a resistance of 6 ohms is connected in parallel with a 3 ohms resistor. both resistances are then connected in series with an 8 ohms resistor through a 6 ohms resistor. If the supply is 220V source. What is the current through a 6 ohms resistor.

a resistance of 6 ohms is connected in parallel with a 3 ohms resistor. both resistances are then connected in series with an 8 ohms resistor through a 6 ohms resistor. If the supply is 220V source. What is the current through a 6 ohms resistor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter8: Combination Circuits

Section: Chapter Questions

Problem 1PA: A circuit contains a 1000- and a 300- resistor connected in series with each other. The total...

See similar textbooks

Related questions

Q: Date: 4:00 PM QI) For the circuits shown in figure below, obtain the equivalent resistance between…

Q: Obtain V0 equation from Figure below and calculate V0 for V1=2V, V2=3V and V1=2V, V2=4V. R3=2k,…

A: To answer above question, one should know what an op-amp amplifier is. An amplifier is an electronic…

Q: A combination of three resistors R1, R2 and R3 in series is connected across a voltage source VT.…

Q: a 25 V source. If the total current delivered by the source is 1 A, determine the following: A. The…

A: When the resistances are connected in parallel the voltage across all the resistance should be the…

Q: Three resistor are connected in parallel to a 20V-supply. The resistances are R1=100, R2=8 and R3.…

Q: 1: The voltage between a and b terminal of a voltage source which has internal resistance R, is…

Q: نقطتان (2) St In the lab, If the circuit shown in the figure with R1= 3000 and R2=2000 ,R3=002, then…

A: Given data, R1=300 Ω, R2=200 Ω, R3=0 Ω Circuit diagram is given as,

Q: Three resistors and two voltage sources R1 = 10 ohms, R2 = 20 ohms, R3 = 30 ohms, V1 = 15v, V2 = 9v…

A: The modified circuit is:

Q: In the figure, there are two meshes. Also, it is given the power supplied by 5A current source is…

Q: Resistor R1 is connected in series with the parallel combination of resistors R2 and R3. Resistor R1…

A: KIRCHHOFF’S LAW KCL: The algebraic sum of all currents at a node is zero. KCL is…

Q: В1 R1 R2 A2, 12= A1 = 8A 4A A

Q: 1)For the above circuit, determine a) The value of a resistance Rv, so that there is maximum power…

A: The maximum power will transfer to the load only if the thevenin's equivalent resistance is equal to…

Q: Consider the horizontally-oriented 1kΩ resistor that is forming the "bridge" in the bridge circuit…

A: First calculate Thevenin equivalent circuit from 1 k ohm terminals. From thevenin equivalent circuit…

Q: Three resistor are connected in parallel to a 20V-supply. The resistances are R1= 10 ohms, R2=…

Q: A combination of three resistors R1, R2 and R3 in series is connected across a voltage source Vt.…

A: The required parameters can be calculated by using the ohm's law. The equivalent resistance can be…

Q: a. Find the total resistance for the series circuit of Figure shown. b. Calculate the source current…

A: As per our guidelines we are supposed to the first 3 subparts,if a student asks multiple subparts.…

Q: Five resistances are connected as shown in figure below. The equivalent resistance * between the…

A: The resistance in the circuit can be reduced by combining the series or parallel resistors together.…

Q: The resistance R1 and R2 are connected in parallel. The ratio of values of resistance R1:R2 is 4:1,…

Q: There is a constant current source whose value is 8 A now there are three resistors connected to it…

A: Draw the circuit and than using nodal analysis find the voltage across the parallel connected…

Q: For a given circuit, A 25-ohm resistor is in series with five resistors in parallel rated at 10, 20,…

A: For the given question we have to find the total resistance , total current, current and voltage…

Q: Example-2.5 For the circuit in figure (a), find voltage v, and v2. Solution: 22 ww- ww 20 V V2 20 V…

A: According to the question we have to find the value of the V1 and V2.

Q: Q2) By using Kirchhoff's Current Law Find the current through a 122 resistance(l), and current…

Q: iny In the circuit below resistors R1 and R2 are in parallel and have resistances of 8 n and 4 N,…

Q: 1)))))For the above circuit, determine: a) The value of a resistance Rv, so that there is the…

A: In this question, We need to determine the The value of a resistance Rv for maximum power transfer…

Q: A 24-V battery is used to supply a 3-carbon type resistor network and two lamps. The connection of…

A: This question belongs to network theory . It is based on the calculation of total resistance and…

Q: A 30-ohm is connected in parallel with a variable resistance R. The parallel combination is then…

A: Power taken by the resistor R = (current through R)2* R First we will calculate current in R in…

Q: Using the superposition method in the circuit, find the voltages at the ends of the resistors and…

Q: A 30-ohm is connected in parallel with a variable resistance R. The parallel combination is then…

Q: Two 12 Ω and 6 Ω resistances are connected in parallel. This parallel combination is connected in…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: d. Find the Norton Current (IN) as seen by the load. e. What load resistance would absorb the most…

Q: how can i solve for the circuit theoratically to get the value of the 3 resistors which are 10k ohm?…

A: The circuit can be drawn as

Q: The figure shows a resistor network consisting of four resistors. R = 480 ohms, R2 = 130 ohms, R3 =…

A: According to the portion we have to calculate the value of equivalent resistance between B and C.

