A square footing which carries an axial load of 132530 kg has its bottom resting on a ground water table at a depth of 2.5 m from the ground surface. Nc = 35, Nq = 22, Nγ = 19. Take PDRY = 1846 kg/m3 and PSAT = 1965 kg/m3, C = 1605 kg/m2. (Nc = 35, Nq = 22, Nγ = 19). Compute the required width of the footing using a factor of safety of 3.

A square footing which carries an axial load of 132530 kg has its bottom resting on a ground water table at a depth of 2.5 m from the ground surface. Nc = 35, Nq = 22, Nγ = 19. Take PDRY = 1846 kg/m3 and PSAT = 1965 kg/m3, C = 1605 kg/m2. (Nc = 35, Nq = 22, Nγ = 19). Compute the required width of the footing using a factor of safety of 3.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter16: Soil Bearing Capacity For Shallow Foundations

Section: Chapter Questions

Problem 16.13P: A square footing (B B) must carry a gross allowable load of 1160 kN. The base of the footing is to...

See similar textbooks

Similar questions

Refer to the rectangular combined footing in Figure 10.1, with Q1 = 100 kip and Q2 = 150 kip. The distance between the two column loads L3 = 13.5 ft. The proximity of the property line at the left edge requires that L2 = 3.0 ft. The net allowable soil pressure is 2500 lb/ft2. Determine the breadth and length of a rectangular combined footing.
A square footing is subjected to an inclined load as shown in the figure below. If the size of the footing ,B=2.25 m , determine the gross allowable inclined load , Q, that the footing can carry. Given:  = 120 andF.S = 3.5.
A strip footing shown is resting on loose sand has the following data (refer to figure h = 0.95 m Df = 1.9 m B = 1.8 m Unit weight of soil above GWT = 1750 kg/m3 Saturated Unit weight of soil = 1950 kg/m3 c = 12 kPa Angle of internal friction = 30 degrees Calculate the following: Net Allowable Bearing Capacity of the footing using Terzaghi’s assumption, kPa. Use FS = 2.5
Q/ for the circular footing 5m diameter . find the thickness of footing if (factor of safety = 3) . salty sand . Ƴsaturated = 19 kN/m3 C = 10 kN/m2 ƴd = 15 kN/m3
A square footing 2.8 m X 2.8 m is built on a homogeneous bed of sand of density 18 kN/m3 and ϕ = 36o. If the depth of foundation is 1.8 m, determine the safe load that can be applied on the footing.
A square footing 2.8 m X 2.8 m is constructed on a uniform bed of sand with a density of 18 kN/m3 and a slope of = 36o. Determine the safe load that may be applied to the footing if the foundation depth is 1.8 m.
A square footing 2.5 m X 2.5 m is built on a homogeneous bed of sand of density 19 kN/m3 having an angle of shearing resistance of 36o . The depth of foundation is 1.5 m below the ground surface. Calculate the safe load that can be applied on the footing with a factor of safety of 3.
A circular footing having a diameter of 1.47m has its bottom at a depth of 2.54 m from the ground surface. The water table is located at a depth of 1.09m below the ground. FS = 2.86 Properties of soil are as follows: Specific gravity, GS = 2.72 Void ratio, e = 0.19 Cohesion, c=20.20 kPa, Assume local shear failure and Terzhagi's Bearing Capacity Equation. Use the following bearing capacity factors: Nc' = 11.85 Nq' = 3.88 Ny' = 1.12 Calculate the following Net Allowable load on the footing, kN HINT: Use Dry unit weight for soil above the groundwater table. Unit weight of water = 9.81 kN/m² NOTE: ROUND OFF ONLY ON THE FINAL ANSWER
A long footing is shown in the figure. N꜀ = 17.69; Nq = 7.44; Nγ = 3.64. Which of the following most nearly gives the ultimate bearing capacity of the soil in kPa?
The ultimate bearing capacity of a strip footing is 1500 mm wide and 120 cm deep for a frictional cohesive soil, Use Terzaghi's formula at general failure condition. Take Nc= 57.80, Nq= 41.4, Nϒ= 42.4, ϒ = 18kN/m3, c= 15kN/m3
A square footing 2.5 m X 2.5 m is built on a homogeneous bed of sand of density 19 kN/m3having an angle of shearing resistance of 36o. The depth of foundation is 1.5 m below the ground surface. Calculate the safe load that can be applied on the footing with a factor of safety of 3. Take bearing capacity factors as Nc= 27, Nq = 30, Nγ = 35
A square footing (B B) must carry a gross allowable load of 1160 kN. The base of the footing is to be located at a depth of 2 m below the ground surface. If the required factor of safety is 4.5, determine the size of the footing. Use Terzaghis bearing capacity factors and assume general shear failure of soil. Given: = 17 kN/m3, c = 48 kN/m2, =31.