(a) Sketch the equivalent circuit and obtain the general equation for synchronous generator

Q: to correct the power factor to reduce

A: A plant has, Active power consumption, P = 290 kW  Average power factor = 70% = 0.7  The power…

Q: For the electric two-port circuit shown, write the ser us voltages w.r.t currents equations…

A: For the above given resistive network we need to calculate the value of open circuit parameters. In…

Q: Why the diode added to the Single phase fully controlled half wave rectific OBecause of the output…

A:

Q: Determine the current IX in the Fig.7:

A: It is given that:

Q: Determine the cut-off frequency

A:

Q: 9. Three equal positive charges of 92 st at coloumb each are located at the vertices of an…

A: Given,Three equal positive charges are located at the vertices of an equiangular triangle.The value…

Q: A 10 MVA three phase load is to be served by a three phase transformer at a line voltage of 13.8 kV.…

A: Transformer is the static device it is used to transfer the electrical power from one terminal to…

Q: Answer Five Questions Q1) Determine the voltage gain (Av) for the amplifier circuit shown in figure…

A: Given data: The value of the β is 250, Given figure:

Q: actice Problem 1: Determine IE, IB, IC, PDc, pc and VEC in the circuit. +VEE +5V RE=2kQ -OVE=4 V

A:

Q: : Answer All points: In any network of wires carrying currents, the algebraic sum of all currents…

A:

Q: 6. Determine the transfer function V.(s)/Vi(s). R₂ www moo +₂ Vi(s)-ME R₂ C₁ 6₂ HE + Vo (s)

A:

Q: For the two port network shown. Calculate Z₁, for maximum power transfer and maximum power delivered…

A:

Q: Vils)–WHE R₂ C₁ " R2 www 2 L2 C2 카 • Ve(s)

A:

Q: 5. If a current enters the dotted terminal of one coil, the reference polarity of the mutual voltage…

A:

Q: Q4. A boost regulator has an input voltage of 5 V. The average output voltage is 15 V and the…

A: Given data : Input voltage Vin=5V Output voltage Vout=15V Average load current iL=0.5A Switching…

Q: For the electric two-port circuit shown, write the voltages w.r.t currents equations (Z-Parameters).…

A:

Q: 1.1 How many coulombs are represented by these amounts of electrons? (a) 6.482 x 1017 (b) 1.24 x…

A: We know that 1 electron has a charge of 1.6 × 10-19  Coulomb a) 6.482×1017 electrons will carry…

Q: Design a circuit that accepts the binary code of decimal numbers 0 to 15 and it outputs a 1 when the…

A: Circuit accepts the binary code of decimal number 0 to 15 and its output as '1' when the input…

Q: For the magnetically coupled circuit shown beside: 1. Write the set of mesh current equations? 2.…

A:

Q: Which of these is not an electrical quantity? (a) charge (b) time (c) voltage (d) current (e) power

A: Option A electric charge is the physical property of something that causes it to feel the force when…

Q: 3ZB The following are basic op-amp connections/application except for. a.Subtracter b.Integrator…

A: Given & To find:: The following are basic op-amp connections/applications except for: a.…

Q: The peak inverse voltage in bridge rectifier of the diodes is reduced from 2Vm to Vm ODuring…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when it…

Q: 9.7 If 6) = cos + jsind, show that fd) = c 9.8 Calculate these complex numbers and express your…

A: The required parameters can be calculated by converting the polar form representation in to…

Q: 3F roblem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A:

Q: Q/ Determine and sketch the even and odd parts of the signal below, label your sketch carefully 1.5…

A:

Q: a-) In the circuit below, the silicon diode needs 1mA as the lowest value of the current in order to…

A: For the above given series connection of voltage source , resistor and diode we need to calculate…

Q: Correct any five of the following sentences using suitable scientific phrases. 1. At star connection…

A:

Q: *: The main reason to convert from digital to analog or vice versa is The devices works only with…

A: Reason for converting analog to digital and vice versa  1. Information or physical data are…

Q: A series LRC circuit has a sinusoidal voltage supplied to it at 158 kHz with a peak voltage of 810…

A: Given a series LRC circuit has a sinusoidal voltage supplied to it at 158 Hz with a peak voltage of…

Q: 1. Based on the exercise, what do you understood about STAR connection? 2. What are the…

A:

Q: Two resistors connected in parallel The value of the first resistance is 6 ohms and the value of the…

A: We need to find out the equivalent resistance

Q: If 12 v peak sine wave is applied across half wave rectifier, value of the PIV across the diode is…

A:

Q: EX: 2.1 Determine Ang) emodita: the instantaneous frequency (in Hz) of the following signals: X₂ (+)…

A:

Q: Q.2) Consider the fixed-gate bias circuit of JFET shown below with the following parameters obtained…

A: The dc circuit is given below  Now we need to find dc parameter by dc analysis.

Q: LI> GH LS 4H L3> 2.4K 6H 1 N2 120v Tod N3

A: Given data, The value current flow through the L2 is 30 A

Q: What are the advantages and disadvantage of cascade system compared to other type of modification

A: There are 2 (or more) controllers in a cascade control system, with one controller's output driving…

Q: 3. Calculate the aperture efficiency of a radar receiver with Pr =43µWatts, with gain of 150,…

A: Given  All the parameters of radar,we need to determine the aperture efficiency. Please find the…

Q: ZI The if the input to a Differentiator op-amp is a DC signal then the magnitude of the output will…

A: The advantage of the Op-Amp separator depends on the size of the input signal. If f = 0, for DC…

Q: C series motor operates at 800rpm with a line current of 100A from 230V mains supply. Its armature…

A: Note: Name of motor is not given so considering it DC series motor and then solving the question.

Q: The voltages developed across the 3 and 2 resistors shown in the Fig.2 are 6V and 2V respectively,…

A:

Q: Q2 (a) Referring to oscillator circuit depicted in Figure Q2(a), determine the value of RF so that…

A:

Q: Me connected load with Zab-48-J21 2, Zbc=18+J16 2 and Zca=20+J02. A three-phase balanced system with…

A:

Q: For the electric two-port circuit shown, write the voltages h w.r.t currents equations…

A: In this question,  We need to determine the Z parameters?  V1 = Z11 I1 + Z12 I2  V2 = Z21 I1 +Z22 I2…

Q: Realize f(a,b,c.d) = {(0,2, 3, 5, 6, 7,11,13,14,15) with 4:1 multiplexer and minimum of other gate

A: For the above given minterms we need to realize them using 4 :1 multiplexer.

Q: For the circuit shown, determine the current drawn from the 15V battery, It. Find I1, I2 I3 and I4

A: To solve above problem, we must know Ohm’s law and Kirchhoff’s law: Ohm's law state that in a…

Q: a. Given Ipss = 12 mA and Vp = −4 V, sketch the transfer characteristics for the JFET transistor. b.…

A: JFET is junction field effect transistor. It is the semiconductor device. It is three terminal…

Q: : Answer All points: Find the value of Vx due to the 16V source in Fig.5 (using superposition…

A:

Q: At times t=0, 1, and 2 seconds, processes P1, P2, and P3 arrive in the Ready state, respectively.…

A:

Q: What are the characteristics of an ideal operational amplifier?

A: In this case, the characteristics of an ideal operation amplifier needs to be discussed.

Q: 3V An op-amp circuit that has a capacitor as the feedback component is called a/an: a.differentiator…

A: opretinol amplifier diffrent circuit is shown below with their circuit

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.