A resistance R =0.291 Ω is connected in series with an inductance L = 251 mH and capacitance C = 11.6 μF. What percentage of its initial value does the maximum charge on the capacitor decay to after 67.7 cycles?

Q: At what frequency does the inductive reactance of a 79.0-µH inductor equal the capacitive reactance…

A: Given :     Inductance, L = 79.0 μH                          L = 79.0*10-6 H     Capacitance, C =…

Q: Consider an RLC circuit with emf amplitude E„ = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

A:

Q: QI/ An impulsive voltage E is applied at t=0 to a series circuit containing inductance L and…

A:

Q: The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain instant…

A: The charge,

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A:

Q: In an L-R-C series circuit, the resistor has a resistance of 214 ohms, the inductor has a reactance…

A:

Q: An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A:

Q: An inductor and a resistor are connected in series. When connected to a 60-Hz, 90-V (rms) source,…

A:

Q: A particular inductor has appreciable resistance. When theinductor is connected to a 12 - V battery,…

A: Part A:

Q: VP30.10.3 The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain…

A: (a)The equation for the electrical energy is given by,

Q: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF. During the current…

A:

Q: An inductor is connected to an AC source. If the inductance of the inductor is 0.460 H and the…

A: Given value--- V = 120 sin (29.5 pi t) . L = 0.460 H . We have to find--- the frequency of the…

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

A: Given The voltage of an LR circuit is V(t) = 10 V. The inductance of the circuit is L = 0.1 H. The…

Q: An inductor is connected to an AC source. If the inductance of the inductor is 0.600 H and the…

A: The voltage source of an alternating current (AC) system is written as, ∆v=V0sin(2πft)…

Q: Calculate the phase angle (in radians) for a circuit with a maximum voltage of 12 V and ω= 100 Hz.…

A: The expression to calculate the phase angle between the current and the voltage is,

Q: An inductor is connected to an AC source. If the inductance of the inductor is 0.504 H and the…

A: In this question we are given that an inductor is connected to an AC source. If the inductance of…

Q: An inductor is connected to an AC source. If the inductance of the inductor is 0.428 H and the…

A: ∆V = 120VSin(29πrad s-1 t) L = 0.428 H

Q: An LC circuit consists of a 3.4-µF capacitor and a coil with a self-inductance 0.080 H and no…

A: Capacitance = C=3.4×10-6 F Inductance = L=0.08 H Initial charge = 5.4×10-6 C It is the case of LC…

Q: The current through the inductor of an LC circuit oscillates at o (3.27x 10brad/s. If the inductance…

A:

Q: In an L-C circuit, C= 3.21 μF and L = 88.0 mH . During the oscillations the maximum current in the…

A: L = 88 mH = 0.088 H C = 3.21×10-6 F Imax = 0.853 mA

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: Given, Resistance=231ohm Inductance=307mH Capacitance=190muoF Voltage=12v

Q: Consider an RLC circuit with emf amplitude E„ = 10 V, resistance R = 10 Q, inductance L = 1.0 H, and…

A:

Q: The current through the inductor of an LC circuit oscillates at o = (5/V3)rad/s. If the capacitance…

A:

Q: An inductor is connected to an AC source. If the inductance of the inductor is 0.448 H and the…

A:

Q: Given is an LC circuit with an inductance of 40.0 mH and a capacitance of 10.0 mF. The capacitor was…

A:

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: As per guidelines we are suppose to do only three subpart from multipart question, kindly post rest…

Q: inductor are connected in series. The resistor has a resistance of 50.0 N, the capacitor has a…

A: Solution:- Given R = 50 ohm C=2.50 microF L= 2.00 mH

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

A:

Q: The output voltage of an AC source is given by Av = 120 sin 38.0nt, where Av is in volts and t is in…

A:

Q: A series RLC circuit contains a resistance R=200 ohm, an inductance with inductive reactance X=80.0…

A:

Q: Consider an RLC circuit with emf amplitude E, = 10 V, resistance R = 10 Q, inductance L = 1.0 H, and…

A:

Q: At 3.7 kHz, an inductor has an impedance of 8.2j Q. What is the inductance, in uH, of the inductor?

A:

Q: An electromotive force E(t) = {120 (120, 0SIS 20 1 > 20 is applied to an L-R series circuit in which…

A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Q: A current of 1.0 A flows in an RLC series circuit consisting of a resistor with a resistance value…

A:

Q: An AC voltage source is connected to an inductor with inductance 0.056 H. The voltage source…

A: Part a solution:

Q: Consider an RLC circuit with emf amplitude E, = 10 V, resistance R = 10 2, inductance L=1.0 H, and…

A:

Q: For an RLC series circuit, the voltage amplitude and frequency of the source are 130 V and 800 Hz,…

A: This question is based on Alternating Currents Chapter.  Average Power formula:…

Q: Consider an RLC circuit with emf amplitude E, = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

A:

Q: The current through the inductor of an LC circuit oscillates at ω = (3.2 π x 103) rad/s. If the…

A:

Q: Consider an RLC circuit with emf amplitude E„ = 10 V, resistance R = 10 2, inductance L=1.0 H, and…

A:

Q: At what frequency does the inductive reactance of a 66.0-uH inductor equal the capacitive reactance…

A: Formula of frequency of LC-circuit is as follows: f=12πLCwhere,L=InductanceC=capacitance

Q: A resistor ( R = 9.00 × 102 Ω), a capacitor (C = 0.250 µF), and an inductor (L = 2.50 H) are…

A:

Q: A battery is used to charge a capacitor. When the stored energy in the capacitor is 1 µj, it is…

A: Given : Maximum energy stored in capacitor, Emax = 1 μJ             Inductance, L = 6 μH

Q: Aseries circuit contains a resistor with R = 40Ω, an inductor with L = 2 H, a capacitor with 0.0025…

A: Given :     Resistor, R = 40 Ω     Inductor, L = 2 H     Capacitor, C = 0.0025 F     Voltage, V(t) =…

Q: A capacitor of capacitance 158 mF and an inductor form anLC circuit that oscillates at 8.15 kHz,…

A: a) The expression foe the angular frequency of the oscillation will be,

Q: An LC circuit has an inductor of inductance 8.4 mH and a capacitor with a capacitance of 963.7 µF.…

A: Given Inductance of the inductor is given as L=8.4 mH=8.4×10-3 H Capacitance is C=963.7…

Q: When an inductor with L = 10 mH is attached to an AC voltage source, the inductive reactance is 7900…

A:

Q: In the circuit of Figure P31.29, the battery emf is 50.0 V, the resistance is 250 V, and the…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.