A pressurised vessel contains water with some air above it, as shown in figure 9 below. A multi-fluid manometer system is used to determine the pressure at the air- water interface. Determine the absolute pressure at point F if atmospheric pressure is 100 kPa.(where h1= 24 cm, h2 = 35 cm and h3 52 cm) %3D Oil Air Water Mercury h, Figure 9

A pressurised vessel contains water with some air above it, as shown in figure 9 below. A multi-fluid manometer system is used to determine the pressure at the air- water interface. Determine the absolute pressure at point F if atmospheric pressure is 100 kPa.(where h1= 24 cm, h2 = 35 cm and h3 52 cm) %3D Oil Air Water Mercury h, Figure 9

Name: A pressurised vessel contains water with some air above it, as shown
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A pressurised vessel contains water with some air above it, as shown in figure 9below. A multi-fluid manometer system is used to determine the pressure at the air-water interface. Determine the absolute pressure at point F if atmospheric pressureis

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

A water pipe is connected to a double-U manometer at a location where the local atmospheric pressure is 14.5 psia. Determine the absolute pressure at the center of the pipe.
Determine the absolute pressure in pa at a depyh of 6 m belowthe free surface when a barometer reads 760 mm mercury (sp.gr = 13.57).
A water pipe is connected to a double-U manometer as shown in Figure below at a location where the local atmospheric pressure is 97.9 KPa. Determine the absolute pressure at the center of the pipe.
Determine the pressure (in kPa) at the bottom of an open tank if it contains layers of 3 m of oil (SG=0.79) and 10 cm of mercury (13.6)
Determine the pressure at the interface of liquids of an open tank containing 3 m of oil (SG=0.79) and 10 cm of mercury (13.6)
A water pipe is connected to a double-U manometer as shown in figure below at a location where the local atmospheric pressure is 12.6 psia. Determine the absolute pressure at the center of the pipe.
determine the pressure exerted on the surface of a submarine sailing 225ft below sea level, assuming that the Barometric pressure is 14.7 psia and the specific gravity is 1.03.
The two water tanks are connected to each other by a curved mercury manometer as shown in the figure. Calculate a and 0 values since the pressure difference between the two tanks is 32 kPa. (SG(hg)=13.6, ρ(water)=1000 kg/m^3)
the gauge pressure of the air in the tank is shown in Fig. p3-49 is measured to be 65 kPa. Determine the differential height H of the mercury column.
A cubic tank with a full capacity of 100 m^3 is filled halfway with oil (SG = 0.7). Determine the absolute pressure exerted on the bottom of the tank.
A U-tube mercury manometer has been employed to measure the pressure of gas following through a pipe line. One limb of the manometer communicates with the gas pressure and the other limb is open to atmosphere. If the difference in level of mercury in the two limb is 40 cm, determine the gas pressure.
Is the hydrostatic pressure the same along any constant horizontal line?