A resistance of 10 Q and an unknown inductance are connected in parallel to a 110- Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.

A resistance of 10 Q and an unknown inductance are connected in parallel to a 110- Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: 6. A 4.2 µC charge is measured to have an electric field of 1.5 x 10° N/C at 3.7 cm. What is the ele...

A: As you have mentioned to solve question 9 So the solution of question 9 is given below

Q: In the circuit shown in the figure below, if the continuous resistance of the coil is 45 ohms and th...

Q: 2. An inductance of 1 henry and a resistance of 1 ohm are connected in series with a constant e.m.f....

Q: The JFET in the circuit in Figure 4 has Vp = -4V and 12m A Ipss . Determine all the voltages and cur...

A: The solution is given below...

Q: 5. Find the branch currents Ii, I2 and I3 using mesh analysis. 6Ω 13 10 Ω 15 V iz 10 V ww

A: Circuit is given as:

Q: Q.2 (a) (i) If the power supply voltage to the Wheatstone bridge in Figure Q.2a(i) increased, what w...

Q: tain the trigonometric Fourier series representation of f(t).

Q: A single-phase 22KVA, 2200 V/220 V, 50 Hz, distribution transformer is to be connected as an auto tr...

A: Here, we have a single phase transformer. For which the input voltage is 2200 V and the output volt...

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with po...

A: The solution is given below

Q: 2. A voltage waveform, v(t) = 200 V sin ( 250 rad/s t ), is connected across a series combination co...

A: In this question series RL circuit is given...We have to find out total impedance , source current ,...

Q: A single phase synchronous generator was open-circuit and short-circuit tested. During an open circu...

Q: 2 μΗ 1 μΗ 3 μΗ LT= 5 μ 3 μΗ 6 μΗ 10 μΗ L. 1 μΗ

Q: Q.1. For the following circuit, Vg=40sin (1000t) V. Calculate a) The voltage Vo b) The real power su...

Q: A balanced Y-connected source is connected to a A-connected balanced load. The phase voltage of the ...

Q: (Ъ) An ammeter shown in Figure Q.1b(i) with full scale current of PMMC is 100 µA and internal resist...

A: The solution is given below

Q: Problem 1. A Darlington Transistor is composed of two NPN transistors. Given transistor Ql's gain B1...

Q: A 110 MVA, 13.8 kV, three phase alternator will have a per phase nominal impedance of

Q: A 3-0 overhead Transmission line having conductor radius of 0.74 cm, are placed at the corner of an ...

Q: 20. There are three resistors, R1,R2 and R3, connected in parallel in which the battery source is 30...

A: Given, There are three resistors R1, R2 and R3 connected in parallel The battery source is, E = 30 V

Q: The synchronous reactance of a generator is 1.0 per unit, and the leakage reactance of its armature ...

Q: Ex. 1618. See Fig. 1618. Zener.D4=1.8 v, R3=1.6 kOhms, R4=5.9 kOhms, and R5=1.60 Ohms. Assume ideal-...

Q: Using node-voltage analysis, mesh-current analysis, or superposition, find the current i across the ...

A: The nodal analysis and mesh analysis can be obtained by using kirchhoff's voltage and current law in...

Q: Why is it important to follow the rule. Do not wear loose clothing or ties near electrical equipment...

Q: what are the draw back of using DTOC relays for the protection of long feeders?

A: Relay: The main work of relay is used to detect the fault and send the signal to the circuit breaker...

Q: R2 10 ka R1 10 ka 12 R3 V2 5V V1 MESH 1 10 V 1 ka MESH 2 A. Determine current 12, across the resisto...

A: A.determine current I2 in terms ofI1,R2,R3 B.current I1,I2

Q: R(s) + 2 s+3 C(s) 4s 3.

A: Solve the above questions

Q: (b) For the following set of voltages, Va= 208sin(@t + 27°) V= 208sin(@t + 147°) V. = 208sin(@t – 93...

A: Phasor is a vector with phase Use this to analyse the given phasors As the phase continuously change...

Q: coil with resistance of 10 ohms and an inductance of 15 mH is connected in series to the parallel co...

Q: Make sketches showing how 18 1.5 dry cells n

Q: (c) A balanced Y-connected load with a phase resistance of 12 2 series with reactance of 15Q is supp...

Q: Find Req at terminals (c, d). 3Ω 5Ω a o 6 Ω 362 3Ω -od bo

A: Here, we have given an electrical network where, no. of resistors are connected in series and parall...

