A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively. Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC.

A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively. Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 27P

See similar textbooks

Related questions

Q: Which of the following is not true for the pan coefficient applied to Class A pan? (i) it is always…

A: Class A evaporation pan is used to measure the rate of evaporation on the field. This pan containing…

Q: Total cooling load; Moisture removed per hour; Minimum diameter of the fresh air duct so that the…

Q: Water with a flow rate of 0.85 lb/s and a temperature of 50 F enters a 1-inch tube. A constant wall…

A: Heat Convection: Heat convection is the physical movement of fluid from one place to another that…

Q: For a runway at an elevation of 1000 m above MSL and airport reference temperature of 16 °C, the…

A: Given, Airport reference temperature, ART = 16 oC Runway elevation = 1000 m above MSL Standard…

Q: A mass of air is at temperature of 30 °C and is having relative humidity of 75 %. Determine the…

A: Given: Temperature, T = 30°C Relative humidity, RH = 75%

Q: Example: Multilayer cylindrical thermal resistance network Steam at T= 320 °C flows in a cast iron…

A: Solution; Given Data; R1=2.5 cmR2=2.75 cmR3=5.75 cm

Q: Convert 15 inHg vacuum to N/m^2 abs. Assume a biometric pressure of 759 mmHg.

A: Atmospheric pressure and vaccum pressure have been given Hg and it has been asked to determine…

Q: Find the dew point temperature for the following air/water vapor mixture for 85°F dry bulb and 50%…

A: Given data- Current temperatue(T)=85oFRelative Humidity(RH)=50% To Find- The dew point temperature.

Q: 12. If an air/water vapour mixture starts at 30% relative humidity, and you add more water vapour to…

A: For questions 12, 13 In both the cases, If we keep temparature and moisture constant by changing…

Q: 2. Suppose the following atmospheric altitude versus temperature data have been collected:…

Q: If Water temp. 18oc and a relative humidity (55 %), Wind velocity at 2 m above ground al 21 km/hr,…

Q: Calculate the net radiation of sun for a day with 2 mm evaporation and air temperature of 30°c. O…

A: Step 1

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

Q: Q4)) A reservoir has an average area of 500 km2, its evaporation estimated to be 75% of class A pan…

A: Given data Average area=500 km2Evaporation from reservoir=0.75×calss A pan evaporationNet radiation…

Q: A steel tape, known to be of standard length at 20°C, is used in laying out a runway 2500 m long.…

Q: Problem 08.141 - River water to cool riverside house A house built on a riverside is to be cooled in…

Q: Water flows through a 4-in steel pipe (k=16 W/m-K) wrapped with a layer of 5-cm thick insulation…

A: Determine the value of heat flow through the pipe if the water is at 80℃ and air outside is at 20℃…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

A: The length of line measured = 746.22mThe standard length of tape at 20°C, l1 =50mThe average…

Q: 8:92 Neglecting losses, find the discharge through the venturi meter of Fig. Air 250 mm Water -150…

A: Given data Area of pipe Area of throat Height column Water as a flowing fluid.

Q: Consider an ordinary shower where hot water at 60°C is mixed with cold water at 10°C. If it is…

A: Given:- Temperature = 10 degree CelciusHot water temperature = 60 degree CelciusPressure = 150kPaTo…

Q: Problems: Q1/ The inner and outer surfaces of a 5-m 6-m brick wall of thickness 30 cm and thermal…

A: My dear Given data Dimensions of wall Thermal conductivity Temperature difference of surfaces.

Q: A single-storey 20 m wide × 20 m long× 3 m tall office building is used by 20 occupants. Each…

A: Infiltration rate- Infiltration rate is the amount of air that flows from the outside of the…

Q: For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and…

A: The given values are as followsThe room dimension is 30×20×5Density(ρ)=1.2kg/m3The specific…

Q: Calculate the precipitable water, the volume generated by the precipitation, and the height of…

A: Given data- Column of dry air 10km high Area (A) = 13 m2 Surface pressure is 101,300 Pa. The surface…

Q: The measured distance from A to B was 300.0m. The tape used has a standard length of 30m, at 20 °C…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A 5006 cm long by 4 m high wall is made of 25 cm concrete and 20 cm hollow clay tile with plaster of…

Q: Incident radiation at the Laguna Lake is 978 W/m2 at noon on February 14th. Water temperature is…

A: Given, Radiation (R) = 978 W/m2 Wind speed (V) = 1.7 m/s

Q: Given: Open water source Net radiation = 200 W/m2 %3D Air temperature 25 °C %3D Density of water =…

A: open water resource is given with above data and it has been asked to calculate evaporation rate…

Q: WATER RESOURCES ENGINEERING: Evaporation The temperature and relative humidity values for the month…

A: It is required to determine the monthly evaporation from the lake. Here, Rn is the net radiation,…

Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

A: To Find :- error in the area of the rectangular lot measured.

