a stone is thrown from top of 35m tall bilding. The stone is thrown with an initail speed of 15 m/s at an angle 53 degrees above the horizintal. If air resistance is negligible, what is the angle at which the stone will hit the ground?

a stone is thrown from top of 35m tall bilding. The stone is thrown with an initail speed of 15 m/s at an angle 53 degrees above the horizintal. If air resistance is negligible, what is the angle at which the stone will hit the ground?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.50P

See similar textbooks

Related questions

Q: A parachute of hemi-spherical shape allows a parachute jumper of weight 90kg to descend with a…

A: A drag force is the resistance created when a body moves through a fluid like water or air. A drag…

Q: QI: The cart in the figure moves initially at velocity Vo-12 m/s and takes on water with a scoop 80…

Q: A helicopter during a test has its four blades turning at 89 rpm with the blades oriented parallel…

A: Given data:- length of blade=3.5m ρair=1.225 kg/m3 width of blade=200mm…

Q: 2-Air at 30 C over a flat plate at speed of 1.2 m/sec. Calculate the boundary layer thickness at…

Q: A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (P = 1258 kg/m and u = 1.49…

Q: A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (p = 1258 kg/m' and u = 1.49…

Q: A wind turbine with two or four hollow hemispherical cups connected to a pivot is commonly used to…

A: Given Data: The wind speed is: v=15 m/s. The diameter of the cup is: d = 8 cm The density of the…

Q: Thrust is required to propel an airplane at a fi nite forwardvelocity. Does this imply an energy…

A: The force that allows the aeroplane to move forward is the thrust force. Thus the thrust force is…

Q: Experimental studies have shown that the rate of the decay of kinetic energy for homogeneous…

A: Experimental studies have shown that the rate of the decay of kinetic energy for homogeneous…

Q: A ship is 150 m long and has a wetted area of 5000 m2.If it is encrusted with barnacles, the ship…

A: For seawater at 20ºC , take p=1025 kg/m3 v=0.00107 Kg/m.s. Convert 15kn=7.72 m/s. Now determine the…

Q: A bicycle rider tries to coast for 300 m to complete one full circuit of a nominally flat oval…

A: Given data: Here, mr represents the rider’s mass, mb represents the bike’s mass, and d represents…

Q: Siven: u=10 Ns/m², p =1.5 kg/m', L=2m,approach velocity U = 20 m/s. The oundary layer thickness is…

Q: The two spheres stand with a stop element as in the figure. The spheres are connected with…

A: Given: The specific gravity of steel ball= 5.98 The density of air= 1.225 kg/m3 The density of…

Q: A 5,000 lb airplane with wing area of 250 sq. ft and power available of 450 hp is at sea level…

A: Please find the answer below

Q: An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has…

A: Given data: Span length of air foil = 36 m Aspect ratio = 10 Speed, u = 150 m/s Altitude, h = 6000 m…

Q: **75. ssm A uniform rectangular plate is hanging vertically downward from a hinge that passes along…

A: Consider the diagram shown below for the horizontal position of plate. Here, FP is the pressure…

Q: D. A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (p = 1258 kg/m and u =…

Q: An airplane has a mass of 19,550 kg, a wingspan of 20 m,and an average wing chord of 3 m. When…

A: Given: The mass of an airplane is m=19550 kg. The density of the air is ρ=0.5 kg/m3. The wingspan of…

Q: A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (p = 1258 kg/m and u = 1.49…

Q: A glider weighing a 750lbf has a wing loading of 12Ibf/ft?. Its drag equation is: 2 C, = 0.010 +…

A: Given data Weight of glider = 750 lbfWing loading = 12 lbf/ft2CD = 0.010 + 0.22 CL2Launch is at 1500…

Q: The two spheres stand with a stop element as in the figure. The spheres are connected with…

Q: Calculate the velocity with air drag in m/s. Take the size across of the drop to be 3.8 mm, the…

A: Size across the drop, d= 3.8 mm= 0.0038 m Hence, radius, r= d2= 0.00382= 0.0019 m Density of air,…

Q: The Cessna Citation executive jet weighs 67 kN and has awing area of 32 m2. It cruises at 10 km…

A: The data given is, Weight of the jet, W = 67 kN Wing area, A = 32 m2 Lift coefficient, CL = 0.21…

Q: A dome is placed over a sports field to protect it from the winter. It is roughly semi-elliptical,…

A: The separation of flow occurs at the point where the flow transforms from laminar to turbulent…

Q: Skydivers, fl ying over sea-level ground, typically jump atabout 8000 ft altitude and free-fall…

A: Assumptions a) When they fall spread eagled Terminal velocity at 8000 ft can be determined as…

Q: In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required…

Q: An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has…

Q: The helium-filled balloon in Fig. is tethered at 20°Cand 1 atm with a string of negligible weight…

A: Write the properties of air at a given temperature.

Q: Consider a cylindrical copper rod in whích there is a unifom volumetric heating q = 12 kW/m³. The…

A: This is the case of crossflow over a smooth cylinder To determine the drag force one must know the…

Q: A light aircraft is flying at a speed of 60 m/s in ISA conditions for an altitude of 2000 m. The…

A: Given data: Calculate the Reynold number as follows:

Q: A square plate with edge length 9.10 cm and mass 488 g is hinged along one side. If air is blown…

A: The figure for the flow of air above and below the square plate is shown below. Apply Bernoulli's…

Q: An aircraft with symmetric airfoil of wing area 20 m2, flying with velocity 60km/hr experiences lift…

A: Given: Wing area is 20 m2. Velocity of the aircraft is 60 km.hr. Lift coefficient is 0.8.

