A signal can be conditioned using various signal conditioning methods such as amplification, attenuation, and filtration. Consider an electrical heater, where in order to measure its voltage using the digital voltmeter, it must first be attenuated using a voltage divider. The voltage to power the electrical heater is equal to the last 3 digit of your matric no., rounded to the nearest tenth (e.g., if your matric no. is 201060020-5, the last 3 digit of your matric no. is 20-5, then the voltage is 210 V). The digital voltmeter used here has a maximum scale of 20 V.

Q: Three capacitors C1 C2 and C3 whose values are 10 µF. 5 µF. and 2 µF respectively, have breakdown vo...

A: This question belongs to circuit theory . It is about breakdown voltages of the capacitors when capa...

Q: calculate the poles and zeros of the system Draw the pole-zero map Determine the stability o

A: Gs=s+3s(s+2)no of poles = 0, -2no of zeroes = -3  

Q: A short circuit test was performed on a 20 kVA, 2000/200 V single-phase transformer, with the second...

A: Given data : Power loss in copper Pcu= 300 W Irated=20,00200=10A V=100V

Q: 2.26. Using only the Fourier transform of the unit im- pulse function and appropriate transform theo...

A:

Q: What value of capacitance is required to produce 50 2 of reactance at 450 MHz?

A: To solve above problem, one should know how to find equivalent capacitance for series and parallel c...

Q: 8Ω A2 A 4Ω 10Ω 12 VA

A: Given Super position theorm:The response produced at an element when all the sources are present is...

Q: A source delivers an AC voltage of the form AV = 198 sin( 51 nt), where AV is in volts and t is in s...

A:  

Q: Describe the C-V characteristics of a MOS capacitor and explain the physics behind them.

A: Note: We are authorized to answer one question at a time since you have not mentioned which question...

Q: In an Alternating Current Electricity with a voltage source rated 230 volts, 3 electrical appliances...

A: DC is not the only "type" of electricity in use, despite how convenient and simple it is. Certain en...

Q: 1. A small wire or device inside a piece of electrical equipment that breaks and stops current if th...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Is 0.2 2 1.8 Ω I'R m IM 0.32 VS(LN) 250 2 40 Q S Given the above approximate equivalent circuit for ...

A: The solution is given below 

Q: Consider a p+n Si diode with Na = 1018 cm−3 and Nd = 1016 cm−3. The hole diffusion coefficient in th...

A: Step 1:Calculating the reverse saturation current as-Is=qADpPnLpWhere,Pn=ni2Nd=2.25×10201016=2.25×10...

Q: a. For the circuit shown below, load resistance is 180 ohm, determine load voltage, the resistance V...

A:

Q: Problem 3. Solve the following simultaneous equations using determinants: 3x – 4y = 12 7x +5y = 6.5

A: Given data : 3x-4y=127x+5y=6.5

Q: a) An electron with velocity u = (15x + 60ỹ – 202) x 105 [m/s] experiences no net force at a point i...

A:

Q: Two equal valued resistors dissipate a power of 100W. The resistors are connected in? choices seri...

A: Given: Two equal valued resistors dissipate a power of 100W. Then The resistors are connected in?

Q: 5. The circuit shown in Fig. Pl.5 is a combination of devices, with the voltages and currents as ind...

A:

Q: Question 2 Use mesh analysis to find the mesh currents in the circuit given in Figure 2 Hint: Apply ...

A: Here we have given a circuit, which consists of no. of resistors, voltage source and current source....

Q: A smart green house was designed with an embedded digital air quality sensors, which can produce a r...

A:

Q: + V - - V2 R, = 1.2 kN /3 R, = 2.2 kN + E1 20 V V3 Ez 10 V 3.3 kN FIG. 14.1 (b) Using branch-current...

A: We can use Kirchoff's current law to find branch current.  We will consider node voltage V and after...

Q: With suitable sketch ,explain in detail the calibration procedure of differential pressure transmitt...

A: Differential Pressure Transmitter- Differential pressure transmitter is a device which is used measu...

Q: (b) Figure Q.2b shows an RL circuit uses as a filter where v(t) as the input voltage and i(t) is the...

A:

Q: 4. AB + B'C +ABCD 5. 2 A+BD • BCD ge 6. xAA+B)

A: Note: As per our company guidelines we are supposed to answer only first 3 sub-parts (i.e. 4, 5, 6) ...

Q: ten voice signals each bandlimited to 3khz are to be FDM with 1khz guardbands between channels the s...

A: Given- Ten voice signals each bandlimited to 3KHzfc1=0.7KHz Baseband bandwidth=10×fm=10×3KHz=30KHzSu...

