A steel cantilever beam is made of two T-shaped structures welded to each other as shown in the figure below. Determine the allowable load P that the block can withstand. Ignore the weight of the block. The allowable stresses are: 150 MPa in tension and compression t =100 MPa in shear in rolled materials, and q = 2 MN/m for joints. L1, L2 = 1m, 0,5m,

A steel cantilever beam is made of two T-shaped structures welded to each other as shown in the figure below. Determine the allowable load P that the block can withstand. Ignore the weight of the block. The allowable stresses are: 150 MPa in tension and compression t =100 MPa in shear in rolled materials, and q = 2 MN/m for joints. L1, L2 = 1m, 0,5m,

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter25: Testing And Inspection

Section: Chapter Questions

Problem 24R: What would be the transverse shear strength per inch of weld if a specimen that was 2.5 in. wide...

See similar textbooks

Similar questions

Change in length of CF? 18akN | g4q o 182 KN mm
Choices are: W690 X 125 W610 X 101 W530 X 82 W610 X 82
True or FALSE ? In the analysis of an eccentrically-loaded line weld, the secondary shear stress is always smaller in magnitude than the direct shear stress.
What would be the transverse shear strength per inch of weld if a specimen that was 2.5 in. wide withstood 25,000 lb?
The size of 1/2 in. would refer to the ______regard to copper tubing used in plumbing and heating. A. ID B. OD C. length D. fitting length
part B and C urgnt
Four inch schedule 80 steel pipes are used to transport high pressure steam. The pipe joints are to be butt-welded. The safe working fiber stress for butt welded pipes is 550 kg/cm2 . Calculate the maximum steam pressure the pipes can handle in kg/cm2 .
Material Strengths: Fy = 248 MPa, Fu = 400 MPa Method: Use ASD. A single angle L127X89X19 is welded (longitudinal and transverse welds) on one leg (shorter leg) togusset plate; thus, there are no holes. The length of the longitudinal welds is 150 mm. Which of the following most nearly gives the allowable tensile load?
The double-offset joint is typically used in applicationsthat require __ .a. higher operating angles and greater plunge depthb. lower operating angles and lower plunge depthc. higher operating angles and lower plunge depthd. lower operating angles and greater plunge depth
The design below is used for a bridge construction. All parts of the assembly are made of ASTM A36 steel and are welded with an E60 electrode. Under these conditions, the minimum size weld, according to table 20-4, should be: 5/16 3/16 3/8 1/4 1/2 5/8
Plz
A straight length of copper steam pipe 450mm ...