A rectangular aluminum bus bar is 0.9m long, 0.15 m wide, 0.013m (1.3cm)thick. If the current in the bus bar flows along its length, and theconductivity (o) of aluminum is 3.57x10^8 S/m. Calculate the bus barresistance in un. *

Answered: Image /qna-images/answer/f99d64fe-359c-4793-8c6e-00d56699c9f1.jpg

Answered: A rectangular aluminum bus bar is 0.9m…

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 86CP: Consider a square rod of material with sides of length L = 3.00 cm with a current density of...

See similar textbooks

Similar questions

Consider a square rod of material with sides of length L = 3.00 cm with a current density of J=J0eaxk=(0.35Am2)e(2.1103m1)xk as shown below. Find the current that passes through the face of the rod.
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
The figure shows a 2.0-cm diameter roller that turns at 90 rpm. A 4.0-cm wide plastic film is being wrapped onto the roller, and this plastic carries an excess electric charge having a uniform surface charge density of 4.8 mC/cm2. What is the current of the moving film in mA to 1 decimal places?
The following figure shows a 4.0-cm-wide plastic film being wrapped onto a 2.0-cm-diameter roller that turns at 98 rpm . The plastic has a uniform surface charge density of -2.1 nC/cm2 . (Figure 1) Part A: What is the current of the moving film? Part B: How long does it take the roller to accumulate a charge of -10 μC?
In the figure below a bar of length L, width w, and thickness d is positioned a distance h underneatha long straight wire that carries a large but unknown steady current Iwire (w is small compared to h,and h is small compared to the length of the long straight wire). The material that the bar is madeof is known to have n positive mobile charge carriers (“holes”) per cubic meter, each of charge e, andthese are the only mobile charge carriers in the bar. An ammeter measures the small current I passingthrough the bar. (a) Draw connecting wires from the voltmeter to the bar, showing clearly how the ends of the con-necting wires must be positioned on the bar in order to permit determining the amount of current in the long straight wire Iwire. If the voltmeter reading ∆V is positive, does the current in thelong straight wire run to the left or to the right? Explain briefly. [2](b) If the voltmeter reading is ∆V , what is the current in the long straight wire, Iwire? Express your 4 answer for…
explain how current flows in p-type semi-conductor
using attached figure.....How many coulombs of charge pass through a cross section of the conductor in the interval from t = 0 to t = 9.0 s? CWhat constant current would transport the same total charge during the 9.0-s interval as does the actual current? A
I. What would be the direction of conventional current if the coil of wire is connected in a battery?II. What would be the direction of electron flow? Answer choices (for the 2 questions):A. upward direction B. downward direction C. both upward and downward direction D. no current flow
At room temperature, What is the strength of the electric field in a 12-gauge copper wire with a diameter of 2.05mm that is needed to cause a 2.75A current to flow? What field would be needed if the wire were made of silver instead?
A 320-km-long high-voltage transmission line 2.0 cm in diameter carries a steady current of 1,090 A. If the conductor is copper with a free charge density of 8.5 1028electrons per cubic meter, how many years does it take one electron to travel the full length of the cable? (Use 3.156 107 for the number of seconds in a year.)
A capacitor with square plates, each with an area of 34.0 cm2 and plate separation d = 2.64 mm, is being charged by a 215-mA current. (a) What is the change in the electric flux between the plates as a function of time? (Use the following as necessary: t. Do not use other variables, substitute numeric values. Assume that dΦE/dt is in V · m/s and t is in seconds. Do not include units in your answer. Enter the magnitude.) dΦE dt = (b) What is the magnitude of the displacement current between the capacitor's plates?
how does current flows in p type and n type semi-conductors?

SEE MORE QUESTIONS

Recommended textbooks for you

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A rectangular aluminum bus bar is 0.9m long, 0.15 m wide, 0.013m (1.3cm) thick. If the current in the bus bar flows along its length, and the conductivity (o) of aluminum is 3.57x10^8 S/m. Calculate the bus bar resistance in un. *