Q: rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

Q: topic: surveying A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded…

Q: Compute by the Priestley-Taylor method the evaporation rate in millimeters per day from a lake on a…

Q: 100°? air flows through a round aluminum tube of ID 60mm and OD 80mm at 4 ?? .The tube is covered in…

A: Take 25 °C as room temperature r1=30 mmr2 = 40 mmr3 = 45 mm Assume unit length of the tube Thermal…

Q: a. What difference in temperature from standard if neglect in use of a steel tape will cause an…

A: Answer To calculate the difference in temperature from standard based on the given data, we can use…

Q: Estimate the total evaporation in inches for 5 days for a certain lake using mass transfer method…

Q: 7. What is the default value of specific heat ratio in pipelines? a) 1 b) 1.2 c) 1.4 d) 2

Q: Given: Open water source Net radiation = 200 W/m2 %3D Air temperature = 30 °C Density of water = 996…

A: Evaporation is generally the method that modifies the water from a liquid to a gas and also vapors.…

Q: 2. A rectangular building 250.00 m by 130.00 m is to be laid out using a 30-m steel tape having a…

A: As per company's guidelines we can only answer first three questions. Kindly post other questions…

Q: Air flows from a 10 cm pipe in which the temperature and pressure are 4-C and 280 kPa, respectively,…

Q: A rectangular building 250.00 m by 130.00 m is to be laid out using a 30-m steel tape having a cross…

Q: 1. A mass of air is having temperature of 26.9 oC. The Relative humidity of this mass of air is 71…

A: Temperature of air (T)= 26.9 Degree Celsius Relative humidity (Rh) = 71 % Determine : Saturation…

Q: A mountain climbers observed that the pressure on top of the mountain is 510 mm Hg. At the same time…

Q: H.WII Cooling Load Estimation An air conditioned room in the Basra city that measures 3 m wide, 3.5…

A: Solution; Given data;

Q: Compute the potential evaporation for Amsterdam for the month of July if net radiation is 361 W/sqm,…

Q: 4. Estimate the temperature at 1000 m given a surface temperature of 22 °C for a clear sunny day…

A: Surface temperature = 22• C Temperature required at 1000m or 1 km. Environment Lapse Rate(ELR) - It…

Q: line was measured using a 50m tape and was recorded as 746.22m. when the average temperature during…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively. Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC. detailed solution pls thank you
topic: surveying A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively. Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC.
A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively.Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC. fundamentals of surveying
A line was measured using a 50m tape and was recorded as 746.22m. when the average temperature during measurement was 16°C. If the tape is of standard length at 20°C and a coefficient of thermal expansion of 0.0000116m/°C. Compute the correct length of the measured line.
A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is measured using this tape. The sides are recorded as 145 meteres and 113 meters. The average temperature of the tape during measurement is 29.4 degree Celsius with a pull of 60 N.
A department store plans to construct a one-story building with a rectangular planform. The building is required to have a floor area of 10,000 f2 and a height of 15 ft. It is proposed to use brick walls on three sides and a glass wall on the fourth side. Use the Lagrange multipliers to find the dimensions of the building to minimize the heat loss, assuming that the relative heat losses per unit surface area for the roof, brick wall, glass wall, and floor are in the proportion 3:2:7:1
Incident radiation at the Laguna Lake is 978 W/m2 at noon on February 14th. Water temperature is 28.0 °C. Airtemperature is 28.0°C, relative humidity is 85%, and wind speed is 1.7 m/s at 2m.– Determine the open water evaporation rate in mm/d using the energy method
For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and 25°C respectively. The space to be air-conditioned Is 20m x 30m x 5m and infiltration is estimated to be one alr are 1.2 (kg of dry air)/m³ and 1.02 kJ/(kg of dry air) °C, then the sensible heat load due to Infiltration is, nearly
Air at 30 deg. Celsius and 110KPa flows at 20N/s through a rectangular duct that measures 160mm x 320mm. Compute the average velocity (m/s) and flow rate (? ^3/s) using gas constant equal to 289 J/kg-K.
4.2. What is the normal range of the air relative humidity for residential premises? Choose the correct answer:1. 20-40%;2. 20-50%;3. 30-60%;4. 35-70%;5. 40-80%;
A 5006 cm long by 4 m high wall is made of 25 cm concrete and 20 cm hollow clay tile with plaster of 1.5 cm thickness on its both sides surfaces. The temperature on inside surface is 19°C while the outside temperature is 45°C. What is the rate of heat transfer through the wall of the hall?
Calculate the evaporation using Combination Method (mm/day) from an open water surface with air temperature 22°C, relative humidity is 40% and wind speed is 3 m/s, all measured at height 2 m above the water surface. Assume a roughness height of 0.03 cm. The net radiation is 200 W/m^2. Cp=1005 J/kg-K *Kelvin = Degree Celsius + 273.2 , use this in computing for the density of air