A small square loop of wire of side a2 is placed inside a large square loop of wire of size a1 (a1 > a2). a)find the mutual inductance b)find the force between the loop

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 75AP: A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of...

See similar textbooks

Related questions

Q: Two coils are at fixed locations. When coil 1 has no current and the current in coil 2 increases at…

A: The rate of change of current,

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 470…

A: Given that: NA=470 NB=570iA=2.60 AϕA=300μWb=300×10-6 WbϕB=90μWb=90×10-6 Wbdidt=0.5 A/s

Q: Initially, the switch connects a resistor of resistance R and an inductor to a battery, and a…

A: Initial current in the circuit = I0 Formula of current through the circuit at time t: It=I0e-tτ

Q: Determine the mutual inductance between a toroidal coil of N1 turns with square cross section (inner…

A: Given: Number of turns in toroidal coil = N1 Inner radius of coil = b Outer radius of coil = a…

Q: Show that the two expressions for inductance given by have the same units.

A: Given: Inductance

Q: A single-loop circuit consists of a 7.20 ohm resistor, a 12.0 H inductor, and a 3.20 mF capacitor.…

A: Write the expression for the charge on the capacitor in RLC circuit after time t.

Q: Experimentally, the magnetic flux OB in a solenoid was 4. measured for various currents I. The data…

Q: Consider a long coaxial cable made of two coaxial cylindrical conductors that carry equal currents I…

A: The ampere’s circuital law is

Q: A 600-turn solenoid is 0.55 m long and 4.2 cm in diameter. Inside the solenoid, a small (1.1 cm ×…

Q: Determine the mutual inductance between a toroidal coil of N1 turns with square cross section (inner…

Q: A small thin coil with N2 loops, each of area A2, is placed inside a long solenoid, near its center.…

A: Mutual inductance of two coils linked with each other is given by:- M= (N2ØB_2)/i1 Where; ØB_2= flux…

Q: The spark plug system in a car stores energy in an inductor coil of 30 turns and inductance of 6.7…

A: (a) the current driven by the battery is, I=VRI=12 V2 ΩI=6 A thus, the energy stored by the…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 400…

Q: Experimentally, the magnetic flux On in a solenoid was measured for various currents I. The data was…

A: Given The data or current and magnetic flux and we have to find the inductance of the solenoid?.…

Q: Two coils are at fixed locations. When coil 1 has no current and the current in coil 2 increases at…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 460…

Q: In and L-C circuit, C=3.19 microFarads and L=81.0 mH. During the oscillations the maximum current in…

Q: A long straight wire and a small rectangular wire loop lie in the same plane, as in the figure.…

Q: Let say that a flat coil of wire, having 5 turns, has an inductance L. Then the inductance of a…

A: For any coil of wire the inductance is given by the following formula : L = µN2A / l µ refers to the…

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

Q: Suppose we have a rectangular loop S2 made by a conducting material with N2 =60turns and length,…

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

A: Given data,

Q: A circuit has two elements a capacitor and an inductor. The inductance is L = 12.5mH, and…

A: Given L= 12.5 mH C= 2μF Initial voltage = 10VFind → voltage…

Q: A 10.00 μF capacitor C is initially charged to a voltage V of 10.00 (V). It is then connected in…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, solenoid A…

A: Given:

Q: Imagine that we have a large loop sitting flat on the screen with a radius = 58.7 cm that has a…

Q: An inductor is formed by winding N turns of a thin conducting wire into a circular loop of radius a.…

A: Given data: Magnetic field, B=B02y^+3z^sinωt Number of turns, N=10 B0=0.2 T; a=10 cm=0.10 m;…

Q: Two coils, 1 and 2, are separated in space, and have a fixed distance between them. When coil 2 has…

A: Given - Rate of increase of current in coil -1, di1/dt = 24.0 A/s EMF induced in coil -2 due…

Q: A capacitor with capacitance of 6.5 x 10-5 F is charged by connecting it to a 12.0-V battery. The…

