A 497-turn solenoid has a radius of 9.00 mm and an overall length of 13.2 cm. (a) What is its inductance? 4.5*10**-4 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. mH (b) If the solenoid is connected in series with a 2.50-N resistor and a battery, what is the time constant of the circuit? 4.52*10**-4 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. ms Additional Materials I eBook

A 497-turn solenoid has a radius of 9.00 mm and an overall length of 13.2 cm. (a) What is its inductance? 4.5*10**-4 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. mH (b) If the solenoid is connected in series with a 2.50-N resistor and a battery, what is the time constant of the circuit? 4.52*10**-4 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. ms Additional Materials I eBook

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 77AP: A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x...

See similar textbooks

Similar questions

Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm. (a) Neglecting end effects, that is the self-inductance per unit length of the solenoid? (b) If the current through the solenoid changes at the rate 5.0 AJs, what is the emf induced per unit length?
A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0 cm2. What is the self-inductance of the solenoid?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
The self-inductance of a coil is zero if there is no current passing through the windings. True or false?
A solenoid of N1turns has length l1and radius R1, and a second smaller solenoid of N2turns has length l2and radius R2. The smaller solenoid is placed completely inside the larger solenoid so that their long axes coincide. What is the mutual inductance of the two solenoids?
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the inductor is 5.0 . Calculate the voltage across the inductor at t = 2.0 ms, r = 4.0 ms, and t = 8.0 ms.
A solenoid with 4 x 107turns/m has an iron core placed in it whose magnetic susceptibility is 4.0 x 103. (a) If a cent of 2.0 A flows through the solenoid, what is the magnetic field in the iron core? (b) What is the effective surface current formed by the aligned atomic current loops in the iron core? (c) What is the self-inductance of the filled solenoid?
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.