A single phase, 60Hz, 200-km medium nominal-T transmission line receives 700 MW at 0.95 lagging pf at 327.8 kV from the generator. Using circuit analysis, determine: a. Sending-end current, Is b. Receiving-end voltage, Vr C. Receiving-end current, Ir d. Receiving-end Real, Reactive, and Apparent Power e. Power loss (real component) in the transmission 3.6 Ω ರ Vs j30 Ω j0.00084 S 2.8 Ω W j40 Ω VR

A single phase, 60Hz, 200-km medium nominal-T transmission line receives 700 MW at 0.95 lagging pf at 327.8 kV from the generator. Using circuit analysis, determine: a. Sending-end current, Is b. Receiving-end voltage, Vr C. Receiving-end current, Ir d. Receiving-end Real, Reactive, and Apparent Power e. Power loss (real component) in the transmission 3.6 Ω ರ Vs j30 Ω j0.00084 S 2.8 Ω W j40 Ω VR

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.18P

See similar textbooks

Similar questions

Consider a long radial line terminated in its characteristic impedance Zc. Determine the following: (a) V1/I1, known as the driving point impedance. (b) | V2 |/V1|, known as the voltage gain, in terms of al. (c) | I2 |/| I1 |, known as the current gain, in terms of al. (d) The complex power gain, S21/S12, in terms of al. (e) The real power efficiency, (P21/P12)=, terms of al. Note: 1 refers to sending end and 2 refers to receiving end. (S21) is the complex power received at 2; S12 is sent from 1.
A three phase 220KV, 50Hz transmission line supplies a power of 100MW at a power factor of 0.8 lag at the receiving end. The Series resistance, reactance, and shunt susceptance per phase per Km are 0.082, 0.8 2, and 6 x 10-6mho respectively. Determine the efficiency and regulation for transmission line lengths of 60Km and 200Km (use π)
A 50ohm transmission line powered by a 3GHz source and terminated with a load impedance ZL=25-j60 ohms will be matched with the shorted parallel side. What should be the length, in m, of the parallel lateral line calculated using the Smith diagram ?
In three-phase short transmission line with end-of-line interphase voltage UR = 31,5kV , from the end of the line active power absorbed PR = 9000 kW, end of line power factor is cosφ = 0,70 (end) and the length of the line is l = 20km, The resistance of the line per km is R'= 0,125 Ohm/km, the reactance per km is X'= 0,375 Ohm/km.With the help of given information; a) Calculate the current drawn from the line (IR) as a phasor. b) Calculate the line-to-line-neutral voltage (VS) as a phasor, determine the effective line-to-line voltage (US) Calculate its value. c) Calculate the line head power factor, active and reactive power drawn from the line head, d) Draw the phasor diagram of the system. ..
A 50-ohm lossless transmission line has series inductance of 250 nH/m and shunt capacitance of 100 pF/m. What is the time delay per unit length (in ns/m) of this transmission line? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an interger).
Question 1. The impedance of a 150 km long transmission line is ? = 0.06 + ?0.48 ?/??, and the shunt admittance value is given as ? = ?3.33?10−6 ?/??. Under 250 kV voltage at the end of the line A power of 250 MW is drawn with a reverse power factor cos ? = 0.95. Nominal π equivalent using the circuit; a) Find the ABCD parameters. b) Find the voltage, current and power factor per line.
With the system shown in the figure, use 100MVA as system base, and 230 kV as base voltage along the transmission line. For the same system in the figure, build the Y-bus matrix without the Load. 1. What is the element Y11? Provide the susceptance value 2. What is the element Y22? Provide the susceptance value
Viva Questions:1. What is the difference between Primary and Secondary constants? 2.Define Transmission line Input Impedance?
In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit. Select one: True False
A bundled 500kv, 60Hz three phase completely transposed overhead line having three ACSR 1113kcmil(556.50mm) conductors per bundle,with 0.5m between conductors in the bundle. The horizontal phase spacings between bundle centers are 10,10,and 20m.Calculate the capacitance -to- neutral in F/m. and the admittance -to-neutral in S/km.
A 500 kV, 60 Hz uncompensated three-phase transmission line is 500 km long. The line has three ACSR 1113-kcmil (Finch) conductors per phase with parameters Current carrying capability of single ACSR 1113-kcmil (Finch) conductor is 1,110 A. Calculate the theoretical maximum (steady state stability limit) real power that this line can deliver and compare with the thermal limit of the line. Assume VS = VR = 1.0 per unit and unity power factor at the receiving end.
b) Ghana Grid Company (GRIDCo) designed a short transmission line using the A, B, C, D line constant of a transmission line parameters in its analysis. The engineering planning department came up with the design and said that when they computed the line performance using the equation AD – BC the answer was equal to 1.As an employee at the Ministry of Energy (MoEn) having oversight responsibility over GRIDCo, how would you accept the answer and recommend the Government of Ghana (GoG) to go ahead to implement the short transmission line?