Answered: Att = 0, the switch K is quickly…

Att = 0, the switch K is quickly closed. Calculate the voltage on the inductor at t = 0+. Note that ɛ = 12 V, R1 =10 N, R2 =20 Q, C =1.2 F, and L=3.0 H. %3D

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 42P: The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the...

See similar textbooks

Related questions

Q: Question 2: Calculate the values of X, and Xc for the following values and Inductor and Capacitor if…

Q: An inductor has an inductance of 0.21 mH. Calculate the number of turns per unit length of this…

Q: 1. For a long solenoid, we discovered in a problem-of-the-day that B = µ,nl, where n is the number…

A: (a)Consider l be the length of the solenoid.The expression for n in term of N, total number of terms…

Q: What percentage of the final current I0 flows through an inductor L in series with a resistor R,

Q: A 14.8-mH inductor carries a current i = Imax sin wt, with Imax = 5.20 A and f = w/2n = 60.0 Hz.…

A: Given: Inductance L = 14.8mH Imax= 5.20 A f=ω2π=60.0Hz or ω=120π Step1:…

Q: 6. a. Calculate the inductance of a solenoid containing 300 turns if the length of the solenoid is…

A: Given data- turns n=300, length l=25 cm=0.25 m, cross sectional area A=4×10-4 m2 Inductance of a…

Q: 1. A long solenoid with length 1 and cross-sectional area A is closely wound with N1 turns of wire.…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A single-loop circuit consists of a 7.20 ohm resistor, a 12.0 H inductor, and a 3.20 mF capacitor.…

A: Write the expression for the charge on the capacitor in RLC circuit after time t.

Q: A long solenoid has n=900 turns per meter and a current ? = 3.2 sin(??). Inside the solenoid with a=…

A: n= 900 turn , a= 0.5 m Nc= 100 turns, b= 0.2 m I= 3.2 sin wt

Q: A long solenoid with length I and cross- sectional area A is closely wound with N1 turns of wire. A…

A: Given: a long solenoid with length L and cross sectional area a is closely bound with anyone turns…

Q: The angular frequency of the oscillations in an LC circuit is 2.0×103 rad/s. (a) If L=0.10H, what is…

A: (a)Given,L=0.1HThe angular frequency of oscillation in the LC Circuit is given by

Q: Consider a long cylindrical solenoid of length 0.4 m radius 1x10-2 m , and 1800 turns, with an empty…

A: Given: The length of the solenoid L = 0.4 m The radius of the solenoid r = 1×10-2 m Number of turns…

Q: 8. The inductor shown in the Figure 8 has inductance 0.260 H and carries a current in the direction…

A: The given Inductance of the Inductor is L = 0.26H and L = magnetic flux per unit current Now if the…

Q: Problem 10: A 75 turn, 10.5 cm diameter coil of an AC generator rotates at an angular velocity of…

A: Given that N= 75 d= 10.5 cm B= 1.4 T w= 6.5 rad/s t= 0 initially

Q: (I) How many turns of wire would be required to make a130-mH inductor out of a 30.0-cm-long…

A: Self inductance, L = 130 mH = 0.13 H length, l = 30 cm = 0.3 m diameter, d = 5.8 cm

Q: An inductor in the form of a solenoid contains 410 turns and is 15.0 cm in length. A uniform rate of…

Q: (1)The current in a 20.0-mH inductor changes with time as i = 3.0t° – 6.0t , where i is in amperes…

Q: A long straight wire and a small rectangular wire loop lie in the same plane, as in the figure.…

Q: In Figure 5, R1 = 10 N, R2 = 12 N, L1 = 0.4 H, L2 = 0.1 H, and the ideal battery has e = 10 V. (i)…

Q: Consider two concentric solenoids of the same length. The inner solenoid has radius a and number of…

Q: An inductor is built using a circular coil that is 0.50 m long, has a 10.0 cm radius, and consists…

A: (a)The self-inductance of the coil,

Q: An alternating emf source with a variable frequency fd is connected in series with an 80.0 …

A: VR lags behind VL by a phase angle

Q: 6. Consider a solenoid with length l, cross sectional area A, and N windings. (a) What is the…

A: Resistance= 5 ohms N= 2000 turn r= 5mm L= 4 cm

Q: What capacitance (in pF) do you need to produce a resonant frequency of 2.00 GHz, when using a 5.00…

Q: Suppose a 57.5 cm long, 11.5 cm diameter solenoid has 1000 loops. Part (a) Calculate the…

