A shunt generator supplies a 32kW load at 215V through cables of resistance, R = 118m2. If the field winding resistance, Rf =542 and the armature resistance, Ra =42m2. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,

A shunt generator supplies a 32kW load at 215V through cables of resistance, R = 118m2. If the field winding resistance, Rf =542 and the armature resistance, Ra =42m2. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Related questions

Q: Two similar 6,600-V, three phase generators are running in parallel on constant-voltage and…

Q: (a) A short shunt cumulative compound dc generator supplies 4kW at 220V. The Shunt field resistance,…

A: Find the induced emf of the DC short shunt commulative type generator.

Q: Draw voltage phasor diagrams for different load cases of salient pole synchronous generators and…

A: Here it is asking to draw the voltage phasor diagrams for different load cases of salient pole…

Q: How many poles should a 60-Hz generator have, if it is connected to a turbine operating under a…

Q: A lap wound dc generator having 50slots with 15conductors per slot generated at no led emf of 400v…

A: The detailed solution is attached with.

Q: Damping factor and the undamped natural frequency for the position control system is given by....?

A: The characteristics equation of the position control system is expressed as:

Q: An 8-pole lap-connected d.c. shunt generator delivers an output of 240A at 500V. The armature has…

A: No. of poles (P) = 8 Armature current (Ia) = 240 A No. of armature conductors (Z) = 1408 No. of…

Q: A Dc shunt generator has the following O.C.C. at 800 r p m Field current (A) 1 1.5 2 0.5 2.5 3 3.5…

A: Given: A DC shunt generator has Speed, N=800 rpm Armature resistance, Ra=0.1 Ω Shunt field…

Q: Consider the two-bus power system shown in Figure P6.2. The marginal cost of production of the…

A: Since you have asked more than one question, I will answer the first question and all its subparts.…

Q: With increasing load current, the output voltage of a separately-excited DC generator falls, which…

A: The separately-excited DC generator the field winding can be excited by an external source. This…

Q: What are the various losses in an induction motor? On what actors do they depend?

A: Following are the various losses in an induction motor a) Core loss b) Stator conductor loss c)…

Q: A shunt generator supplies a 28kW load at 220V through cables of resistance, R = 114mQ. If the field…

A: Solve as below

Q: Briefly explain the impact of self-induced emf in a DC generator? What techniques are employed to…

A: The main impact of self induced emf in the armature of a dc generator is ,the flux produced by this…

Q: Between a separately-excited and a self-excited DC generator, which is simpler to construct and why?

Q: a dc shunt generator supplies a load of 10kW at 250V calculate the induced emf,if the armature…

A: DC Generator: DC Generator is an electrical device which converts mechanical input energy into…

Q: 1- Prove from the first principles an expression for the generated EMF at the armature of DC…

Q: A 4-quadrant DC chopper with bipolar switching operating at a switching frequency of 2kHz, is…

A: Given R=2 ohm Edc =120 V Eb=50 V

Q: A shunt generator supplies a 24kW load at 230V through cables of resistance, R = 106mo. If the field…

Q: Find the maximum efficiency of shunt generator has the armature resistance and shunt resistance 0.08…

A: Given Ra=0.08 Ω Rsh=120 Ω Wr=800 W VT=250 V

Q: A shunt generator supplies a 33kW load at 210V through cables of resistance, R = %3D 122m2. If the…

Q: A shunt generator supplies a 36kW load at 200v through cables of resistance, R = 100mN. If the field…

Q: Calculate the field copper loss at no -load and rated voltage for CW rotation of the armature and…

Q: The armature reaction of the DC generator reduces the generated EMF. Select one: O True False

A: Choose the correct option The given statement The armature reaction of the DC Generator reduce the…

Q: Find the number of commutator segments required in a 6-pole dc machine having s simple wave-wound…

Q: shunt generator supplies a 24kW load at 200V through cables of resistance, R = 110mΩ. If the field…

Q: A shunt generator supplies a 32kW load at 230V through cables of resistance, R = 110mQ. If the field…

A: A DC Shunt generator 32kW load, supplied at voltage 230V Cable resistance R= 1ohm Armature…

Q: (a) A short shunt cumulative compound dc generator supplies 8kW at 235V. The Shunt field resistance,…

A: In this question we need to find a Induced EMF and load resistance of a short shunt compund genrator

Q: 11 What is the dq component - Park transform The effective stator field current is I, = and the…

A: The direction of the direct-axis current is along the direction of the rotor magnetic field and the…

Q: (a) Draw the combined space and time phasor diagram for a cylindrical rotor alternator with armature…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A DC shunt generator supplies a load of 27 kW at 210 V through the cables of resistance, R = 126 mΩ.…

Q: What is the current

Q: 4) A 40-kW induction motor, with a lagging power factor of 0.76 is supplied by a 120-Vrms, 60-Hz…

Q: A phase control circuit is mainly composed of a TRIAC in series with the load resistance, RL,…