A: Given: Capacitance, C = 6.5 X 10-5 F Voltage, V = 12 V Inductance, L = 1.5 H

Q: Cl. Consider the simple circuit shown to the right. The inductor is composed of 1000 loops and has…

A: Let the length of the solenoid be l, the radius of the cross-section of the inductor be r, the total…

Q: A 497-turn solenoid has a radius of 9.00 mm and an overall length of 13.2 cm. (a) What is its…

Q: A voltage E= E,e-at is applied at t= 0 to a circuit of inductance L and R.f the required…

Q: Coil A is a large 1000 turn circular coil of radius 68.0 cm. Circular coil B has 200 turns, a radius…

A: The given values are,

Q: Experimentally, the magnetic flux PB in a solenoid was 2- measured for various currents I. The data…

Q: An RL circuit consists of a 40.0 Ω resistor and a 3.00 mH inductor. (a) Find its impedance Z at 60.0…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 340…

Q: A single-loop circuit consists of a 7.0 Ω resistor, 12.2 H inductor, and a 3.1 μF capacitor.…

A: Given,

Q: Part A In an L-C circuit, C = 3.19 µF and L = 87.0 mH. During the oscillations the maximum current…

Q: A resistor and inductor are connected to a 9.0 V battery by a switch as shown. The moment the switch…

Q: Tarik winds a small paper tube uniformly with 173 turns of thin wire to form a solenoid. The tube's…

A: Given data : Number of turns, N = 173 Diameter of the tube, D = 7.95 mm =…

Q: Figure Q3(a) Calculate the inductance of the coil shown in Figure Q3(b), which has a cylindrical…

A: Given Number of turns of the coil N= 200 Length l =200mm = 0.2 meters Diameter d=5mm Then radius…

Q: A coil of 40 turns is wrapped around a long solenoid of cross-sectional area 7.5 × 10−3 m2. The…

A: The relation between magnetic flux (Φ21) and mutual inductance (M) is given by- M=N2Φ21I1Here,N2 is…

Q: Suppose we have a rectangular loop S2 made by a conducting material with N2 = 10 turns and length, a…

A: Magnetic Flux is the number of magnetic lines passing through a surface. Given Mutual inductance= 8…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

A small square loop of wire of side a2 is placed inside a large square loop of wire of size a1 (a1 > a2).

a)find the mutual inductance

b)find the force between the loop

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
A coaxial cable has an inner conductor of radius a, and outer thin cylindrical shell of radius b. A current I flows in the inner conductor and returns in the outer conductor. The self-inductance of the structure will depend on bow the current in the inner cylinder tends to be distributed. Investigate the following two extreme cases. (a) Let current in the inner conductor be distributed only on the surface and find the self-inductance. (b) Let current in the inner cylinder be distributed uniformly over its cross-section and find the self-inductance. Compare with your results in (a).
Discuss how you might determine the-inductance per unit length of a long, straight wire.
The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.
A 600-turn solenoid is 0.55 m long and 4.2 cm in diameter. Inside the solenoid, a small (1.1 cm × 1.4 cm), single-turn rectangular coil is fixed in place with its face perpendicular to the long axis of the solenoid. What is the mutual inductance of this system?
The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In each case, determine which end of the inductor is at the higher potential.
Check Your Understanding (a) What is the magnetic flux through one turn of a solenoid of self- inductance 8.0 × 10-5 H when a current of 3.0 A flows through it? Assume that the solenoid has 1000 turns and is wound from wire of diameter 1.0 mm. (b) What is the cross-sectional area of the solenoid?
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
Referring to the configuration shown on theright,a) determine the force between theseconductorsb) determine the mutual inductance
An engineer proposes to store 75 kJof energy by flowing 1.5 kA of current through a superconductingsolenoid that forms an inductor. (a) What is the required inductance L? (b) If the solenoid is to have a radius of 1.2 m and bewound with no more than 5 turns per meter, what length mustthe solenoid have?