Q: Sand particles (SG = 2.7), approximately spherical withdiameters from 100 to 250 μm, are introduced…

A: From Stole's law, we know that settling velocity (Vt) is given by : Vt = (2/9) * g * (⍴sand -…

Q: Use FoilSim to investigate how an aircraft wing produces lift and drag by changing the values of…

A: Given Foilsim To find Lift and drag conditions

Q: 8. A flat plate ( 1.5 m ) long and ( 1.5 m ) wide is towed in water (p = 1000 kg/m and v=1.31 * 10 “…

A: The given values are length l=1.5m, width b=1.5m, density ρ=1000kg/m3 , kinematic viscosity…

Q: Calculate lift, drag and (T/W) for an aeroplane with velocity 500 m/s, wing area 45 m2 , a drag…

A: Given, V = 500 m/s A = 45 m2 CD = 0.05 CL = 0.9

Q: e jet plane in Fig. 6–19a is in level flight with a constant speed of Om/s. Each of its two turbojet…

Q: A tiny particle of mass 4 x 10°4 kg (so fdrag = bv) has a drag coefficient, b = 3.3 x 10² kg/sec.…

A: Given data mass of particle (m) = 4*10-4 kg drag coefficient (b) = 3.3*10-2 kg /sec To determine…

Q: A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft2, and is traveling at…

Q: A thin sheet of fiberboard weighs 90 N and lies on a rooftop,as shown in Fig. . Assume ambient air…

A: For air density = 1.2 kg/m3. μ=1.8×10-5 Kg/ms Dimension are very large we will assume that the flow…

Q: A portion of ship’s hull can be idealized as a flat plate, 100ft long. If the ship’s velocity is 10…

A: Given data: L=100 ftv=10 ft/sρ=62.4 lbm/ft³µ=3.0 lbm/hr.ft Need to determine the maximum boundary…

Q: A wind turbine has a rotor diameter of 33 m (blade length of ~16.5 m) and an efficiency (power…

Q: 8. A flat plate ( 1.5 m ) long and ( 1.5 m ) wide is towed in water ( p = 1000 kg/m and v=1.31 * 10…

Q: 1 .Water at 15 ºC flows past a 1.5 mm radius small sphere at 5 cm/s. What is most nearly the drag…

A: Data given: Size of the sphere radius ,d= 1.5mm= 0.0015m cross sectional area =…

Question

Expert Solution

Step 1

$g i v e n h e i g h t o f t h e b u i d i n g H = 35 m i n i t i a l s p e e d U = 15 m / s A n g l e m a k e s w i t h h o r i z o n t a l a x i s θ = 53^{o}$

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance from the entrance to the point at which the hydrodynamic boundary layers meet.
Air at 1000C flows at an inlet velocity of 2 m/s between two parallel flat plates spaced 1 cm apart. Estimate the distance from the entrance to the point where the boundary layers meet.
Engine oil at 100C flows over and parallel to a flat surface at a velocity of 3 m/s. Calculate the thickness of the hydrodynamic boundary layer at a distance 0.3 m from the leading edge of the surface.
A jet flights with a speed of 291 m/s . If the jet's engine has a power of 1,462,823 W. what is the air resistance? Calculate answer to one decimal
A ship is 125 m long and has a wetted area of 3500 m2.Its propellers can deliver a maximum power of 1.1 MWto seawater at 20°C. If all drag is due to friction, estimatethe maximum ship speed, in kn.
An aircraft with symmetric airfoil of wing area 20 m2, flyingwith velocity 60km/hr experiences lift coefficient of 0.8. Considering the aircraft flying at sea level conditions, determine the mass of the aircraft.
. A bicyclist of mass 70 kg supplies 300 W of power while riding into a 3 m/s headwind. The frontal area of the cyclist and bicycle together is 0.36 m^2 , the drag coefficient is 0.88, and you can ignore rolling resistance. Determine the speed of the cyclist (assuming standard atmospheric conditions).
In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required to keep a 75 kg person suspended in the air in a horizontal position. The height of this person is 1.7m and the width is 38cm and the front drag coefficient is around 1. Atmospheric pressure and temperature inside the tunnel are Patm = 85kPa and T = 25C, respectively.
A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at 90 mi/h. How much power (in ft-lb/s) is required to overcome aerodynamic drag if air density is 0.002378 slugs/ft?
A bicycle rider tries to coast for 300 m to complete one full circuit of a nominally flat oval shaped “track” in an elementary school parking lot on a non-windy day with the air temperature at 20oC. The mass of the rider is 85 kg and the mass of the bike is 12.5 kg. How fast does the initial speed need to be to coast the desired 300 m? Is attaining this speed feasible (i.e., can the rider generate this speed by pedaling on horizontal surface)? Assume: •The rider crouches down a bit to reduce drag (as compared to sitting upright) •The rider cannot maintain balance if the speed gets below 0.1 m/s. •All resistance is due to wind drag
Qustion. An aircraft is flying in level flight at a speed of 200 km/h through air (density, p = 1.2 kg/m³, and viscosity, μ = 1.6 x 10-5 N-s/m²). The lift coefficient at this speed is 0.4 and the drag coefficient is 0.0065. The mass of the aircraft is 800 kg. The effective lift area of the aircraft NOTE= Do not give wrong answer I will dislike , If not sure skip it
A wind turbine with two or four hollow hemispherical cups connected to a pivot is commonly used to measure wind speed. Consider a wind turbine with four 1-cm-diameter cups with a center-to-center distance of 22 cm, as shown in Fig. 1. The pivot is stuck as a result of some malfunction, and the cups stop rotating. For a wind speed of 20 m/s and air density of 1.25kg/m3, determine the maximum torque this turbine applies on the pivot.