A spring return solenoid valve is to be switched via pushbutton S1. Calculate the current through the valve coil 1M1 if the voltage supply is 24V DC and the coil resistance is 480. What is the power consumption of the valve coil? +24V Show your work: 13 SIE 14 IM1 Ov

A spring return solenoid valve is to be switched via pushbutton S1. Calculate the current through the valve coil 1M1 if the voltage supply is 24V DC and the coil resistance is 480. What is the power consumption of the valve coil? +24V Show your work: 13 SIE 14 IM1 Ov

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter9: Components For Electric Motors

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Related questions

Q: A dc series motor drives a load a 30rev/s and takes a current of 10A when the supply voltage is…

A: In this question, We need to efficiency of the DC series motor? If input current I= 10A Supply…

Q: МСВ Instruction Check Connection ON A Voltmeter 1 Ammeter Wattmeter Reset V Add to Table…

A: The setup shows two voltmeter, ammeter, wattmeter, auto transformer, Transformer and MCB.

Q: Maintenance team has a 3Φ induction motor 400V, 50Hz, 6 pole delta connected takes 45 kW with a line…

A: Output power = input power - losses. Output power = 2× pi× Nr× T /60. Using above formulae find the…

Q: The following readings are obtained when doing a Break test on a d. c. shunt motor: - Spring balance…

A: Reading of DC Shunt motor with, Spring Balance Reading = Tight Side(W1) = 30.5 kg.…

Q: 20. An incandescent lamp load, generally considered to be made up of resistors, takes 8 kW from a…

A: This question belongs to circuit theory . It is based on the concept of sinusoidal analysis for a…

Q: copper coil, when connected to a 30-volt supply, initially takes a current of 3 A and has a mean…

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: A relay has a resistance of 350 ohms and an inductance of 0.8 henry. V volts is suddenly impressed…

Q: 8. When a motor is tested with a prony brake, the scale reading is 3.50 lb. The length of the brake…

A: The word Dynamometer has came from French word dynamomètre, which consists of two words dunamis…

Q: 30 75 hp Motor Nameplate Information: 208-230/460-V Supply: 3-pole breaker in a 120/240-V, 3-ph, 4-W…

A: Given motor name plate: 208-230/460 Volts, 3-phase, 75 hp. We need to choose the minimum size…

Q: äbä 12 Determine the resistor values in the circuit shown in Figure below for the indicated…

Q: Q2) A hydro-electric generating plant is supplied from a reservoir of capacity 20000000 m3 with a…

Q: (i) A 3-phase, 575V, 60 Hz, 100 hp electric motor has rated efficiency of 96%. What value of line…

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: L1 L2 L3 RESISTIVE HEATERS HR HR HH HR CONTROL TRANSFORMER THERMOSTAT HR HR A HR R

A: The thermostat in the above circuit is used to energize the coil HR. It is commonly used in the…

Q: Q.26: For the circuit shown Find: 1. Turn ratio "n" for max. power delivered to (20KQ) resistor. 2.…

Q: Two tram cars (A & B) 2 km and 6 km away from a sub-station return 40 A and20 A respectively to the…

Q: 14. A 220-volt electrical heater is used to warm 6Li/hr of water from 250C to 930C. Assume heat…

Q: Vin o V out + R1 150 kN R2 68 kN

A: SCHMITT TRIGGER: Schmitt triggers are hysteresis-based comparator circuits that use positive…

Q: Determine the current at which the Maynilad water pump is operating. The motor is said to be…

Q: I |(1) (2) (3) 10 2 52 V = 100 -<45° ( ww

A: By the complex power analysis

Q: 110 v dc motor draws a current of 30A and is located 500 ft from the power source. What is the…

A: Given: Voltage V = 110 V Current I = 30 A Length of the wire = 500 feet = 15240 cm Diameter = 0.25…

Q: A heater is required to give 1000 cal/min on a 200V dc circuit. What length of wire is required for…

A: Given, P=1000 cal/minV=200 VR=3 Ω/m

Q: Id:120200160 A current of 5 mA flowing through a DC motor when the applied voltage is 24 V. What (2)…

A: Given: For a DC motor Current, I=5 mA Applied voltage, V=24 V Back EMF, E=0 V (last digit of Id is…

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (d) the maximum…

Q: Thermal question. A system has two thermal layers. The first layer has a Rth 0.5 K/W, and Cth 0.8…

A: Thermal: Thermal refers to something that is caused or affected by heat or temperature. In science,…

Q: Two coils are connected in parallel acros 100-V supply mains take 1OA from the line The power…

Q: For any feasible combination of generators, the load will be dispatched based on a. Heat rate b.…

A: For a power system that contains number of generator , ' Equal incremental cost rule ' determines…

Q: A solenoid containing 8 coils produces 10 V of power. How many coils will produce 5 V? A. 2 B. 4…

A: In this question, We need to choose the correct options How many coils will produce 5 V?

Q: 00 Next Page Previous Page Question 32 (1 point) 1) Listen A 25 hp motor located 400 ft from a 240V…

A: The solution is given below.

