A short circuit test was performed upon a 10-kVA, 2300/230-volt transformer with the following results: Esc = 137 volts; Psc = 192 W; Isc = 4.34 A. Calculate in primary terms the reactance of the transformer.

A short circuit test was performed upon a 10-kVA, 2300/230-volt transformer with the following results: Esc = 137 volts; Psc = 192 W; Isc = 4.34 A. Calculate in primary terms the reactance of the transformer.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter28: Three-phase Transformers

Section: Chapter Questions

Problem 4RQ: An open-delta three-phase transformer system has one transformer center-tapped to provide a neutral...

See similar textbooks

Related questions

Q: R1 R2 b a 20 Vs1 11 Vs2 =12V 2A 20V

Q: draw a schematic diagram of the jumpers connected to the front panel of a computer system unit.

A: Jumpers allow the computer to shut down the electrical circuit, allowing electricity to flow to cert...

Q: For the circuit given below: (a) Derive the equation of Kirchhoff's Current Law for node a and node ...

Q: 4-In general, NAND and NOR circuits are easier for implementa tion when building logic gates from tr...

A: The solution is given below

Q: A 225 / 430 V, 8 KVA, 50HZ single phase transformer has a copper loss of 105 W at full load, unity p...

A: Single Phase Transformer The device operates on single-phase power. It works on the principle of Far...

Q: (ii) Sketch the output versus input graph for a 4-bit digital-to-analog UTN converter (DAC) which ha...

Q: What are the different onboard sources of electrical power in a modern commercial passenger aircraft...

Q: Electrical Engineering 40Ω 50Ω. 1502 4V 802 15mA ( T 25Ω. Isos 802 Please solve for the current I5o0...

Q: A series circuit connected across a 100-Vac source consists of a 10-Q resistor, a 5- capacitor, and ...

Q: A 5000 uF capacitor is charged by a steady current of 0.5 mA for 30 s. Calculate (a) the charge supp...

A: Charge =integration of current. Voltage across capacitor (p.d) =(charge on the plate)/capacitance. ...

Q: 1. For the network of Fig. 12.10: 6 kn 18 mA 4 kn 2 kn 36 V FIG. 12.10 Hi

Q: 7. Find out fn using Norton's Theorem, [Hint: Resistor across which any electrical parameter is unkn...

A: In this question we will find load current io using Nortons theorem...

Q: Q4) A piece of Silver Wire has aresisitance of 22 what will be the rsistance of Manganin wire of one...

A: Solve the problem

Q: A 160 micro-farad capacitor is connected in series with a 10 ohm resistor. Write the equation of the...

Q: Calculate the average output voltage of the circuit shown. Vo = volts 10 V 2 ΚΩ 0. 2 k2 2k2

A: Full wave rectifier- A circuit which converts alternating current into DC with the help of diodes.

Q: A 15.9-µF capacitor and a 15.1-mH inductor are connected in parallel. In series with these units are...

A: In a circuit, a capacitor and inductor are connected in parallel connection. The values of the capac...

Q: A resistor of 6 ohms and an unknown impedance coil in series draws 12 A from a 120 V, 60 Hz line. If...

A: Power consumed by resistor = current2 × resistance . Impedance of the coil= voltage/ current through...

Q: Find Z, and V,n for the Thevenin equivalent of the given circuit 3Ω 200-50 V j6 Ω I2

A: To find the Thevenin impedance (Zth) and Thevenin voltage Vth for the given circuit

Q: Question 2. Given a balanced 3-wire, three phase system serving the following loads: Vab = 200 < 0V ...

Q: a) Consider the CMOS Inverter with the following device parameters: NMOS : Vin = 0.6 V Kn = 60 µA/V²...

Q: find a response i (t) at steady state of the circuit and the value i, l0.5ms] set to W= 500 rad/s l0...

Q: (a) State two differences in the features of a general-purpose computer application compared to an e...

