Suppose we include the lead resistance in the calculation of temperature for a class A RTD. If R3 = 1000 ohms, Ra = 18 ohms, V0 = 1.80 volts, and V = 5 volts. Including the tolerances, what is the highest temperature you could measure in °C? (Type in a two-decimal number)

Q: Q.3 For Resistance temperature detectors (RTDS) 1) What's the principle of operation for Resistance…

A: RTD stands for resistance temperature detector  It works on the principle that if we increase the…

Q: Design and show how you would run an experiment in Labaratory to measure the resistance of a piece…

A:

Q: A metallic wire is stretched from original length of 2 m to 4 m. If the original cross-sectional…

A: This question belongs to circuit theory . It is based on the concept of resistance . Problem can be…

Q: Q11. What is LED?

A:

Q: Complete the table of values for this circuit, representing all quantities in complex-number form:…

A:

Q: Give a brief introduction about the topic of generation and measurement of direct current…

A: generation and measurement of direct current voltage

Q: Example: If PMMC meter have internal resistance of 102 and full scale range of 1mA. Assume we wish…

A:

Q: In digital communication it is said that Analog information sources can be transformed into digital…

A: Given :   In the above question they want to know by which process we can convert the analog…

Q: Ohm's Law calculates what values? Please

A:

Q: In Figure 1, If the two NMOS have the same parameters and the resistors are the same, what current…

A:

Q: A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional…

A: To determine the new resistance value of the metallic wire

Q: 2. Does ?a three digit color coding of resistor values? limit producible resistor value ranges? Why?…

A: In the three-digit color coding of the resistor, the first two color bands indicate the two-digit…

Q: Power Electronics.   Write necessity of power supply and briefly describe different types of SMPS…

A: Power supply: It is an electronic device  that supplies electric energy to an electric loads the…

Q: Q.3 For Resistance temperature detectors (RTDS) I) What's the principle of operation for Resistance…

A:

Q: An electrical circuit has components as figure bellow, VA = 6 Volt and V 2 Volt. R2 = 10 2 ww VA Ic…

A:

Q: Q) TTR 300 , What is the basic working principle of the device ?

A: The TTR300 is a series of devices which includes three-phase transformer turns ratio test sets…

Q: When is it necessary to include internal resistances to circuit calculations

A: In this question, When is it necessary to include internal resistances to circuit calculations?

Q: Did you observe a difference in the values of operate and release voltages in the case of DC supply?…

A: The operating voltage is the voltage at which appliances are operating, and the release voltage is…

Q: What is the (Methods) to calculate the value of resistance?? and how we can using the multimeter…

A:

Q: B F E D

A: Given

Q: 6. BJT is more linear than FET. Why? Explain 7. what is vas (off)? How could it effects the…

A: In this question we will write how BJT is more linear than FET... Note :- as per our guideline , I…

Q: What is the Vref for Iref = 250 microamps in the circuit in the figure? What is R1?

A:

Q: A simple circuit with one or more chips for Digital Integrated Circuits subject, with a written…

A: Integrated circuits: An Integrated Circuit (IC) is an electronic device that assembles (or…

Q: 1- If we use 5000 μF, we can get a very low ripple voltage. But this is so bad and this a…

A: Ripple voltage is the amount of AC voltage appearing on a DC voltage. for the ripple voltage the…

Q: The following circuit operates if and only if there is a path of functional devices from left to…

A:

Q: Please answer the question by showing step by step and explaining each step with details, please?…

A:

Q: A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional…

A:

Q: Discuss how the circuit in flashlights, calculators, remote controls, and cellphones works.

A: (1) Flashlight consists of a Switch, batteries, lamp, reflector. When switching the flashlight on,…

Q: Give brief answer only. Define DPST along with it's symbol and uses.

A: DPST switch: Definition with symbol? Uses?

Q: Sketch the following particulars for the device which is used in high voltage and high current…

A: Part a: Device used in high voltage and high current operation is IGBT Symbol of IGBT,

Q: Table 3: Record the resistances, including uncertainty. You can report the uncertainty in the usual…

A: Resistance: It is the value by which a object opposes the electric force or current. The higher the…

Q: 1. Refer to the graphics appendix. What resistance is most near the total resistance of the circuit?

A: This question belongs to circuit theory . It is based on the concept of calculation of total…

Q: Are the following statements correct or wrong? Justify your answer. (a) GTO requires very high…

A: Are the following statements correct or wrong? Justify your answer. (a) GTO requires very high…

Q: A metallic wire is stretched from original length of 1 m to 5 m. If the original cross-sectional…

A:

Q: 3. Suppose the d'Arsonval volt-meter shown is used to measure the voltage across the 45 0 resistor…

A: Dear student you asked 3 question at a time.we have limited time to solve your question.we will…

Q: , explain the FET types , working principles, structure and applications.

A: There are three terminals present in FET such as drain, source, and gate. FET stands for the…

Q: measurements , describe how to read the values given on the measurement tools and to write about…

A: Extension rod- extension rod is used for extensive objects having large diameters, it is used along…

Q: Why is the computed standard error less than the tolerance of the resistors which is 5%. Explain…

A: According to the question, we need to explain why is the computed standard error less than the…

Q: (b) Determine the range of K for which the system shown in figure Q2b is stable. R(s) E(s) C(s) s? +…

A: Given that

Q: Where do we exactly need to use a clipper circuit? State at least 3 examples and why it's needed on…

A: According to the question, we need to discuss the application of the clipper circuit.

Q: Questions 1. Does Ohm's Law appear to hold in this exercise? 2. Is there a linear relationship…

A:

Q: Questions Ohm's Law experiment 1- What is the aim from Ohm's Law experiment ? 2- What is the used…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: *Explain the process here; how to determine the resistor value using the color coders and nominal…

A: Color code of the resistor: Gold and silver color denoted the 5% and 10% tolerance respectively.

Q: Indicate which of the following statements refer to LCD displays and which refer to LED displays:…

A: (a) Emit light- LED display (b) Reflect ambient light- LCD display (c) Are best for low power…

Q: Using Microsoft Excel, plot a graph of Resistance vs. Area, then find the What is the shape of this…

A: Here, the given values of Area (A), Resistance (R), and 1/A are

Q: 3) Calculate the reşistance od a (100m) wire having a cess-sectional area A Od mm) and resistivity…

A: To find the resistance of a wire  And new resistance when it's length is increased to three times

Q: (a) Explain how the electrical power is obtained and how it is converted into other types of energy…

A: Electric car/vehicle  is run on electric supply .

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.