Q: 1.By using NODAL ANALYSIS solve the following electric circuit. 201 1ov E (a)Calculate the current…

Q: A 40 HP load with a cross section of 35 mm ^ 2 and a length of 75 m from a copper line with an…

A: Given, Load power (Pout) = 40 HP = 40*746 = 29840 Watts Cross sectional area(A)= 35 square mm Length…

Q: 14.1 The power rating of a motor can be modified to account for different ambient temperature,…

A: Given data: Pe=10 kW a) At 50° C the variation of rated power is -12.5%. The actual power is given…

Q: Given f = 8 volts , d = 3 ohms , e = 1 ohms Determine VAB (not VBA)

A: From the given figure, total resistance between the path AB is,

Q: Q2: A: A hydro-electric station is operated with a mean head (h) of 30 m and consume (discharge…

A: In hydro electric power plant, the potential energy of water is used to generate electricity. It is…

Q: 5. A 230 V ampere-hour type meter is connected to a 230 V D. C. supply. If the meter completes 225…

Q: Two coils are connected in parallel across 100-V supply mains take 10A from the line. The power…

Q: 13. i) The data for a wind turbine is given below: Wind speed = 14 meters/sec, Length of blade = 10…

Q: A 300- kw alternator has an efficiency of 90 % at full load. Calculate the power losses?

Q: Q2) A hydro-electric generating plant is supplied from a reservoir of capacity 20000000 m3 with a…

Q: V Q₁ Dynamster type voltmeter with its Vollage coil Connected across the Load side teads 192 w. load…

A: Given: Power, P=192 WVoltage, V=208VResistance of the potenitial coil, R=3825Ω

Q: Set up and solve the system of equations for the currents in the branches of the given electric…

Q: efficiency of the motor.

Q: A 220-volt electrical heater is used to warm 6Li/hr of water from 250C to 980C. Assume heat…

Q: 14. i) Choose the correct statement for the wind turbine with blade length as 5 meters, operating…

Q: The power drawn by a resistive coil made of copper wire is 300 watts at 220 volts of 25 °C.…

Q: 9. The power taken by a 500 ft resistive coil made of copper wire is 250 Watts at 110 Volts.…

Q: Two coils are connected in parallel across 100-V supply mains take 10A from the line. The power…

Q: Two coils connected in parallel across 100 V supply mains take 10 A from the line. The power…

A: Given data, Voltage, V = 100 V. Current, I = 10 A. Power in one coil, P1 = 600 W. Let, Current I1…

Q: Example 1.3. A coil consists of 2000 turns of copper wire hav- ing a cross-sectional area of 0.8…

A: Given, A coil consist number of turns = 2000 Cross section area, A = 0.8 mm2 = 0.8×10-6 m2 Mean…

Concept explainers

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.

Question

A spring return solenoid valve is to be switched via pushbutton S1. Calculate the current
through the valve coil 1M1 if the voltage supply is 24V DC and the coil resistance is 48O.
What is the power consumption of the valve coil?
+24 V
Show your work:
13
S1E
14
IM1
Ov

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the ratio of V/F has been kept constant and the observed value of hysteresis loss at rated frequency of 50 Hz is 18 W, the measured value of core losses is 35 W, Find the total core losses at the frequency of 60 Hz.
Is this armature winding a progressive or a retro-progressive winding? W N Select one: 2 B 4' O a. Both O b. Progressive OC. Neither O d. Retro-progressive B S
A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?
An AC ammeter is connected in series with the primary winding of T1. What is the expected current reading? An AC ammeter is connected in series with the secondary winding of T1. What is the expected current reading? An AC ammeter is connected in series with R1. What is the expected current reading? NOTE: Idc for HW rectifier = 0.318 * Ipeak = 0.45 * Irms Describe/Explain briefly the purpose/use of the array (series-parallel) connection of the rectifier diodes in the given circuit.
• Each shunt field coil od DC -Generator produces 2,700 amp – turns. How many turns are there in the coil if the current is 1.5 amp?
Untitled Section Jalis 6 In d.c. generators armature reaction is produced by field current O armature current commutating winding current none of the mentioned compensating winding current *.The use of d.c. generators eliminated the use of rectifiers and ac supplies True False O
What are the two necessary conditions for a thyristor to begin conduction?and Once a thyristor begins to conduct, what condition(s) is necessary to cease conduction? Also, why is the conduction angle greater with an inductive load than with a purely resistive load?
b) A certain winding made up of copper has a resistance of 100 Q at room temperature. If resistance temperature coefficient of copper at 0 C° is 0.00428/C°, calculate the winding resistance if temperature is increased to 45 C°. Assume room temperature as 25 C°.
10. A potential difference of 250 V is applied to a field winding at 15-C and the current is 5 A. What will be the temperature of the winding when current has fallen to 3.91 A applied voltage being constant. Assume temperature coefficient at 15'C is equal to 1/254.5 per °C
How long a wire is needed to coil a spring having a mean diameter of 1 inch if there are 8 active coils?
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The coil of a generator has an equivalent resistance of 1.5 ohms at 20 °C. After being used for several hours, the resistance is found to be 1.75 ohms. Determine the temperature of the coils at this time. The temperature coefficient of resistance at 0 °C of the coil is 0.004 OC-1.
Ip Ep=40 V f = 60 Hz N₂= 20- N₁ = 120 Find the maximum flux om om = Find the magnitude of the induced secondary voltage Es Es = units + Is Es units If the coefficient of coupling (k)= 0.75, determine the magnitude of the induced secondary voltage Es Esk=0.75 = units