*Chapter 30, Problem 075Z Your answer is partially correct. Try again.A rectangular loop of N closely packed turns is positioned near a long stralght wire as shown in the figure. What is themutual inductance M for the loop-wire combination if N = 107, a = 2.4 cm, b = 11 cm, and / = 64.0 cm?N turnsNumber T2.36Units PH

Given Data : The number of turns of the rectangular wire is given as N = 107 The distance of the…

A rectangular loop of N closely packed turns is positioned near a long straight wire as shown in the figure. What is the mutual inductance M for the loop-wire combination if N = 107, a = 2.4 cm, b = 11 cm, and / = 64.0 cm? a N turns

A rectangular loop of N closely packed turns is positioned near a long straight wire as shown in the figure. What is the mutual inductance M for the loop-wire combination if N = 107, a = 2.4 cm, b = 11 cm, and / = 64.0 cm? a N turns

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 42AP

See similar textbooks

Similar questions

A 100-mH inductor is connected across the emf of the preceding problem. (a) What is the reactance of the Inductor? (b) Write an expression for the current through the inductor.
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
Two rectangular loops of wire lie in the same plane as shown in Figure OQ31.11. If the current I in the outer loop is counterclockwise and increases with time, what is true of the current induced in the inner loop? More than one statement may be correct, (a) It is zero, (b) It is clockwise, (c) It is counterclockwise, (d) Its magnitude depends on the dimensions of the loops, (e) Its direction depends on the dimensions of the loops.
A large research solenoid has a self-inductance of 25.0 H. (a) What induced emf opposes shutting it off when 100 A of current through it is switched off in 80.0 ms? (b) How much energy is stored in the inductor at full current? (c) At what rate in waits must energy be dissipated to switch the current off in 80.0 ms? (d) In View of the answer to the last part, is it surprising that shutting it down this quickly is difficult?
In Figure P30.26, a semicircular conductor of radius R = 0.250 m is rotated about the axis AC at a constant rate of 120 rev/min. A uniform magnetic field of magnitude 1.30 T fills the entire region below the axis and is directed out of the page. (a) Calculate the maximum value of the emf induced between the ends of the conductor. (b) What is the value of the average induced emf for each complete rotation? (c) What If? How would your answers to parts (a) and (b) change if the magnetic field were allowed to extend a distance R above the axis of rotation? Sketch the emf versus time (d) when the field is as drawn in Figure P30.26 and (e) when the field is extended as described in part (c). Figure P30.26
When a wire carries an AC current with a known frequency, you can use a Rogowski coil to determine the amplitude Imax of the current without disconnecting the wire to shunt the current through a meter. The Rogowski coil, shown in Figure P30.8, simply clips around the wire. It consists of a toroidal conductor wrapped around a circular return cord. Let n represent the number of turns in the toroid per unit distance along it. Let A represent the cross-sectional area of the toroid. Let I(t) = Imax sin t represent the current to be measured. (a) Show that the amplitude of the emf induced in the Rogowski coil is Emax=0nAImax. (b) Explain why the wire carrying the unknown current need not be at the center of the Rogowski coil and why the coil will not respond to nearby currents that it does not enclose. Figure P30.8
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
A coil of 40 turns is wrapped around a long solenoid of cross-sectional area 7.5 × 10-3 m2. The solenoid is 0.50 m long and has 500 turns. (a) What is the mutual inductance of this system? (b) The outer coil is replaced by a coil of 40 turns whose radius is three times that of the solenoid. What is the mutual inductance of this configuration?
The lowest frequency in the FM radio band is 88.0 MHz. (a) What inductance is needed to produce this resonant frequency if it is connected to a 2.50 pF capacitor? (b) The capacitor is variable, to allow the resonant frequency to be adjusted to as high as 108 MHz. What must the capacitance be at this frequency?
The open switch in Figure CQ32.7 is thrown closed at t = 0. Before the switch is closed, the capacitor is uncharged and all currents are zero. Determine the currents in L, C. and R, the emf across L, and the potential differences across C and R (a) at the instant after the switch is closed and (b) long after it is closed.
An air-filled cylindrical inductor has 2100 turns, and it is 2.7 cm in diameter and 27.4 cm long. Part A) What is its inductance? Express your answer to two significant figures and include the appropriate units. Part B) How many turns would you need to generate the same inductance if the core were filled with iron of magnetic permeability 1200 times that of free space? Express your answer using two significant figures.
P6 Please solve this problem very clearly and briefly with step by step explanation. A 760 pF capacitor is charged to 135 V and then quickly connected to a 175 mH inductor. Determine (a) the frequency of oscillation, (b) the peak value of the current, and (c) the maximum energy stored in the magnetic field of the inductor