A simple power system is shown in this Fig. The generator (480 V, 10 kVA) is connected to an ideal step-up transformer (1:20), a transmission line (R=20 Ohm and X=60 Ohm), step down transformer (40:1) and a load (R= 25 Ohm and X=10 Ohm) the base values for this system are chosen to be 480 V and 10 kVA at the generator. Calculate the per unit reactive power for the load. line j60 N load Zyond 20Ω Zine 480 0° v Select one: a. 0.079 b. 1.63 c. 1.33 d. None of the above

A simple power system is shown in this Fig. The generator (480 V, 10 kVA) is connected to an ideal step-up transformer (1:20), a transmission line (R=20 Ohm and X=60 Ohm), step down transformer (40:1) and a load (R= 25 Ohm and X=10 Ohm) the base values for this system are chosen to be 480 V and 10 kVA at the generator. Calculate the per unit reactive power for the load. line j60 N load Zyond 20Ω Zine 480 0° v Select one: a. 0.079 b. 1.63 c. 1.33 d. None of the above

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

There is a thermoelectric power plant with an output of 500 MW, thermal insulation efficiency of 40%, and auxiliary ratio of 5%. If the plant uses heavy oil with a heating value of 9,600 [kcal/l] and operates at an annual utilization rate of 60%, what would the thermal efficiency at the generation transmission line be? solve it correctly please. I will rate accordingly.
Q10.Using diagrams, explain the correctness of the relation ICEO = (β + 1)ICBO.
It has been desired to install a diesel power station to supply power in a suburban area having the following particulars: (i) 1000 houses with average connected load of 1.5 kW in each house. The demand factor and diversity factor being 0.4 and 2.5 respectively. (ii) 10 factories having overall maximum demand of 90 kW. (iii) 7 tubewells of 7 kW each and operating together in the morning. The diversity factor among above three types of consumers is 1.2. What should be the minimum capacity of power station?
In Dhaka city during the month of May, a 20W rated solar panel supplies 15W of power at an output voltage of 15V & an output current of 1A. But during the month of December, the same solar panel supplies 8.5W of power at an output voltage of 10.5V & an output current of 0.81A.The solar panel is used to charge a 12V battery. Practically, for charging a 12V battery we need to supply 13V. i) In the month of May, the user will need a DC-DC converter (Buck) to charge the battery.a) What will be the duty cycle?b) Assuming that the converter is 100% efficient, what will be the input current to the battery?
An electricity power plant delivers energy at a rate of 20 MW to a city 1 km away. The common voltage output of commercial electricity generator is 22 kV. In order to reduce the power loss during transmission, a step-up transformer is used to boost the voltage to 230 kV before transmission. If the resistance of the transmission wires is 2 Ω and the electricity cost is about HK$1 per kWh, estimate the cost of electricity loss due to “joule heating” in the wires in one day.
Study the AC circuit shown. If the amplitude of the AC voltage source, Vm, is 210 V then find the amplitude of the AC current waveform, Im, in the circuit. Calculate the amplitude of the current in amps to one decimal place but do not enter the units (A) in your answer, for example, if you find Im to be 5.6 A then enter 5.6 only....
The Vi=3.5mV rms, find the ouput voltage, no handwritten
You are to size a grid-connected PV system to deliver 4000 kWh/yr in a location characterized by 5.5 kWh/m2/d of insolation on the array. a. Find the DC, STC rated power of the modules assuming a 0.72 derate factor. b. Find the PV collector area required if, under standard test conditions, these are 18%-efficient modules. c. Find the first-year net cost of electricity ($/kWh) if the system costs $4 per peak watt ($4/WDC, STC), it is paid for with a 5%, 30-year loan, interest on the loan is tax-deductible, and the owner is in a 29% marginal tax bracket.
1. An LRT car, 5 km distance from the Tayuman, takes 100 A over a 100 mm hard-drawn copper trolley wire having a resistance of 0.270 ohms per km. The rail and ground return has a resistance of 0.06 ohm per km. If the station voltage is 750 V, what is the voltage of the car? 2. A carbon resistor dissipated 60 W of power from a 120 V source at 20°C. How much energy will be dispersed in the resistor at 120°C if connected across the same source? Assume the temperature coefficient of carbon at 20°C is -0.0005 per °C?
USE APPROXIMATE ANALYSIS USE 2 decimal places, no commas. Given: Voltage-divider biased, npn BJT with 1. VCC=17V 2. R1 33kohms 3. R25kohms 4. RC = 2kohms 5. RE 1 kohms 6. BDC = 144 ** Solve for: 1, VB Blank 1 V: 2. VE Blank 2 V; 3. IE Blank 3 mA; 4. VCE Blank 4 V; 5. VC Blank 5V:
A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic meters. Thenet head of water at the turbine is 50 m. If the efficiencies of turbine and generator are 85% and 95%respectively, calculate the total energy in kWh that can be generated from this station. If a load of 15000kW has been supplied for 4 hours, find the fall in reservoir.
1- Your company is considering the installation of a 2 MW wind turbine with a rotor diameter of 80 m in a location with average wind v = 10 m/s. The turbine has a cut-in velocity of 5 m/s and a cut-out velocity of 25 m/s. The capacity factor is 0.45. The installed cost of the turbine is $3,500,000. Operating expenses are $225,000 per year. The system has a power coefficient (electric power generated divided by wind power) of 0.45. What price would you have to get for the electricity you produce to obtain a 10% return on the plant investment assuming a project lifetime of 20 years? Use the tables for the cumulative wind power distribution in the notes on wind probability to answer this question. Assume an air density of 1.225 kg/m3.