A speech signal, band limited to 4 kHz, is sampled at 1.25 times the Nyquist rate. The speech samples, assumed to be statistically independent and uniformly distributed in the range -5 V to +5 V, are subsequently quantized in an 8-bit uniform quantizer and then transmitted over a voice-grade AWGN telephone channel. If the ratio of transmitted signal power to channel noise power is 26 dB, the minimum channel bandwidth required to ensure reliable transmission of the signal with arbitrarily small probability of transmission error (rounded off to two decimal places) is kHz.

A speech signal, band limited to 4 kHz, is sampled at 1.25 times the Nyquist rate. The speech samples, assumed to be statistically independent and uniformly distributed in the range -5 V to +5 V, are subsequently quantized in an 8-bit uniform quantizer and then transmitted over a voice-grade AWGN telephone channel. If the ratio of transmitted signal power to channel noise power is 26 dB, the minimum channel bandwidth required to ensure reliable transmission of the signal with arbitrarily small probability of transmission error (rounded off to two decimal places) is kHz.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a baseband digital communication system, communication is made with pole coding at -1 V and +5 V levels. There is a noise sign of ? ~ ? (0.1) in the channel. It is also given the information that (? = 0) = 0.4. In this case, find the decision threshold that will give the buyer the lowest probability of error. Calculate the total error probability of the system for this decision threshold.
An SSB signal is generated by modulating a 10-MHz carrier with a 1-KHz sine tone. At the receiver, the carrier is reinserted during demodulation, but its frequency is 10.00015 MHz rather than exactly 10-MHz. How does this affect the recovered signal? How would a voice signal be affected by a carrier that is not exactly the same as the original?
A digital data will be transmitted over an analog transmission medium that has amaximum bandwidth of 1.4MHz with SNR=26.2 dB.a) What is the maximum data speed that can be achieved in this system?b) If you consider only the white noise, what is the minimum signal power required withinthis transmission system?c) How many signaling levels should be used to reach to the data rate that you calculated inpart (a)?
A digital communication link carries binary-coded words representing samples of an input signal, xa(t)=3cos⁡(600πt)+2cos⁡(1800πt)The link is operated at 1,000 samples/s. (a) What is the folding frequency? (b) What is the Nyquist rate for the signal xa(t)? (c) What are the frequencies in the resulting discrete-time signal x(n)? (d) Will there be any aliasing here? (e) Which frequency will alias to what frequency
Q3 (i) What do you mean by baseband transmission of a digital signal ? What are the possible types of connection of devices in a topology for communication?
After an analog signal is sampled at 15 kHz, it is converted into digital form by quantitating at 64 levels. Since unipolar rectangular pulses with 50% occupancy-void ratio are used to transmit the signal from the baseband, what is the required bandwidth for transmission?
Consider a communication channel with a spectrum between 5 MHz and 7 MHz and SNR of 30 dB. Calculate the theoretical maximum data rate according to Shannon's formula. İf we assume we can achieve this limit, how many signaling levels are required based on Nyquist's formula ?
Wireless communication Determine the minimum C/N ratio for an 8-PSK system when the transmission rate is 60Mbps, the minimum energy of bit-to-noise density ratio is 15 dB, and the receiver bandwidth isequal to the minimum Nyquist frequency.
What is the SNR expressed in dB for a signal detected at a receiver with a power of 1 microwatt? Assume that the power of the noise at the receiver is 1 nanowatt.
A communication system has a bandwidth of 150 MHz and an SNR (dB) of 35 dB. a. What is the theoretical maximum data rate (C) on this channel?b. How many signal levels (symbols) do we need to achieve this data rate?c. If we want to increase the maximum data rate to 10 Gbps, what SNR (dB) do we need on this medium?
A telephone signal with a cut-off frequency of 4 kHz is digitized into 8-bit PCM, sampled at Nyquist rate. Calculate the baseband transmission bandwidth and quantization S/N ratio.
Calculate channel capacity, in bits per second, of a 10-MHz channel with an S/N ratio of 50 dB *