Answered: A reservoir of glycerin has a mass of…

A reservoir of glycerin has a mass of kg and a volume of Find its density in kg/cu.m. MASS = 1025 VOLUME = 0.513 cu.m. -- - %3D %3D O 1,998.051 O 1,344.062 O 2,331.117 O 1,827.260

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter11: Calibrating Instruments

Section: Chapter Questions

Problem 4RQ: Temperature-measuring instruments may be designed to measure the temperature of vapors, ________,...

See similar textbooks

Related questions

Q: The figure (not drawn to scale) shows a metallic cylindrical column submitted to a combined load:…

Q: A steel component is subjected to alternate cyclical loading. The steel follows Basquin's law for…

A: Answer: (a) Stress Ratio: -1 Amplitude Stress: 213 MPa Mean Stress: 0 MPa (b) The corresponding…

Q: Q A thick-walled cylinder has an inside diameter of 150mm. The inside of the cylinder is subjected…

A: Soln:- d1 = 150 mm r1= 75 mm P1= 350 bar = 350 × 10^5 pa Max.…

Q: Part A- Angular Acceleration of the Rod Learning Goal: The slender rod AB shown has a mass of m =…

Q: Consider a Rankine cycle with reheat as shown in the diagram, with state properties as specified in…

A: as per guideline i have to solve only three subpart of your question

Q: Find the centroidal moment of inertia and radius of gyration of the given cross section below, then…

A: Given Diameter, d = 24 cm Side, a = 10 cm Find Moment of inertia, I Radius of…

Q: In the gap between the two plates, the lubricant flows in one direction (x) by the pressure…

Q: Initially, a closed system consists of 2 lb of water vapor at the temperature and volume of 300°F…

A: Given Mass, m = 2 lb Volume, V1 = 20 ft3 V2 = 9.05 ft3 Work done, W…

Q: The figure (not drawn to scale) shows a metallic cylindrical column submitted to a combined load:…

Q: A uniform disc having a mass of 10 kg and a radius of gyration of 175 mm is mounted on one end of a…

A: find the angular velocity of precession.

Q: 10. A 72.0 N ladder that is 3.60 m long is placed against a frictionless wall so the base of the…

Q: SITUATION 8 Determine the critical hydraulic gradient of a coar se- grained soil if buoyant unit…

A: find the critical hydraulic gradient.

Q: H, =0.40 Hz = 0.30 D 150 mm 150 mm B E 300 mm 300 mm M 150 mm 150 mm 250 mm

Q: 12 mm PROBLEM 1.25 For the assembly and loading of Prob. 1.9, determine (a) the average shearing…

Q: Complete the schematic below to provide for the following: 1. Cylinders extend and retract together.…

A: Given : To find : Complete the diagram

Q: The pulley system shown in Figure Q1c lifts a mass, m, of 550 kg. Calculate the force FA necessary…

Q: A tripod supports the load W as shown in the figure. Determine the maximum load "W" (in pounds),…

Q: Fig. Q1 2. The truss in Fig. Q6 supports the vertical load of 600N. If L = 2m determine the force in…

Q: Consider the system shown in figure, which consists of a uniform rigid bar OA that is welded o a…

Q: ) In terms of machine utilisation, discuss the benefits and drawba each?

A: Utilisation Rate, R=700/hrDelay time, T=35minsCapacity, C=100unitsOperation Variation X=25%…

Q: 11. What is the total distance that the object travels?

A: Displacement can be understand as the minimum distance between the initial and final position.…

Q: the blanks: the center distance in (cm) of 4 direct contact rolling.cylinders. Cylinders A-D have a…

Q: 5.) Does a refrigerator full of food consume more power if the room temperature is 200C than if it…

Q: 75 kg E=0.3 15 eg 41,2m 25 kg |2.0m

A: given; →mass of C (mc)=75kg→coefficient of friction (μ)=0.3→mass of B (mB)=15kg→when start from B;→…

Q: 12. For which time period, is there a constant velocity of 10 m/s? - D. 30 20 B. 10 C 3 4 tame (s 6.…

A: Point A: (tA,sA)= (0,0)Point B: (tB,sB)= (1,10)Point C: (tC,sC)= (2,10)Point D: (tD,sD)= (5,40)Point…

Q: Problem (5). The internal and external diameters of the centrifugal pump are 200 mm and 400 mm…

Q: An Actual Reheat Cycle with one-stage reheating is executed with steam expanding initially from the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: 2 m 5 m h * P

A: find the value of h.

Q: The coefficient of kinetic friction under block A in Fig. 24-A is 0.30 and under block B is 0.20.…

Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…

A: Find Mean effective pressure Indicated Power

Q: If water is flowing half-full in a circular pipe containing a gas at a constant pressure (as shown…

A: Pressure at the depth of h in a liquid of density ρ is given by, P=ρgh In the case of a circular…

Q: For the given instant collar A moves to the left with a speed 3.5 m/s and acceleration 2.7 m/s² ,…

Q: A system is moving like in the figure below. Find the angular velocity of link AB if point C is…

Q: A hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile load…

Q: A conical tank having a radius of the base equal to 0.39 m and a height of 0.75 m. The cone is laid…

Q: The bars shown are the same length. The spring is unstretched when alpha= 90°; the horizontal…

A: Consider the diagram as shown below.

