A rectangular block with mass m₁ = 440 kg and length L = 2.00 m, is placed on a pivot point at a distance x = 0.33 L from its edge. The block is connected by a lightweight wire to an object with mass m₂ via a pulley, as shown in the figure. What is the mass m₂ knowing that the system is in equilibrium?

A rectangular block with mass m₁ = 440 kg and length L = 2.00 m, is placed on a pivot point at a distance x = 0.33 L from its edge. The block is connected by a lightweight wire to an object with mass m₂ via a pulley, as shown in the figure. What is the mass m₂ knowing that the system is in equilibrium?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter10: Rotational Motion

Section: Chapter Questions

Problem 78P: Review. A string is wound around a uniform disk of radius R and mass M. The disk is released from...

See similar textbooks

Similar questions

A nylon siring has mass 5.50 g and length L = 86.0 cm. The lower end is tied to the floor, and the upper end is tied to a small set of wheels through a slot in a track on which the wheels move (Fig. P18.76). The wheels have a mass that is negligible compared with that of the siring, and they roll without friction on the track so that the upper end of the string is essentially free. Figure P18.76 At equilibrium, the string is vertical and motionless. When it is carrying a small-amplilude wave, you may assume the string is always under uniform tension 1.30 N. (a) Find the speed of transverse waves on the siring, (b) The string's vibration possibilities are a set of standing-wave states, each with a node at the fixed bottom end and an antinode at the free top end. Find the node-antinode distances for each of the three simplest states, (c) Find the frequency of each of these states.
A horizontal, rigid bar of negligible weight is fixed against a vertical wall at one end and supported by a vertical string at the other end. The bar has a length of 50.0 cm and is used to support a hanging block of weight 400.0 N from a point 30.0 cm from the wall as shown in Figure P14.81. The string is made from a material with a tensile strength of 1.2 108 N/m2. Determine the largest diameter of the string for which it would still break. FIGURE P14.81
A uniform wire (Y = 2.0 1011 N/m2) is subjected to a longitudinal tensile stress of 4.0 107 N/m2. What is the fractional change in the length of the wire?
When a circus performer performing on the rings executes the iron cross, he maintains the position at rest shown in Figure P12.37a. In this maneuver, the gymnasts feet (not shown) are off the floor. The primary muscles involved in supporting this position are the latissimus dorsi (lats) and the pectoralis major (pecs). One of the rings exerts an upward force Fk on a hand as show n in Figure P12.37b. The force Fs, is exerted by the shoulder joint on the arm. The latissimus dorsi and pectoralis major muscles exert a total force Fm on the arm. (a) Using the information in the figure, find the magnitude of the force Fm for an athlete of weight 750 N. (b) Suppose a performer in training cannot perform the iron cross but can hold a position similar to the figure in which the arms make a 45 angle with the horizontal rather than being horizontal. Why is this position easier for the performer? Figure P12.37
When a person stands on tiptoe on one foot (a strenuous position), the position of the foot is as shown in Figure P12.32a. The total gravitational force Fg on the body is supported by the normal force n exerted by the floor on the toes of one foot. A mechanical model of the situation is shown in Figure P12.32b, where T is the force exerted on the foot by the Achilles tendon and R is the force exerted on the foot by the tibia. Find the values of T, R, and when Fg = 700 N. Figure P12.32
Review. A string is wound around a uniform disk of radius R and mass M. The disk is released from rest with the string vertical and its top end tied to a fixed bar (Fig. P10.78). Show that (a) the tension in the string is one third of the weight of the disk, (b) the magnitude of the acceleration of the center of mass is 2g/3, and (c) the speed of the center of mass is (4gh/3)1/2 after the disk has descended through distance h. (d) Verify your answer to part (c) using the energy approach. Figure P10.78
Why is the following situation impossible? A uniform beam of mass mk = 3.00 kg and length = 1.00 m supports blocks with masses m1 = 5.00 kg and m2 = 15.0 kg at two positions as shown in Figure P12.2. The beam rests on two triangular blocks, with point P a distance d = 0.300 m to the right of the center of gravity of the beam. The position of the object of mass m2 is adjusted along the length of the beam until the normal force on the beam at O is zero. Figure P12.2
A bridge of length 50.0 m and mass 8.00 104 kg is supported on a smooth pier at each end as shown in Figure P12.25. A truck of mass 3.00 104 kg is located 15.0 m from one end. What are the forces on the bridge at the points of support? Figure P12.25
A child works on a project in art class and uses an outline of her hand on a sheet of construction paper to draw a turkey (Fig. P16.36). The teacher pins the turkey to the bulletin board in the front of the classroom by using a thumbtack. The student notices that if she flicks her finger on the end of the turkey, it oscillates back and forth with a frequency of about 1.65 Hz. If the rotational inertia of the paper turkey is 1.25 105 kgm2 and its mass is 0.005 kg, what is the distance between the thumbtack and the center of mass of the turkey? FIGURE P16.36
Review. One end of a light spring with force constant k = 100 N/m is attached to a vertical wall. A light string is tied to the other end of the horizontal spring. As shown in Figure P12.57, the string changes from horizontal to vertical as it passes over a pulley of mass M in the shape of a solid disk of radius R = 2.00 cm. The pulley is free to turn on a fixed, smooth axle. The vertical section of the string supports an object of mass m = 200 g. The string does not slip at its contact with the pulley. The object is pulled downward a small distance and released. (a) What is the angular frequency of oscillation of the object in terms of the mass M? (b) What is the highest possible value of the angular frequency of oscillation of the object? (c) What is the highest possible value of the angular frequency of oscillation of the object if the pulley radius is doubled to R = 4.00 cm? Figure P12.57
Consider a nanotube with a Youngs modulus of 2.130 1012 N/m2 that experiences a tensile stress of 5.3 1010 N/m2. Steel has a Youngs modulus of about 2.000 1011 Pa. How much stress would cause a piece of steel to experience the same strain as the nanotube?
A rigid vertical rod of mass 75 kg and length 4.0 m is connected to the floor by a bolt through its lower end A. The rod also has a wire connected between its top end B and the floor as shown in the figure. A horizontal force F = 500 N is applied at the midpoint of the rod. What is the tension in the wire?