A: Since you have posted multiple different questions. we will solve the first question for you. To get...

Q: From the following test results, determine the voltage regulation of a 346 kVA, 2,000V, 3 phase Y al...

A: We have given the Voltage rating=2000 V The emf of 500 V is provided on open-circuit with the field ...

Q: Problem 1. H3(S) HI(S) H2(S) H4(S) Consider the system whose block diagram is shown above. Use the s...

A: According to the question, for the given diagram as shown below we need to find the transfer functi...

Q: R2 4 Ohm DI D2 Iş R1 5 A 2 Ohm 4i2 211

Q: (b) A loss and charge method is one of the well-known methods for high resistance measurement. Descr...

Q: 1. Solve the following resistance problems: a. A 4.2 cm long copper wire has a cross-sectional area ...

A: Brief description: Resistor is a passive element which is used in the electrical circuit for the th...

Q: The role of air traffic control systems is increasing as airplane traffic increases at busy airports...

A: Global Positioning System (GPS) - The Navstar Global Positioning System is the official name for the...

Q: A single phase alternator gives 250 A at 1200 volts. What is the output of the machine in kVA?

Q: ependen deper :SISA n the circuit given below, R= 4 Q. Find vo and io R 12 2Ω is

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with po...

Q: A 25 kVA alternator has a total loss of 2,000 watts when it delivers rated kVA to a load at a power ...

A: In this answer we will try to find the efficiency of the alternator as explained below.

Q: A resistance of 10 52 and an unknown inductance are connected in parallel to a T10- Vac, variable fr...

A: The resistance/impedance stays constant, changes in the potential difference (Voltage) influence the...

Q: 1. Find the total Capacitance in the circuit.

A: If the capacitors are connected in parallel then we can add it or if the capacitors are connected in...

Q: 6. A 4.2 µC charge is measured to have an electric field of 1.5 x 10° N/C at 3.7 cm. What is the ele...

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the other question...

Q: An AM signal with expression x ()-10 1+, cos 1000r cos 10'r is demodulated with an 16 envelope detec...

Q: If a communication bandwidth of Bc= 20,000 Hz is available how many bits, n, per signal clement are ...

A: The bit rate and the bandwidth of the signal are known. For the perfect noiseless channel, the bit ...

Q: Given a 50 Ω resistor with a tolerance of 10%, what is the minimum andmaximum voltage across the res...

A: The tolerance of the given resistance of 50 Ω is known, the maximum and the minimum values of the r...

Q: 15. a. Find the Thévenin equivalent circuit for the portions of the network of Fig. 9.139 O external...

A: Brief description : In case of electrical circuits any complex circuit can be reduced into simplifie...

Q: 1)A schematic of an absorption curve is shown to the right for an indirect band-gap semiconductor. F...

A: Because direct band-gap semiconductors do not involve lattice vibration in electron band-to-band tra...

Q: R= 10e R=22 Ro-24 %3D loor Rz 2e G. Is - 7 Is- 8. I7- 9. I ls - 1o. Il- 1. RTOTAL- 2. ITOTAL - 6. b ...

Q: 20Ω Μ 30Ω

Q: 12.13 A 74178 shift register is described by the given table. All state changes occur on the 1-0 tra...

Q: Estimate the kwh electrical billing of a household with the following average electrical consumption...

Q: A series circuit connected across a 100-Vac source consists of a 10-2 resistor, a 5-2 capacitor, and...

Q: (b) The switch in the DC circuit of Figure 2(b) has been in position a for a long time. At time t = ...

A: Brief description: Transient analysis is only applicable for those networks where network consists ...

Q: 1. Determine Av, Zi, Zout, and Vout if Vin = 2mV and RL=4.7kn %3D Vec 12V 470kn R 10F C 10uF B-100 V...

A: Brief description: In the above given question they have mentioned a NPN transistor circuit. For th...

Q: A two-pole ac generator is running at 1500 rpm. Find the frequency and angular velocity.

