A soil profile consists of sand (9-m thick) which overlies a layer of clay (5-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.8, Specific gravity = 2.79, Degree of Saturation = 0.68 For clay layer: Void Ratio = 1.09, Specific gravity = 2.88 Round off to two decimal places.

A soil profile consists of sand (9-m thick) which overlies a layer of clay (5-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.8, Specific gravity = 2.79, Degree of Saturation = 0.68 For clay layer: Void Ratio = 1.09, Specific gravity = 2.88 Round off to two decimal places.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.11P

See similar textbooks

Similar questions

Refer to Figure 10.48. If R = 4 m and hw = height of water = 5 m, determine the vertical stress increases 2 m below the loaded area at radial distances where r = 0, 2, 4, 6, and 8 m. Circular contact area of radius R on the ground surface Figure 10.48
A soil profile consists of sand (7-m thick) which overlies a layer of clay (9-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.75, Specific gravity = 2.62, Degree of Saturation = 0.77 For clay layer: Void Ratio = 0.87, Specific gravity = 2.85 Round off to two decimal places.
A soil profile consists of sand (5-m thick) which overlies a layer of clay (4-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.75, Degree of Saturation = 0.76 For clay layer: Void Ratio = 1.09, Specific gravity = 2.76
Question 20 A soil profile consists of sand (5-m thick) which overlies a layer of clay (9-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.68, Degree of Saturation = 0.6 For clay layer: Void Ratio = 0.92, Specific gravity = 2.86 Round off to two decimal places.
A soil profile consists of sand (6-m thick) which overlies a layer of clay (5-m thick). The groundwater table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.72, Specific gravity = 2.61, Degree of Saturation = 0.6 For clay layer: Void Ratio = 0.99, Specific gravity = 2.72 Round off to two decimal places.
A soil profile of sand (9m thick) which overlies a layer of clay (5m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in effective stress (in kpa) at the bottom of the layer? for sand layer: void ratio = 0.88, specific gravity = 2.71, degree of saturation = 0.76 for the clay layer: void ratio = 1.07, specific gravity = 2.81
The soil profile shown consists of dry sand (5-m thick) which overlies a layer of clay (8-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water taable rises to the top of the ground surface, what is the change in effective stress (kpa) at the bottom of the clay layer? For sand layer: Void Ratio= 0.83 SG= 2.68 Degree of Saturation= 0.78 For claylayer: Void Ratio= 0.89 SG=2.88
The soil profile shown consists of dry sand (4-m thick) which overlies a layer of clay (3-m thick). Ground water table is located at the interface of the sand and clay. a. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? Round off to two decimal places. (ANSWER: 26.336) b. Compute the effective stress at the bottom of the clay layer in kPa. Round off to three decimal places (ANSWER: 97.686) c. How many meters must the ground water table rise to decrease the effective stress by 14 kPa, at the bottom of the clay layer? Round off to two decimal places (ANSWER: 2.13)
The water table is lowered from a depth of 3 m to a depth of 6 m in a deposit of silt. The silt remains saturated even after the water table is lowered. What would be the increase in the effective stress in kPa at a depth of 3 m and at 10 m on account of lowering of the water table? Assume the water content as 27% and grain specific gravity 2.67. a.29.43 b.88.29 c.117.72 d.58.86
Effective Stresses in Soil Problem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of the solid particle is 2.84. 1.Determine the density of the clay in kg/m³. 2.Determine the total vertical stress at the bottom of the clay layer in kpa. 3.Determine the effective vertical stress at the bottom of the clay layer in kpa.
need fast please A soil profile consists of sand (6-m thick) which overlies a layer of clay (6-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.88, Specific gravity = 2.75, Degree of Saturation = 0.79 For clay layer: Void Ratio = 0.99, Specific gravity = 2.86 Round off to two decimal places.
A layer of soil has the following properties: void ratio = 0.44, effective diameter = 12 μm, capillary constant C = 0.18 cm2 . Groundwater table is 10 m below the ground surface. (a) Find the height of capillary rise in the soil in mm. (b) What is the effective stress in kPa at 7 m depth if unit weight of solids is 25.55 kN/m3 and soil above the capillary zone is 40 % saturated? (c) What is the effective stress in kPa at 14 m depth?