A: Answer:- Given The length of the solenoid(xo) = 57.5 cm = 0.575 m The diameter of the…

Q: 2. Arrange the following solenoids according to increasing inductance. Here N is the number of…

A: 2) Let the number of turns = N Let the area = A Let the length = L

Q: A 15.00 µF capacitor, labeled as C below, is charged to 175.0 µC at time t = 0. At t = 0, the…

Q: An air-filled cylindrical inductor has 2100 turns, and it is 2.7 cm in diameter and 27.4 cm long.…

A: Number of turns in the inductor, N=2100 Diameter of the coil, d=2.7 cm Length of the inductor,…

Q: An RL circuit with a 5-2 resistor and a 0.05-H inductor carries a current of 1 A at t= 0, at which…

A: we have following data as given in question Resistance of resistor R = 5 Ω Inductance of inductor L…

Q: A 497-turn solenoid has a radius of 9.00 mm and an overall length of 13.2 cm. (a) What is its…

Q: 6. a. Draw an RLC circuit with a 0.3 n resistor, 0.1 H inductor, and 5 F capacitor connected in…

A: (a)

Q: 6. A solenoid(inductor) is 30.0 cm long and has 100 turns of wire and a cross-sectional area of 1.00…

A: Given, Length of solenoid l = 30 cm = 30 x 10-2 m Number of turns in a solenoid N = 100 Area A = 1 x…

Q: The switch S in the circuit has just been closed. Right after (at t 0) the current shown is measured…

Q: In the circuit shown in the figure (Figure 1), E = 61.0 V, R = 35.0 . R2 = 24.0 N, and L = 0.295 H.…

A: Given that, value of the resistance R1 and R2 and inductor and voltage in the given circuit. Then We…

Q: 5. The solenoid in the circuit is made of tightly wound 1200 turns of wire on a 50.0 cm long…

A: Given : Number of turns equal to 1200

Q: An RLC circuit has L = 250 mH, C = 0.200µF, and R = 2.00 kn. What is the angular frequency of its…

Q: A coil of 40 turns is wrapped around a long solenoid of cross-sectional area 7.5 × 10−3 m2. The…

A: The relation between magnetic flux (Φ21) and mutual inductance (M) is given by- M=N2Φ21I1Here,N2 is…

Q: R1 In the circuit shown in the figure the emf of the battery & = 24 V. All the inductors %3D R. are…

A: Given : Emf of battery, E = 24 VRo = 2 Ω R1 = 1 Ω R2 = 4 ΩR3 = 5 ΩR4 = 3 ΩR5 = 2 Ω

Q: *Chapter 30, Problem 075 A rectangular loop of N closely packed turns is positioned near a long…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Att = 0, the switch K is quickly closed. Calculate the voltage on the
inductor at t = 0+. Note that ɛ = 12 V, R1 =10N, R2 =20 Q, C =1.2 F,
and L=3.0 H.
E
k
R1
L
000
R2
+

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 600-turn solenoid is 0.55 m long and 4.2 cm in diameter. Inside the solenoid, a small (1.1 cm × 1.4 cm), single-turn rectangular coil is fixed in place with its face perpendicular to the long axis of the solenoid. What is the mutual inductance of this system?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
Show that Equation 32.28 in the text Ls Kirchhoffs loop rule as applied to the circuit in Figure P32.56 with the switch thrown to position b.
The self-inductance of a coil is zero if there is no current passing through the windings. True or false?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the current flowing through a rectangular toroid when the energy in its magnetic field is 2.0 × 10-6 J?
Consider the circuit in Figure P32.18, taking = 6.00 V, L = 8.00 mH, and R = 4.00 . (a) What is the inductive time constant of the circuit? (b) Calculate the current in the circuit 250 s after the switch is closed. (c) What is the value of the final steady-state current? (d) After what time interval does the current reach 80.0% of its maximum value?
In an oscillating RLC circuit with L = 10 mH, C = 1.5 F , and R = 2.0 , how much time elapses before the amplitude of the oscillations drops to half its initial value?
A solenoid of N1turns has length l1and radius R1, and a second smaller solenoid of N2turns has length l2and radius R2. The smaller solenoid is placed completely inside the larger solenoid so that their long axes coincide. What is the mutual inductance of the two solenoids?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
A coil with a self-inductance of 3.0 H carries a current that decreases at a uniform rate dl/dt = -0.050 A/s. What is the emf induced in the coil? Describe the polarity of the induced emf.