cons of its usage.

A:

Q: An aluminum wire having a cross-sectional area equal to 3.00 x 10-6 m² carries a current of 3.00 A.…

A:

Q: A grenade is initially at rest. Suddenly, it explodes into many different pieces. If you were to sum…

A: This problem can be solved by using conservation of momentum of the grande system.

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).