A single-mode step-index fibre in doped silica is designed for operation at a wavelength of 1.31 um. What is the practical significance of this choice of wavelength? Assuming that the V-value of the fibre at 1.31 um is close to its maximum for single mode operation, calculate the V-value at 1.56 um and discuss its suitability for operation at the longer wavelength. and discuss its prey for For operation at 1.31 µm, the chosen fibre has a core of refractive index 1.457 and a refractive index difference of 2.5.10-3 between core and cladding. What is the maximum core diameter compatible with single mode operation at 1.31 μm?

A single-mode step-index fibre in doped silica is designed for operation at a wavelength of 1.31 um. What is the practical significance of this choice of wavelength? Assuming that the V-value of the fibre at 1.31 um is close to its maximum for single mode operation, calculate the V-value at 1.56 um and discuss its suitability for operation at the longer wavelength. and discuss its prey for For operation at 1.31 µm, the chosen fibre has a core of refractive index 1.457 and a refractive index difference of 2.5.10-3 between core and cladding. What is the maximum core diameter compatible with single mode operation at 1.31 μm?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Find the ripple factor of the filter gantry rectifier with a load as shown in the figure below 10:1 Output 120 V rms ア 60z V Ppriy Piec) 1000uF DA 220 2 All diodes are IN4001. lll
Look up the diameter of a silicon atom, in Å. The latestsemiconductor chips have fabricated lines as small as 14nm. How many silicon atoms does this correspond to?
An interference filter is to be constructed for isolation of the nitrobenzene absorption band at 1537cm-1. a) If it is to be based on first-order interference, what should be the thickness of the dielectric layer(refractive index of 1.34)? b) What other wavelength would be transmitted?
Consider a CDMA cellular telephone system designed to meet a standard similar to IS-95, with the following modifications. The spread-spectrum chip rate is 10.24 Mchips/s, and the data rate is 20 kbits/s. The reverse link uses a 256-ary Walsh wave- form for modulating the rate coded data, requiring an E/I, of 6 dB. Find the values of the following received power-to-interference spectral density and energy-to- interference spectral density parameters: P,/Io, Ello, EwIo, EwchIo, and Ech/Io. Also. find the values of the following rates: R., Rw, and Rwch, where c, w, wch, and ch repre- sent channel bit, Walsh waveform, Walsh chip, and spread-spectrum chip, respec- tively. What is the processing gain, and how many spread-spectrum chips correspond to one Walsh chip?
QUESTION E True or falset A narrow band pass spectrophotometer produces more sensitive measurement and is less affected by wavelength calibration error than a wider band pass spectrophotometer. O True O False QUESTION In a spectrophotometric determination, which one of the following is the formula for calculating the absorbance of a solutiont O (Absorptivity concentration) / light path in cm O (Absorptivity = light path in cm) / concentration O Absorptivity light path in cm concentration O (Light path in cm concentration)/absorptivity QUESTION 10 Which of the following statements is TRUET O Partition chromatography is most appropriate to identitying analytes that may be distrituted between two liquid phases O Steric endusion chromatography is best suited for separating analytes based on their solubility in the mobile solvent. Oin liquid-solid chromatography, the stationary phase separates analytes based on size, shape, and polarity O lon eschange chromatography has a resin phase that…
(a) Show that the skin depth in a poor conductor (o « we) is (2/0)JE/µ (independent of frequency). Find the skin depth (in meters) for (pure) water. (b) Show that the skin depth in a good conductor (ơ » we) is à /27 (where à is the wavelength in the conductor). Find the skin depth (in nanometers) for a typical metal (a 107 (2 m)-') in the visible range (» z 1015/s), assuming e = €o and µ z µo. Why are metals opaque?
Rg Q V3 Eg V1 V2 V1=5 Vms- V2=10dBy. V3=80dBmy- Rg=502. RL=102. Compute the value of the power gain Gp with a absolute accuracy ±0.1dB Answer: RL
A GaAs DH injection laser (refractive index: 3.6) has an optical cavity of length 50 μm and width 20 μm. At normal operating temperature (300 K) the loss coefficient is 10 cm-1, the mirror reflectivity at each end of the optical cavity is 0.3 and the gain factor for the device is 3.76x10-2 cm/A. The device emits at a wavelength of 870 nm. 1.1 Calculate the frequency separation of the longitudinal modes and the number of longitudinal modes emitted by the device. 1.2 Determine the current threshold for the device at 300 K. 1.3 Determine the required threshold current when the diode is operated at a temperature of 60˚C.
An FM signal has a deviation of 3 kHz and a modulating frequency of 1 kHz. Its total power is 5 W, developed across a 50 22 resistive load. The carrier fre- quency is 160 MHz. ahora la edasil. (c) Calculate the frequency requency of each sideband for the first three sideband mal bo phasd af vo pairs. dan sebaran
A helium-neon laser operates at the threshold limit, mirror reflectivity coefficient (0.999 & 0.95), laser length (50 cm) and effective mean gain (1.02). Calculate: a- loss factor k, b- loss coefficient »?
Q I/ A voice signal with maximum frequency of 3kHz, is to be transmitted using sampling frequency fs 8 kHz, and pulse duration z pulse duration, and the required bandwidth of PAM, PWM and PPM if the rise time tr = 1% of pulse duration. 0.1 Ts, determine the Ts,
The reflectivity of silicon at 633nm is 35% and the absorption coefficient is 3.8×105 m¹. Calculate the transmission of a sample with a thickness of 10 µm.