Answered: A red laser (725 nm) shines on a double…

A red laser (725 nm) shines on a double slit (slit separation - 0.19 mm). What is the angle of the fourth order maximum (that is, the fourth bright fringe away from the central maximum)?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter35: Diffraction And Interference

Section: Chapter Questions

Problem 87PQ

See similar textbooks

Similar questions

What is the angular width of the central fringe of the interference pattern of (a) 20 slits separated by d=2.0103 mm? (b) 50 slits with the same separation? Assume that =600 nm.
Figure 27.55 shows the central part of the interference pattern for a pure wavelength of red light projected onto a double slit. The pattern is actually a combination of single slit and double slit interference. Note that the bright spots are evenly spaced. Is this a double slit or single slit characteristic? Note that some of the bright spots are dim on either side of the center. Is this a single slit or double slit characteristic? Which is smaller, the slit Width or the separation between slits? Explain your responses. Figure 27.55 This double slit interference pattern also shows signs of single slit interference. (credit: PASCO)
Four trials of Young's double-slit experiment are conducted. (a) In the first trial, blue light passes through two fine slits 400 m apart and forms an interference pattern on a screen 4 in away, (b) In a second trial, red light passes through the same slits and falls on the same screen. (c) A third trial is performed with red light and the same screen, but with slits 800 m apart, (d) A final trial is performed with red light, slits 800 m apart, and a screen 8 m away. (i) Rank the trials (a) through (d) from the largest to the smallest value of the angle between the central maximum and the first-order side maximum. In your ranking, note any cases of equality, (ii) Rank the same trials according to the distance between the central maximum and the First-order side maximum on the screen.
Two slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?
From Equation 37.2, find an expression for the sine of the angles at which the minimum intensity occurs in a single-slit diffraction pattern. Compare the result to Equation 37.1.
A thread must have a uniform thickness of 0.525 mm. To check the thickness of the thread, you can illuminate it with a laser of wavelength 625.8 nm. A diffraction pattern like the one produced by a single slit forms on a screen. a. If the screen is 3.00 m from the thread, how far apart are the fifth-order minima from one another? b. If the thread's thickness increases by 20%, how far apart will the fifth-order minima be?
Microwaves of wavelength 10.0 mm fall normally on a metal plate that contains a slit 25 mm wide. (a) Where are the first minima of the diffraction pattern? (b) Would there be minima if the wavelength were 30.0 mm?
Determine what happens to the double-slit interference pattern if one of the slits is covered with a thin, transparent film whose thickness is /[2(n1)] , where ? is the wavelength of the incident light and n is the index of refraction of the film.
In Figure 38.4, assume the slit is in a barrier that is opaque to x-rays as well as to visible light. The photograph in Figure 38.4b shows the diffraction pattern produced with visible light. What will happen if the experiment is repeated with x-rays as the incoming wave and with no other changes? (a) The diffraction pattern is similar. (b) There is no noticeable diffraction pattern but rather a projected shadow of high intensity on the screen, having the same width as the slit. (c) The central maximum is much wider, and the minima occur at larger angles than with visible light. (d) No x-rays reach the screen.
In a Youngs double-slit experiment, a set of parallel slits with a separation of 0.100 mm is illuminated by light having a wave- length of 589 nm, and the interference pattern is observed on a screen 4.00 m from the slits, (a) What is the difference in path lengths from each of the slits to the location of a third-order bright fringe on the screen? (b) What is the difference in path lengths from the two slits to the location of the third dark fringe on the screen, away from the center of the pattern?
Ten narrow slits are equally spaced 0.25 mm apart and illuminated with yellow light of wavelength 580 nm. (a) What are the angular positions of the third and fourth principal maxima? (b) What is the separation of these maxima on a screen 2.0 m from the slits?
A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm. (a) If light from this lamp falls on a N slits separated by 0.025 mm, how far from the central maximum are the third maxima when viewed on a screen 2.0 m from the slits? (b) By what distance are the second and third maxima separated for l=486 nm?