Answered: Find the dew point temperature for the…

Find the dew point temperature for the following air/water vapor mixture for 85°F dry bulb and 50% RH O 70 O 5 O 60 O 65

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 10P: Calculate the thermal resistance due to convection for the following situations: a. warm water with...

See similar textbooks

Related questions

Q: Sanitary Engineering laboratory the test " Relative Humidity of Air" discuss

Q: ospheric pressure is about 1.00×10° Pa on average. vert the downward force of the air on a desktop…

A: Given that Atmospheric pressure P = 1 * 10^5 Pa Surface area A = 2.1 m2 Force F = ?

Q: 17-A refrigerator is to remove heat from the cooled space at a rate of 300 kJ/min to maintain its…

A: Let us estimate the Input power required by the refrigerator.

Q: Total cooling load; Moisture removed per hour; Minimum diameter of the fresh air duct so that the…

Q: Exercise 2: According to an appliance manufacturer, the 4-in,-diameter vent on a clothes dryer is…

Q: Inside a wall measuring N/Sx N /3m, there are 2(glass thickness lcm) single-glazed windows measuring…

A: A wall is a construction that defines a certain region while also providing safety and shelter. A…

Q: A mass of air is at temperature of 30 °C and is having relative humidity of 75 %. Determine the…

A: Given: Temperature, T = 30°C Relative humidity, RH = 75%

Q: A room is to be maintained at 25°C dry bulb temperature and 55% relative humidity under the…

A: Given data, Dry bulb temparature=25oC Relative humidity=55% Sensible heat=5100W Laten heat=3400W…

Q: At 9:00PM., a thermometer reading 70oF is taken outdoors where the temperature is 15oF. At 9:05PM.,…

Q: A room is to be maintained at 25°C dry bulb temperature and 55% relative humidity under the…

A: Given that, dry bulb temparature=25oC sensible heat=5100 W latent heat=3400 W RELATIVE HUMIDITY=55%…

Q: In a condenser containing air and water, the air pressure is 22.1 kPa absolute. What is the gage…

A: given that pressure at absolute Pabs=22.1 KPaThe pressure at a point 2.09 m below 1 ltr water…

Q: The air in a certain room 150’ x 50’ x 12’ tested 0.2% CO2. Fresh air containing 0.05% CO2 was then…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

Q: 3. At 2:00P.M, a thermometer reading is 80°F is taken outside where the air temperature is 20°F. At…

Q: The damping ratio of the system response shown in BLUE is 1 0.8 0.6 0.4 0.2 0 -0.2 -0.4 -0.6 -0.8 20…

A: Explanation : The damping responses of various systems are given in above graph. The graph plotted…

Q: The measured distance between the two poles is 318 m. The tape used was standardized at 20 degrees…

Q: A steel tape, known to be of standard length at 20°C, is used in laying out a runway 2500 m long.…

Q: a. At 1:00 P.M., a thermometer reading 70°F is taken outside where the air temperature is - 10°F…

A: Using Newtons…

Q: Air at 25 ° C blows over the hot steel plate whose surface temperature is maintained at 150 ° C. The…

Q: Water flows through a 4-in steel pipe (k=16 W/m-K) wrapped with a layer of 5-cm thick insulation…

A: Determine the value of heat flow through the pipe if the water is at 80℃ and air outside is at 20℃…

Q: Exercise 2: According to an appliance manufacturer, the 4-in,-diameter vent on a clothes dryer is…

Q: A forced air system takes return air at 62 degrees Fahrenheit (°F). It heats theair 59°F. What is…

A: Given: The temperature at which the return air enters room Tr is 62oF. The heated temperature of…

Q: The dry bulb temperature and relative humidity for the conditions (WBT=12.6 and specific volume=0.85…

A: Given data, Wet Bulb Temperature= 12.6 C Specific Volume = 0.85 m3/kg of dry air We have to find the…

Q: For a particular location, the average net radiation is 185 W/m2, air temperature is 28.5 deg C,…

Q: Consider an ordinary shower where hot water at 60°C is mixed with cold water at 10°C. If it is…

A: Given:- Temperature = 10 degree CelciusHot water temperature = 60 degree CelciusPressure = 150kPaTo…

Q: Within an air-handling system, a stream of air at T=30°C and 91=40% relative humidity is being mixed…

A: Solution-The given values ara as followsT1=30°cφ1=40%T2=5°Cφ2=20%T3=20°Cφ3=0.006708kgH2o/kgdry…

Q: For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and…

A: The given values are as followsThe room dimension is 30×20×5Density(ρ)=1.2kg/m3The specific…

Q: 10 psig H to Free jet 1 in. dia. 3 ft 2 in. dia. *.?=In fig. V2 25.9 ft/s O 35.9 ft/s 15.9 ft/s

Q: D

A: The gas inside the pressure vessel have the property to change the volume and pressure. And the…

Q: 2.6 Express standard atmospheric pressure as a head, h p/pg, in (a) feet of ethylene glycol; (b)…

