Problem-5. Suppose that the spectrum of a channel is between 12 MHz and 18 MHz, and an intended capacity of 10 Mbps. (A) What should be the SNR to obtain this capacity? (B) How many signaling levels are required to obtain this capacity? (C) What would be the capacity if the environment starts suffering lesser noise and the SNR goes up to 30 dB. (D) Same question as (B) but for the capacity in (C)

Problem-5. Suppose that the spectrum of a channel is between 12 MHz and 18 MHz, and an intended capacity of 10 Mbps. (A) What should be the SNR to obtain this capacity? (B) How many signaling levels are required to obtain this capacity? (C) What would be the capacity if the environment starts suffering lesser noise and the SNR goes up to 30 dB. (D) Same question as (B) but for the capacity in (C)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands in computer communication and network?
There exist several methods to perform AM demodulation, consider a requirement where we intend to design an AM receiver which is characterized by less distortion and high SNR.Identify which type of AM demodulation scheme is mentioned in the above statement and explain one such demodulation with appropriate sketch.Compare and contrast different AM modulation and demodulation schemes in various aspectsExplore one interesting application area involving Amplitude Modulation with explanation and neat sketch.
A. How many numbers of constellation points exist in phase for 3bit ASK? B. What happens to the radio wave propagation when the frequency is below critical angle? C. If the mark frequency and space frequency are same then what happens to FSK? D. What is the Carson’s rule? E. What is the Maximum data rate in a minimum channel bandwidth is ? F. What is radio horizon and where is it used? G. What are the phase angle limitations of a BPSK? H. What is the change in channel capacity when two number of bits are increased?
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?
For the transistor , IS = 6×10−16 μA,αF = 0.985, and αR = 0.25. (a) What type oftransistor is in this circuit? (b) Label the collector, base, and emitter terminals of the transistor.(c) Label the emitter-base and collector-base voltages, and label the normal direction for IE , IC, andIB. (d) Write the simplified form of the transportmodel equations that apply to this particular circuitconfiguration. Write an expression for IE /IC. Writean expression for IE /IB. (e) Find the values of IE ,IC, IB, βF , βR, VE B, and VC B.
Consider an AWGN channel with bandwidth 50 MHz, received signal power 10 mW, and noise density No (Noise Power/Bandwidth) = 10−9 W/Hz. (Use two decimal places) (a) What is the information capacity (Mbps) in the system? (b) By doubling the received power, What is the information capacity (Mbps) in the system? (c) How much does the capacity (Mbps) by doubling the channel bandwidth?
24. The power of DSSS systems is largely in the spreading and dispreading of the received signal because it gives rise to a phenomenon known as ______________.A. channel codingB. spectral regrowthC. processing gain5D. frequency-hopping
Q3 (i) What do you mean by baseband transmission of a digital signal ? What are the possible types of connection of devices in a topology for communication?
what is the realistic channel capacity of a communication channel of 25KHZ that has 20db signal to noise ratio?
Question 1. Calculate the peak LTE OFDMA downlink data throughput of 20-MHz channel bandwidth using 128QAM modulation and 2x2MIMO?
A carrier is modulated simultaneously by two baseband signals with modulation indices of 0.3 and 0.4 respectively. If the scheme is AM, then what will the overall modulation index?
Let assume that the spectrum of a channel is between 10 MHz and 12 MHz, and an intended capacity of 8Mbps What should be the SNR in order to obtain this capacity? How many signaling levels are required to obtain this capacity?