A: Consider the formula for the frequency is, f=NP120 Here, N is the speed and P is the number of pole.

Q: Q2 (a) Differentiate between analog and digital oscilloscopes in terms of their mode of operation.

A: We need to differentiate between analog and digital oscilloscopes in terms of their mode of operatio...

Q: Fill in the blanks / Tuenti volts Given the circuit below, calculate the voltage drop across R1 when...

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

A short circuit test was performed upon a 10-kVA, 2300/230-volt transformer with
the following results: Esc = 137 volts; Psc = 192 W; Isc = 4.34 A. Calculate in primary
terms the reactance of the transformer.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the purpose of a transformer? Draw the symbols for a transformer.
An open-delta three-phase transformer system has one transformer center-tapped to provide a neutral for single-phase voltages. If the voltage from line to center tap is 277 V, what is the high-leg voltage?
A 25-kVA, 4000/400-V, 60-Hz transformerhas the following parameters: RH =18 Ω, XH = 25 Ω, RL = 180 mΩ, XL = 250m Ω, RCH =15 kΩ, and XMH = 25 kΩ. If the open-circuit and short-circuit tests areperformed on this transformer, what are thereadings of the instruments in each case?
A 4.2-kVA, 237 / 164 -volt distribution transformer has the following equivalent resistance and leakage-reactance values referred to the primary: rep = 1.5 ohm; xep = 8.5 ohms. If this transformer is operating at full-load unity power factor, what will be the percent voltage regulation of this transformer?
A 4.6-kVA, 308 / 155 -volt distribution transformer has the following equivalent resistance and leakage-reactance values referred to the primary: rep = 1.5 ohm; xep = 7.5 ohms. The core losses of this transformer amount to 500 watts. If this transformer is operating at full-load unity power factor, what is its percent efficiency?
A 1.3-kVA, 408 / 129 -volt distribution transformer has the following equivalent resistance and leakage-reactance values referred to the primary: rep = 1.7 ohm; xep = 7.3 ohms. This transformer has core losses of 400 watts. If this transformer is operating at full-load with 0.52 power factor lagging, what is its percent efficiency at this loading?
A 10-kVA, 2200/400 V, single phase distribution transformer has a primary and secondary winding impedances of 5 + j12 and 0.25 + j0.45 ohms, respectively. Calculate the voltage across the secondary terminals at full load, 90 % power factor lagging, when the primary is supplied with 2200 volts?
A transformer takes a current of 0.8A when its primary is connected to a 240 volt, 50 Hzsupply,the secondary being on open circuit. If the power absorbed is 72 watts, determine (i) the ironloss current, (ii) the power factor on no-load, and (iii) the magnetising current.
A 10-kVA, 200-V/400-V, 50-Hz, single-phase transformer gave the following test results : OC test (HV winding open) : 200 V, 1.3 A, 120 W. SC test (LV winding shorted) : 22 V, 30 A, 200 W. Calculate (a) the magnetizing current, and (b) the equivalent resistance and leakage reactance as referred to the low voltage side.
A 400-k VA, 2300 230, 60-hz transformer supplies a 0.8 lagging power-factor load whose KVA Is adjustable from no load to 120 percent rated KVA. The percent resistance, percent reactance, and percent core loss are 56, 3.16, and 0.42 respectively. For 2 KVA increments of load, tabulate and plot the efficiency of the transformer from no load to 120 percent rated load. Please state the formulas clearly
A single-phase, 10-kVA, 480/120-V transformer is to be used as an autotransformer tying a 600-V distribution line to a 480-V load. When it is tested as a conventional transformer, the following values are measured on the primary (480-V) side of the transformer: Find the per-unit equivalent circuit of this transformer when it is connected in a conventional manner. What is the efficiency of the transformer at rated conditions and unity power factor? What is the voltage regulation at those conditions?
How does a transformer function in a power system, and what are its key types?