Q: a. What difference in temperature from standard if neglect in use of a steel tape will cause an…

A: Answer To calculate the difference in temperature from standard based on the given data, we can use…

Q: 18- Water flow (frictionless) through a long horizontal conical diffuser at a rate of 4.2 m3/sec.…

A: Given: The discharge is 4.2 m3/sec. The diameters are 1 m and 1.6 m. The pressure at the smaller end…

Q: 7. What is the default value of specific heat ratio in pipelines? a) 1 b) 1.2 c) 1.4 d) 2

Q: 1. A mass of air is having temperature of 26.9 oC. The Relative humidity of this mass of air is 71…

A: Temperature of air (T)= 26.9 Degree Celsius Relative humidity (Rh) = 71 % Determine : Saturation…

Q: A mountain climbers observed that the pressure on top of the mountain is 510 mm Hg. At the same time…

Q: H.WII Cooling Load Estimation An air conditioned room in the Basra city that measures 3 m wide, 3.5…

A: Solution; Given data;

Q: 10. When is air assumed to be incompressible? a) At low speed b) At high speed c) Independent of its…

A: Option (a) is correct At low speeds the air is assumed to be incompressible. At Mach number value…

Q: Q5: Imagine that you do not want the CO2 concentration to exceed 766 ppm. What is the minimum…

A: Cin=Cout+GNKQ Cin= 766 ppm Cout= 400 ppm G= 0.005 N= 4 people K=1000000

Q: Compute the cooling load for the south windows on a middle floor of an office building that has no…

A: Given :

Q: 1. Current mean temperature is 27°C. Current Vapor pressure is 2.337 kPa. (a) What is the dew point…

Q: If the air pressure at 18°C is 102.6kPa abs, determine the specific humidity of the air. Air Density…

A: According to given data

Q: b.) calculate the outside air flow for the restaurant dining area where cold air is supplied from…

A: Given data, Area of dining space = 175 m2 Ceiling height = 3 m

Q: 2.62 Water is at 20°C, and the pressure is lowered until bubbles are noticed to be forming. What…

A: Vapour pressure is the tendency of particles to escape from a liquid (or a solid). The temperature…

Concept explainers

Engineering Standards and Codes

Standards are technical publications designed to ensure the reliability of goods, products, methods, or services. They establish technical requirements, specifications, guidelines, features, or design procedures. Standards recommend a set of tolerance for design, processes, operations, production methods, or equipments used in a particular area. Standards are not legally binding unless they are accepted as code or regulation.

Question

clear and correct or dislike

Find the dew point temperature for the following air/water vapor mixture for 85° F dry bulb
and 50% RH
O 70
O 55
60
O 65

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air at 30 deg. Celsius and 110KPa flows at 20N/s through a rectangular duct that measures 160mm x 320mm. Compute the average velocity (m/s) and flow rate (? ^3/s) using gas constant equal to 289 J/kg-K.
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m into the atmosphere. The total pressure is 100 kPa, air temperature is 28°C and the dew point temperature is 16°C near the ground, the lapse rate 6°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal place
Air enters an adiabatic nozzle steadily at 300 kPa, 200°C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm2. Determine (a) the mass flow rate through the nozzle, (b) the exit temperature of the air, and (c) the exit area of the nozzle. R = 0.287 kJ/kg. K, CP 1.005KJ/kg. K.
1. In undisturbed air stream, where the pressure is 14.7 psi and density is 101325Pa, where the velocity is 500 ft/sec. What are the density, temperature, speed of sound, and specific weight where the velocity is 590ft/sec? g=9.8066 m/s^2
4.2. What is the normal range of the air relative humidity for residential premises? Choose the correct answer:1. 20-40%;2. 20-50%;3. 30-60%;4. 35-70%;5. 40-80%;
If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what is the temperature of the system (rod+water) at equilibrium assuming no losses to the surrounding?
A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is measured using this tape. The sides are recorded as 145 meteres and 113 meters. The average temperature of the tape during measurement is 29.4 degree Celsius with a pull of 60 N.
1. A mass of air is having temperature of 26.9 oC. The Relative humidity of this mass of air is 71 %. Determine Saturation Vapor pressure, Saturation deficit, Actual Vapor Pressure, Dew Point and Wet-bulb temperature.
Calculate the AQI and give a description of air that contains 5 ppm CO (8-hour average), 300 pg/m3 PM-10 {24-hour average), and 0.10 ppm SO2 (24-hour average).
2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature during measurement was 16°C. If the tape is of standard length at 20°C and a coefficient of thermal expansion of 0.0000116m/C. Compute the correct length of the measured line.
If the air temperature on the ground is 25˚C, and the dry adiabatic lapse rate is 10˚C, and the environmental lapse rate is 5˚C. Give the temperature of the atmosphere after 1 km above the ground
Glycerin (s.g.=1.26, and absolute viscosity = 1.49 Pa-s) flows through a rectangular conduit 325mm by 450mm at the rate of 160 lit/sec. Determine the major head loss due to friction (hf) per 1km length of pipe.