A: Triac: It is a three terminal semiconductor device and is a current control device. this is…

Q: A shunt generator supplies a 20kW load at 200V through cables of resistance, R= 100mΩ. If the field…

A: Dc shunt Generator

Q: An engineer is designing 4-pole DC generator with 30 conductors by using simplex two-layer wave-…

Q: A 1200 kVA, 6600 volts, three-phase wye connected alternator, has an effective resistance of 2.5…

A: The solution is given below

Q: A 10 pole wave wound shunt generator delivers 178 A at a terminal voltage of 236 V. Ra and Rsh are…

A: For generator Armature current = Load current +shunt field current. Generated voltage =Terminal…

Q: A Dc shunt generator has the following O.C.C. at 800 r pm Field current (A) 0.5 1 1.5 2 2.5 3 2 3.5…

A: Given: A DC shunt generator has Speed, N=800 rpm Armature resistance, Ra=0.1 Ω Shunt field…

Q: A shunt generator supplies a 33kW load at 225V through cables of resistance, R = 100mΩ. If the…

Q: In a DC motor with separately excited configuration, EMF voltage=8xrotational speed of the rotor (or…

A: Given data: Resistance and the inductance of the armature are 10 Ohms and 500 mH.

Q: A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 122mΩ. If the…

A: In this question we need to find a terminal Voltage and internal emf genrated by Shunt Genrator.

Q: A shunt generator supplies a 32kW load at 220V through cables of resistance, R = 128mΩ. If the…

A: A shunt generator supplies 32kW load at 220V through cables of resistance, Cable resistance R =…

Q: A short shunt compound generator supplies a load of 10 kW at 200 V through a pair of feeder and…

A: A self-excited motor made up of both series and shunt field coils linked to the armature winding is…

Q: A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 104m2. If the field…

Q: Draw voltage phasor diagrams for different load cases of salient synchronous generators and derive…

A: Synchronous generators are used for power generation. The power factor shows the phase relation…

Question

A shunt generator supplies a 32kW load at 215V
through cables of resistance, R= 118m2. If the field
winding resistance, Rf =542 and the armature
resistance, Ra =42m2.
Determine the following below:
The terminal voltage is,
The e.m.f. generated in the armature is,

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A small manufacturing plant is located 2 km down a transmission line, which has a series reactance of 0.5/km. The line resistance is negligible. The line voltage at the plant is 4800V(rms). and the plant consumes 120kW at 0.85 power factor lagging. Determine the voltage and power factor at the sending end of the transmission line by using (a) a complex power approach and (b) a circuit analysis approach.
Consider a three-phase generator rated 300MVA,23kV, supplying a system load of 240 MA and 0.9 power factor lagging at 230 kV through a 330MVA,23/230Y-kV step-up transformer with a leakage reactance of 0.11 per unit. (a) Neglecting the exciting current and choosing base values at the load of 100 MVL and 230 kV. Find the phasor currents IA,IB, and IC supplied to the load in per unit. (b) By choosing the load terminal voltage IA as reference, specify the proper base for the generator circuit and determine the generator voltage V as well as the phasor currents IA,IB, and IC, from the generator. (Note: Take into account the phase shift of the transformer.) (C) Find the generator terminal voltage in kV and the real power supplied by the generator in MW. (d) By omitting the transformer phase shift altogether, check to see whether you get the same magnitude of generator terminal voltage and real power delivered by the generator.
An AC generator having an internal resistance of 2 ?? is connected to an LCR circuit in series as shown in the figure. If the generator supplies an electromotive force, ? = 282 ??? (100??) volt, calculate:a) the impedance of the circuitb) the rms value of the current in the circuitc) the voltage drop across L, C and R
Explain the importance of load flow analysis in power systems. How does it help in optimizing the operation of electrical grids?
Derive emf equation of the synchronous generator.
What is the need to conduct power flow analysis? Discuss about data needed and bus types too.
A 200 bus power system has 160 PQ bus. For achieving a load flow solution by N-R in polar coordinates, the minimum number of simultaneous equation to be solved is
What are FACTS (Flexible AC Transmission Systems) devices, and how do they enhance power system stability and control?
At the end of the 8 km overhead line given in the figure below, there are two distribution transformers, one of which is 800kVA and the other is 1200kVA, operated with power coefficients of 0.6 and 0.8, respectively. The end-of-line voltage is 6kV. Find the required rated cross section and line head voltage so that the power loss on the line is less than %pk = 10.
Discuss about Generator modeling in transient stability and derive the formula for the real and reactive power supplied by it.
What is the significance of load flow analysis in power systems, and how is it conducted?
An area of an interconnected power system has two fossil-fuel operating on economic dispatch. The variable operating costs of these units are given by in image Determine the power output of each units, the incremental operating cost, and the total operating cost that minimizes when total load demand is 250, 500, 750, 1000 and 1250 MW, transmission losses is neglecting?