Q: 2. Find the Laplace transform of the following function using the properties and table of laplace

A: Wrte the properties of the Laplace transform. Multiplication by t. Lt f(t) ⟷ −d F(s)ds Time shifting...

Q: Determine if the DIODE is forward bias or reverse bias And approximate the output voltage Vo Determi...

A: In this question,  Given the circuit,  Check which diode is forward bias and which is reverse bias. ...

Q: 1. Determine Vo for each of the circuit shown below 22 ka Si SV 10 V 1.2 ka 4.7 ka -10 V (a) (b)

A: The solution is given below 

Q: decimal points. Enclosed your final answer into boxes. 1.Draw the DC equivalent circuit. 2.Draw the ...

A:

Q: A solid insulating sphere of radius 20 cm carries a net positive charge Q 10 µC uniformly distribute...

A:

Q: Plot the Q-point of the circuit below. At а. Beta = 90 %3D b. Beta = 150 с. Beta = 250 16V R1 3.9k R...

A: Brief description :  Bipolar junction transistor are having three terminals such as base, emitter an...

Q: A DC compound motor has shunt field resistance of 5002 and series field resistance of 22. Shunt fiel...

A: Shunt field resistance of the motor (Rsh) = 500 Ω Series field resistance (Rse) = 2 Ω Shunt field cu...

Q: Explain the differences between metals, polymers and ceramics in terms of its atomic structure and t...

A:

Q: 6. Determine İolt) in the RLC circuit 1 H 4 cos 2t A 1Ω 1F

A: Given circuit is :

Q: 59. Which of the following is the most probable impedance of a 100MW alternator? а. 5% b. 100% с. 10...

A: An alternator is an electrical generator that converts mechanical energy into alternating current el...

Q: 2.26. Using only the Fourier transform of the unit im- pulse function and appropriate transform theo...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: Using 8-bit 2's compliment number, add 14 and -29 together, then verify the result.

A: First convert the 14 and -29 into the 8 bit binary form obtain the 2's completement of the -29 perfo...

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...

A: Given: Maximum amplitude of sinusoidal voltage, Vm=680 V Load resistance, R=65 Ω  

Q: Find the general solution: (x - y) da + rydy 0 O none of the choices given +c=0 2x2 In x+ +c=0 2x2 I...

A:

Q: Your team is working on a new walkie-talkie design that must be able to withstand harsh weather cond...

A: METALS - Lets see their properties first . They are malleable. It means they can be worked with easi...

Q: Given R = 22, use nodal analysis to compute the node voltage V4 (in Volts).

A:

Q: Determine all the currents and voltages for the circuit in Fig.6.8. R, R2 60 R,40 R30 E -16.8 V R.60...

A: Brief description : In the above given question they have mentioned an electrical circuit which cons...

Q: Simplify this boolean expression to only NAND gate. F(A,B,C,D)= A’B’C’D’ + BC’D + A’C’D + A’BCD + A...

A: Rewrite the given expression ((A'B'C'D')+(A'C'D))+(BC'D)+(A'BCD)+(ACD')=((D+(B'D'))A'C')+(BC'D)+(A'B...

Q: A balanced 3 phase star connected load draws power from a 420 V supply. Two wattmeter's indicate 400...

A: GIVEN: V= 420V              W1=4000W              W2=800W FIND: (1) The input power P            (2)...

Q: VCC +3 V Rc RB 1.8 k. 33 kN BpC = 90

A: Collector to Base Bias circuit The supply to the base terminal is given from the collector terminal ...

Q: Consider the sinusoids x1[n] = 2 sin(πn +2π/3)  ,x2[n] = 3 cos(3πn + 3π/2) −∞ < n < ∞, From their f...

A: This question belongs to signal and system . It is about calculation of time period of discrete sign...

Q: A single-phase, 50 Hz, overhead transmission line supplies 1300 kW at 30 kV, 0.65 p.f. lagging. The ...

A: Given    Overhead transmission line Frequency f=50 Hzload power PL=1300 kwload voltage VL=30 kvpower...

Q: Two 30-ohm resistors are connected in series. They are then connected across a 115-volt supply. What...

A: Here, we have given a situation that two resistors are connected in series.  And, a voltage supply o...

Q: c) An electric potential is expressed as V = 2xy2(z – 3) [V]. Find the followings: the expression of...

A: Electric field E= - gradient (electric potential).  Volume charge density = divergence (electric flu...

Q: in time domain using convulution. No laplace.  how do I do the convulution of.   x(t) = e^-tu(t)  ...

A: Since, both the functions are causal, the output y(t) is   

Q: In a three – phase system with balanced loads, total power using one wattmeter method is given by - ...

A: A circuit of power measurement using three wattmeter method is shown

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.