A simple pendulum is made of a 50 cm-string and a bob of mass m. At t =0, the pendulum is at its equilibrium position and is given an initial velocity v = 0.1 m/s. The maximum angular speed, O'max, is: 08 rad/s 0.4rad/s 0.05rad/s 0.2 rad/s O 01 rad/s

A simple pendulum is made of a 50 cm-string and a bob of mass m. At t =0, the pendulum is at its equilibrium position and is given an initial velocity v = 0.1 m/s. The maximum angular speed, O'max, is: 08 rad/s 0.4rad/s 0.05rad/s 0.2 rad/s O 01 rad/s

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter13: Rotation Ii: A Conservation Approach

Section: Chapter Questions

Problem 58PQ

See similar textbooks

Similar questions

Figure P10.16 shows the drive train of a bicycle that has wheels 67.3 cm in diameter and pedal cranks 17.5 cm long. The cyclist pedals at a steady cadence of 76.0 rev/min. The chain engages with a front sprocket 15.2 cm in diameter and a rear sprocket 7.00 cm in diameter. Calculate (a) the speed of a link of the chain relative to the bicycle frame, (b) the angular speed of the bicycle wheels, and (c) the speed of the bicycle relative to the road. (d) What pieces of data, if any, are not necessary for the calculations? Figure P10.16
A nylon siring has mass 5.50 g and length L = 86.0 cm. The lower end is tied to the floor, and the upper end is tied to a small set of wheels through a slot in a track on which the wheels move (Fig. P18.76). The wheels have a mass that is negligible compared with that of the siring, and they roll without friction on the track so that the upper end of the string is essentially free. Figure P18.76 At equilibrium, the string is vertical and motionless. When it is carrying a small-amplilude wave, you may assume the string is always under uniform tension 1.30 N. (a) Find the speed of transverse waves on the siring, (b) The string's vibration possibilities are a set of standing-wave states, each with a node at the fixed bottom end and an antinode at the free top end. Find the node-antinode distances for each of the three simplest states, (c) Find the frequency of each of these states.
Review. A string is wound around a uniform disk of radius R and mass M. The disk is released from rest with the string vertical and its top end tied to a fixed bar (Fig. P10.78). Show that (a) the tension in the string is one third of the weight of the disk, (b) the magnitude of the acceleration of the center of mass is 2g/3, and (c) the speed of the center of mass is (4gh/3)1/2 after the disk has descended through distance h. (d) Verify your answer to part (c) using the energy approach. Figure P10.78
A pendulum consists of a rod of mass 2 kg and length 1 m with a solid sphere at one end with mass 0.3 kg and radius 20 cm (see the following figure). If the pendulum is released from rest at an angle of 30 , what is the angular velocity at the lowest point?
A uniform solid sphere of mass m and radius r is releasedfrom rest and rolls without slipping on a semicircular ramp ofradius R r (Fig. P13.76). Ifthe initial position of the sphereis at an angle to the vertical,what is its speed at the bottomof the ramp? FIGURE P13.76
Figure P10.18 shows the drive train of a bicycle that has wheels 67.3 cm in diameter and pedal cranks 17.5 cm long. The cyclist pedals at a steady cadence of 76.0 rev/min. The chain engages with a from sprocket 15.2 cm in diameter and a rear sprocket 7.00 cm in diameter. Calculate (a) the speed of a link of the chain relative to the bicycle frame, (b) the angular speed of the bicycle wheels, and (c) the speed of the bicycle relative to the road, (d) What pieces of data, if any, are not necessary for the calculations?
A smaller disk of radius r and mass m is attached rigidly to the face of a second larger disk of radius R and mass M as shown in Figure P15.48. The center of the small disk is located at the edge of the large disk. The large disk is mounted at its center on a frictionless axle. The assembly is rotated through a small angle from its equilibrium position and released. (a) Show that the speed of the center of the small disk as it passes through the equilibrium position is v=2[Rg(1cos)(M/m)+(r/R)2+2]1/2 (b) Show that the period of the motion is v=2[(M/2m)+R2+mr22mgR]1/2 Figure P15.48
The angular momentum vector of a precessing gyroscope sweeps out a cone as shown in Figure P11.31. The angular speed of the tip of the angular momentum vector, called its precessional frequency, is given by p=/I, where is the magnitude of the torque on the gyroscope and L is the magnitude of its angular momentum. In the motion called precession of the equinoxes, the Earths axis of rotation processes about the perpendicular to its orbital plane with a period of 2.58 104 yr. Model the Earth as a uniform sphere and calculate the torque on the Earth that is causing this precession. Figure P11.31 A precessing angular momentum vector sweeps out a cone in space.
A thin, spherical shell of mass m and radius R rolls down aparabolic path PQR from height H without slipping (assumeR H) as shown in Figure P13.65. Path PQ is rough (and sothe shell will roll on that path), whereas path QR is smooth, orfrictionless (so the shell will only slide, not roll, in this region).Determine the height h above point Q reached by the shell onpath QR. FIGURE P13.65
In Figure P10.40, the hanging object has a mass of m1 = 0.420 kg; the sliding block has a mass of m2 = 0.850 kg; and the pulley is a hollow cylinder with a mass of M = 0.350 kg, an inner radius of R1 = 0.020 0 m, and an outer radius of R2 = 0.030 0 m. Assume the mass of the spokes is negligible. The coefficient of kinetic friction between the block and the horizontal surface is k = 0.250. The pulley turns without friction on its axle. The light cord does not stretch and does not slip on the pulley. The block has a velocity of vi = 0.820 m/s toward the pulley when it passes a reference point on the table. (a) Use energy methods to predict its speed after it has moved to a second point, 0.700 m away. (b) Find the angular speed of the pulley at the same moment. Figure P10.40
A simple pendulum is made of a 50 cm-string and a bob of mass m. At t = 0, the pendulum is at its equilibrium position and is given an initial velocity v = 0.2 m/s. The maximum angular speed, θ'max, is: 0.05 rad/s 0.1 rad/s 0.2 rad/s 0.8 rad/s 0.4 rad/s
A simple pendulum consists of a 0.8-kg bob connected to a massless inextensible cord with a length L = 1.4 m. The bob is set into motion and its angular displacement is given by e(t) = 0.11cos(wt), where is in radians and tis in seconds. Take g = 9.8 m/s^2, determine the mechanical energy of this pendulum.