A PPMC instrument with a 900 n coil resistance and an FSD of 75 !LA is to be used with a half-wave rectifier circuit as an ac voltmeter. Silicon diodes are used, and the minimum diode forward current is to be 80 /-LA when the instrument indicates 0.25 FSD. Calculate the shunt and multiplier resistance values required to give 200 V FSD.

In a center-tapped full wave rectifier circuit utilizing ideal diodes, if the primary voltage is 160Vpeak, the turns ratio is 8:1 and the load resistance is 860 ohms, what is the rectified dc voltage at the output? express answer in volts

Consider the half-wave rectifier shown in the figure below. Let vs be a sinusoidal with 10V peak amplitude with frequency of 60Hz and let R = 1000 ohms. Use the contant voltage-drop diode model with VD = 0.7 V.

Draw the following rectifier circuits with an input voltage of 12 Vrms and an RL=2K. Determine the output voltage and the current in RL. Plot these waveforms indicating the peak values and the time as per calculation. Also solve for the output DC value. Use silicon diode/s in your analysis. Half wave rectifier circuit (include the diode voltage analysis), Full wave bridge rectifier circuit, Full wave rectifier using center tapped transformer

What is the approximate rms value of secondary voltage to get a peak load voltage of 40 V out of a bridge rectifier? Ignore diode drop.

Can someone please provide a step by step solution? Thank you! The full wave rectifier in the circuit below is to deliver 0.25A and 15V (peak) to a load. The ripple is to be no larger than 0.4 V peak-to-peak. The input signal is 120 V (rms) at 60 Hz. Assume V(lambda) = 0.7 V . Determine the required turns ratio, the filter capacitance, and the diode PIV rating.

A single-phase full-wave bridge rectifier circuit is fed from a 220 V, 50 Hz supply. It consists of four diodes, a load resistance 20 Q and a very large inductance so that the load current is constant. What is the average or dc output voltage?

A bridge rectifier circuit has secondary voltage of 12 V Assume secondary resistance and diode forward resistance to be negligible. Load resistance is 100(ohm.) Calculate peak load current, DC load current, rms current and across each diode.

A sinusoidal signal with a maximum value of 12V is applied to the input of the bridge type rectifier circuit. Since silicon diodes with a threshold voltage of 0.7V are used in the circuit, what is the maximum voltage of the signal at the output of the rectifier?

Q.3 Consider the half-wave rectifier eircuit shown in Figure B3. Assuming practical diode model with turn on voltage of 0.7 V. Si 4V 7:1 + 120 Vrms 60HZ V. pri Ves RL V. Figure B3 a) Determine the Vipp) voltage for Vee- b) Draw and label completely the output voltage wavefom. State the peak value and the frequency of the wavefom.