Q: p= 998 kg/m, Cp = 4171 J/kg K, k = 0.651 W/m K, po = 4.71 x 104 kg/m s, Hu = 2.82 x 104 kg/m s and…

A: We calculate reynolds number , then the nusselt number and then the heat transfer coefficient.

Q: expression for R in terms of unit vector notation). (c) determine the magnitude and direction of the…

Q: *15-100. Each ball has a negligible size and a mass of 10 kg and is attached to the end of a rod…

A: find the speed of balls at t= 3 sec.

Q: A chain and sprocket has a pitch diameter of 9.56-inch and pitch 1/2-in .How many teeth are there in…

A: Given data, D = 9.56 in (D = Pitch diameter ) P= 0.5 in (P = Pitch) Find T = no. Of teeth = ?

Q: Determine the chain speed in meter/sec of an rc 80 on a 21-tooth sprocket turning at 600 rpm.

A: find the speed of chain.

Q: A hollow steel shaft, 5.5 ft long, has an outer diameter of 2.76 in. and an inner diameter of 1.48…

Q: Question 1 Figure Q1a shows two cables attached to a half-ring anchor point as shown in Figure Q1a.…

A: 1-Use resultant formula of 2 force to solve first problem, 2- use equilibrium equilibrium to solve…

Q: Determine (a) the shear stress in the rivets and (b) the thickness "t" of the steel plate if the…

A: find the shear stress in rivets and thickness of plate.

Q: g of gas occupying 0,7 m³ had on original temperature of 0.25 15 °F. It was then heated at constant…

Q: b siven: = 20 kN = 1.1 m = 1.3 m = 1.3 m

Q: The wheelbarrow and its contents have a mass of 60 kg with a centre of mass at G. Determine the…

Q: Can you help me with these practice questions please

Q: for the maximum velocity in (mm/s) of the 1sthalf of the return stroke Compute for

Q: The overhanging beam is supported by a pin at A and the two- force strut BC. Determine the…

Concept explainers

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.

Question

100%

Need asap. Thank youuuuu. Upvote

A reservoir of glycerin has a mass of
kg and a volume of
Find its density in kg/cu.m. MASS = 1025 VOLUME = 0.513
cu.m.
---
%3D
%3D
O 1,998.051
O 1,344.062
O 2,331.117
O 1,827.260

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given Data

VIEW

Step 2 Calculation

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A box contains a mixture of small copper spheres and small lead spheres. The total volume of both metals is measured by the displacement of water to be 427 cm^3, and the total mass is 4.36 kg. What percentage of the spheres is copper?
Balloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ? airgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 70 kg each, Determine the maximum amount of load, in kg . Assume the density of air is ? =1.16kg/m3, and neglect the weight of the ropes and the cage
Ethylene glycol (antifreeze) has a density of 1.11 g/cm^3.What is the volume in L of 4.1 kg of this liquid?
In a tank with a height of 1 meter, open to the atmosphere at the top, there are two immiscible liquids (which do not mix) and whose densities are 13,600 kg/m3 and 750 kg/m3, respectively. The tank is completely full and each liquid occupies half of the container. If the atmospheric pressure of the place is 105 Pa, at what depth, measured from the top of the tank, is the value of the gauge pressure equal to half the value of the atmospheric pressure of the place? Consider that the gravitational acceleration of the place is 9.8 m/s2? a) 84.76 cmb) 34.75 cmc) 50.00 cmd) 37.51 cm
A fluid has a specific volume of 0.00007353 m3/kg. If 500 grams of fluid is poured in a container, how much volume, in cm3, will it occupy? The velocity distribution for the flow of oil with dynamic viscosity of 0.05 Pa-s is given by u(y)=200y(0.1−y)u(y)=200y(0.1−y) where y is in meters. What is the shear stress at the bottom boundary in Pa? see picture
In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the oil is898 kg/m 3 ?
Ethylene glycol (antifreeze) has a density of 1.11 g/cm^3. What is the mass in g of 417 mL of this liquid?
Consider a tilted surface with an angle of 30 degrees. Oil (µ = 0.025 Pa.s) covers the inclined surface, and when a cubic object with a height of 0.1 m is placed on the tilted surface, a liquid film of 0.5 mm occurs. Suppose that the object slides down the surface with a constant velocity of 0.2 m/s. Determine the mass (in gram) and density of the object (in kg/m3).
Give me right solution. Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute pressure of 23 kPa, abs. and the atmospheric pressure at sea level is 101.325 kPa, absolute and temperature of 15 ⁰C. The gas constant of air is 286.9 joule per kilogram per degree kelvin. Assume the condition isisothermal.
A 3-kg plastic tank has a volume capacity of 0.2 m 3 and is filled with water. What is the mass of air that the tank can carry? How many tanks can be filled by helium (SG = 0.138) if the total mass of helium is the same with that of air? How many tanks can be filled with oxygen (SG = 1.1044) if the total mass of oxygen is the same with that of air?
A two-compartment vessel contains fluid in each section. For the first compartment, the fluid density is 1,285.1 kg/m³ and for the second is 560.6 kg/m³. The partition is removed, allowing the fluids to mix. Determine the specific gravity of the mixture if the fluid masses are equal.
The vapor pressure of water above water in a capillary is 99.9% of that above flat water surgace at 80°C. What is the diameter of the capillary? density of water= 0.9718g/cm^3, surface tension of water=62.6mN/m