Q: 4. A series circuit has the potential difference of 10V, 20V, and 30 V. how much is the source…

A: 4. Find source voltage of series circuit with 10V, 20V, 30V ? 5. Find voltage across R2 which is…

Q: Solve for the following with reference on the figure below: Find the total resistance for the series…

Q: A 30-ohm is connected in parallel with a variable resistance R. The parallel combination is then…

Q: A current of 30.0 mA is to be divided into two branch currents of 20.0 mA and 10.0 mA by a network…

Q: R,, then the voltage across R, and the voltage across R2 are :Two resistors, R, and R2, are…

Q: For the circuit shown below, find the values for V01, V02 and I0 (VDSi=0.7V VDGe=0.3V

A: For the circuit shown below, find the values for V01 V02 and Io (VDSi=0.7V VDGe=0.3V

Q: 1 8 2 7 R₁ 3 6 R₂ 4 5 R₁

A: We need to find out the total total resistance and current for given circuit .

Q: For the circuit shown in Figure below, find the equivalent resistance and determine all resistor…

Q: The resistance of a parallel circuit consisting of two branches is 12 ohms. If the resistance of one…

A: Given; For parallel circuit of two resistors Req=12 ΩR1=18 Ω

Q: In the following circuit, a) ( what is the total resistance of the circuit looking between the two…

Q: For the Wheatstone bridge cited in the figure, calculate what the resistance Rx must be that…

A: In this question, We need to determine the value of unknown resistance Rx?

Q: Apply Norton theorem on the circuit shown in Figure 2 to find the Rn and In Fill up the Table 2 for…

A: For this problem we have to find Norton's current and Norton's resistance.

Q: For the above circuit, determine: a) The value of a resistance Rv, so that there is maximum power…

Q: A 93-V source is in series with six resistors having resistances of 4, 8, 15, 19, 25, and 2 ohms.…

Q: A coil of resistance 16 ohm is connected in parallel with a coil of resistance R₁. This combination…

Q: For the circuit shown in figure below, find the equivalent resistance and determine all resistort…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circuit contains a 1000- and a 300- resistor connected in series with each other. The total circuit resistance must be reduced to a value of 1150 . Using standard resistance values of 5% resistors discussed in Unit 5, explain how to change the present resistance value to the value desired.
A 10 ohms and a 20 ohms resistance are connected in parallel and a 5 ohms is connected in series with the two. If the supply voltage is 48V, find the current in the 10 ohms resistance.
a current 10ohms and a 20 ohms are connected in parallel. another resistance of 5ohms is connected in series with the two. if the supply voltage is 48V, what is the current through th 10ohms resistor?
For the above circuit, determine: a) The value of a resistance Rv, so that there is maximum power transfer from the circuit to it. b) The value of the maximum power transferred to that load.
A 10-ohm resistor is connected in series with another resistor R. This in turn is connected in series to a 12-V source. If the voltage across the 10-ohm resistor is 3 V, determine the resistance R.
The total current drawn by a circuit consisting ofthree resistors connected in parallel is 12 A. Thevoltage drop across the first resistor is 12 V, thevalue of the second resistor is 3 ohms, and the power dissipationof the third resistor is 24 W. What are the resistances of the first and third resistors?
a current 10ohms and a 20 ohms are connected in parallel. another resistance of 5ohms is connected in series with the two. if the supply voltage is 48 ohms, what is the current through th 10ohms resistor?
A combination of three resistors R1, R2 and R3 in series is connected across a voltage source Vt. The voltage drop across R1 and R3 are 10V and 36V, respectively. If the current supplied by the source voltage is 1.4A and the total power supplied by the source is 70W, Calculate the value of Req-
A 100-W, 110-V and a 50-W, 110-V lamps are connected in series across a 220-V d.c. source. If the resistances of the two lamps are assumed to remain constant, the voltage across the 100-W lamp is
Consider the horizontally-oriented 1kΩ resistor that is forming the "bridge" in the bridge circuit below. Which of the following statements about the current in this resistor is correct? It flows from right to left No current is flowing through this resistor It flows from left to right The current through this resistor is negative
A 30-ohm is connected in parallel with a variable resistance R. The parallel combination is then connected in series with a 3-ohm resistor. Find the minimum value of R if the power taken by R is equal to the power taken by the 3-ohm resistor.
When two identical elements of a kettle are connected in series to a 240V supply, Power developed is 400W. Find the resistance of either elements and the power developed when the elements are connected in parallel to the supply.