Q: 1)A schematic of an absorption curve is shown to the right for an indirect band-gap semiconductor. F...

A: Because direct band-gap semiconductors do not involve lattice vibration in electron band-to-band tra...

Q: A delta connection three phase motor load is supplied from 400v, three phase , 50 hz supply system. ...

A: An AC motor is an electrical machine which takes AC electrical input energy and produces mechanical ...

Q: Q1- For the circuit of Figure below: a) Determine Thevenin equivalent circuit at the output terminal...

A: We need to find out Thevenin equivalent theorem, and R value for maximum power transfer and value of...

Q: Solve the following problems. Use 3 decimal places. Copy the problems. 1. A silver wire has a resist...

A: 1) The resistance of the silver is given as: Rs=ρslsπds2 The resistance of the manganin is given as:...

Q: The circuit Gn be draun as, R is 102 26MH VIH) = 200V gin (250 t)

A: Resistance, R = 10 Ω Inductance, L = 25 mH Angular frequency, ω = 250 rad/s Supply Voltage, V = 2002...

Q: Find the output voltage of the zener diode. When a zener diode is forward bias, it acts as an ordina...

Q: Find the following phasors. אלל jue J.1 Vt 2.1 Vz 23 13

Q: 5. Find the unknown currents in the curcuits shown in Fig. 2.40 (a). DC Network Theorems 4A 8A SA 5A...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: hysteresis curve

A: Hysteresis loop- A hysteresis loop (also known as a hysteresis curve) is a graph which is defined in...

Q: 2. A 15 - kg body falls from rest (assuming / after it false 10 m. no friction). Determine its veloc...

Q: R=22 R= 10e Ro 2a { R = 10 %3D loor = Rz 2e Is - 7 Is - 8. I7- 9. Ilo - l6. Ill- 1 RponAL- 2. ITOTAL...

Q: (b) A star-connected three-phase load absorb 3000 W with power factor 0.433 lagging has a resistance...

Q: Determine the gain of a radiator with a transmitted power of 240 Watts. The field intensity at 42m i...

A: Determine the gain of the radiator with a transmitted power of 240 watts. The field intensity at 42 ...

Q: Two wattmeters connected to a three-phase 440V squirrel cage induction motor indicate a total of 12k...

Q: Draw the n-p-n silicon bipolar junction transistor at zero bias and also in forward active mode with...

Q: 8. An electric field of 0.151 N/C passes through a vector of 3.1 cm? . Calculate area the electric f...

A: Given Electric field , E = 0.151 N/C area, A = 3.1 cm2 Electric Flux = ?

Q: Show that tthe Tf of tVe Feed Back connec tion is ) ycs) G (5) 1- HIS) G(S)

A: In this question we will find transfer function of positive feedback system....

Q: T QF D Q A B CLK

A: Given the circuit, as shown below: We need to construct the complete state diagram for the Finite S...

Q: Which of the following will be the per-phase load impedance for a Y-connected load, if a three-phase...

Question

A resistance of 10 Q and an unknown inductance are connected in parallel to a 110-
Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by
the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A resistance of 20 ohms and an unknown capacitance are connected in parallel to a 110-Vac, variable frequency source. When the frequency is 60 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.
A resistance of 10 Ω and an unknown inductance are connected in parallel to a 110-Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A
A 150V moving iron volt meter intended for 50Hz has an inductance of 0.7H and a resistance of 3K ohm. Find the series resistance required to extend the range of instrument to 300V if this 300V - 50Hz instrument used to measure dc voltage find the dc voltage when the scale reading is 200V
What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?
An inductance of 2 henries and a resistance of20 ohms are connected in series with an emfof E volts. If the current is zero at time, t = 0,find the current at the end of 0.01 sec if E =100sin150t volts.
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
A circuit contains series combination of a resistance of value 10 ohm, an inductance of value 40 mH and a capacitance of value 20 microfara. What will be the value of the impedance of of the circuit at a frequency of 100 kHz?
In one carried out at the Electricity Laboratory, a group of students assembled the circuit outlined in the figure below: In this regard, answer the following: (a) What is the voltage across the capacitor terminals B and C? (b) What is the voltage between terminals A and D?
Explain the basic concepts of direct current and alternating current, and the main applications that each one has today, explain it with exercises with formulas.