A purple solution is prepared by mixing 5.00 mL of the blue dye solution with 6.25 mL of red dye solution. The calibration curve for each color is provided. Measurement Result Measurement Blue dye stock solution (M) Result 0.1944 M Red dye stock solution (M) 0.2015 M Absorbance at 630 nm 0.00697 0.00193 Absorbance at 500 nm Calibration curve Calibration curve y=0.0682x y=0.0170x Part: 0/4 Part 1 of 4 Determine the theoretical molar concentration of each dye in the mixture. Round your answer to 3 significant digits. [Blue theoretical M [Red theoretical M X Part: 1/4 Part 2 of 4 Using the absorbance and calibration curve for each dye, calculate the experimental molar concentration of each dye in the mixture. Round your answer to 3 significant digits. [Blue] M E Submit Terms of Use | Privacy Center

A purple solution is prepared by mixing 5.00 mL of the blue dye solution with 6.25 mL of red dye solution. The calibration curve for each color is provided. Measurement Result Measurement Blue dye stock solution (M) Result 0.1944 M Red dye stock solution (M) 0.2015 M Absorbance at 630 nm 0.00697 0.00193 Absorbance at 500 nm Calibration curve Calibration curve y=0.0682x y=0.0170x Part: 0/4 Part 1 of 4 Determine the theoretical molar concentration of each dye in the mixture. Round your answer to 3 significant digits. [Blue theoretical M [Red theoretical M X Part: 1/4 Part 2 of 4 Using the absorbance and calibration curve for each dye, calculate the experimental molar concentration of each dye in the mixture. Round your answer to 3 significant digits. [Blue] M E Submit Terms of Use | Privacy Center

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter16: Data Processing With Excel

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

The original solution was diluted by a factor of three, and then the absorbance of the diluted cereal sample solution was measured and recorded as (2.0x10^-1). Use the following trendline and dilution factor to determine the concentration of iron, in unit of M, in the original cereal sample solution. The trendline (linear regression) as displayed on the plot is y = 11898x - 0.0112.
a- Separation is essential in chemical analysis especially when we are dealing with complexmixture of chemical species. Name 1 separation technique based on basis of operation asbelow. Basis of operation Techniquei) Sizeii) Mass and densityiii) Change in physical state
FT-IR technique can be utilized for the analysis of unknown analytes by matching it with__________. Both choices are correct Commercial library/database Reference standard
Table 1. Data for the Concentration of the KMnO4 Unknown Solution. Abs of Unknown Solution is 0.362 Absorbance Concentration Trial 1 0.120 0.00145 Trial 2 0.066 0.00104 Unknown Solution: __________ What is the Concentration of the Unknown Solution. _____________ Show statistical treatment of data.
An HPLC method was developed for the separation and determination of ibuprofen in blood samples. A 3.00 mL blood sample dissolved in 70.00 mL solvent was prepared and 10.0 mL was injected into the HPLC. Standard ibuprofen solutions were also run.Calculate the ibuprofen present in the 3.00 mL blood sample The following data were obtained. Table po itoo: Ibuprofen concentration, mg/ml0.50 1.0 2.0 3.0 Blood sample Peak area (Right column)5.29.617.419.911.4
A student prepared a cereal sample solution using a procedure similar to that in Lab 5. The original sample solution was diluted by a factor of two, and then the absorbance of the diluted sample solution was measured and recorded as (2.0x10^-1). Use the following calibration plot and the dilution factor to determine the concentration of iron, in unit of M, in the original cereal sample solution. The trendline (linear regression) as displayed on the plot is y = 11898x - 0.0112.
hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?
the following data were the results from six replicate determinations of iron in aqueous samples of a standard solution containing 20ppm iron (III) 19.8, 19.6, 19.5 ,19.4, 20.1, 20.3 DETERMINE THE MEDIAN FOR THE DATA
Xanthurenic acid stock solution Absorbance 25 0.052 50 0.128 75 0.202 100 0.310 150 0.448 200 0.621 Plot a graph, from graph, y=mx (force the trend line to pass through origin since the blank with no xanthurenic acid was set to be zero absorbance) in which, y: Absorbance, x concentration
A 10-ml transfer pipet and a 200-ml volumetric flask (TC) are used to make 0.100 M and 0.0050 M solutions from a stock solution of 2.000(plus or minus) 0.005 M. Calculate the percent relative error for the three solutions if perfect technique is used. (See Garland Experiments in Physical Chemistry, 10th ed. p. 639-642) Report the two new molaritites
No need guideline answer if u provide guideline answer I will dislike ok Module Code & Title: CHM9011M Chromatography and Sep Sciences Description of Assessment Task and Purpose: To prepare an SOP for the GC-MS Instrument
Use the following information collected from a SIZE-EXCLUSION CHROMATOGRAPHY experiment to answer the questions below. MW Standards Molecular Weight (kDa) Elution Volume (mL) blue dextran 1000 85 myoglobin 17.2 200 TIM 53.3 178 hemoglobin 62.2 156 IgG 140 122 ATCase 307.9 94 Prepare a graph showing the linear relationship between log function of molecular weight against Ve/Vo. The R2value must be 0.9 or higher. What is the linear equation from the standards given? What is the R2value?