A stream moving with a speed of 0.7 m/s reaches a point where the cross-sectional area of the stream decreases to one-half of the original area. What is the water speed in this narrowed portion of the stream? m/s

A stream moving with a speed of 0.7 m/s reaches a point where the cross-sectional area of the stream decreases to one-half of the original area. What is the water speed in this narrowed portion of the stream? m/s

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 57PQ: Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the...

See similar textbooks

Related questions

Q: A vertical column of water will be supported to what height by standard atmospheric pressure? The…

A: h = 10.33 m

Q: Water flows at a rate of 800 cm3/min in a pipe of varying cross-sectional areas. Calculate the…

Q: 3. Water flows at a rate of 800 cm³/min in a pipe of varying cross-sectional areas. Calculate the…

Q: 4. Water flows through a pipe shown below at the rate of 30 liters per second. The absolute pressure…

A: Rate of water flow from A to B = 30 liter per second The absolute pressure at point A = 200 kPa…

Q: The small piston of a hydraulic lift has a cross-sectional area of 2.6 cm2 and its large piston has…

Q: The internal diameters of the horizontal pipe shown in the figure are 2.50 cm in both extremes. A…

Q: A soft drink (mostly water) flows in a pipe at a beverage plant with a mass flow rate that would…

Q: The small piston of a hydraulic lift has a cross-sectional area of 4.7 cm² and the large piston has…

A: Given data: Cross-sectional area of Small piston (A1) = 4.7 cm2 Cross-sectional area of large…

Q: Water is flowing in a pipe with radius of 25.4 cm at velocity of 5 m/s. The viscosity of water is…

A: Reynolds number is the measure of type of flow. Reynolds number gives the information about the…

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

A: Let d1 be the inner diameter of the cross-section of the larger horizontal pipe, and R be the flow…

Q: The small piston of a hydraulic lift has a cross-sectional area of 2.4 cm2 and its large piston…

A: Given Data: Small piston area, As=2.4 cm2=2.4×10-4 m2 Large piston area, AL=321.3 cm2=321.3×10-4 m2…

Q: Water flows straight down from an open faucet. The cross-sectional area of the faucet is 1.6 x 104m2…

Q: 10.0 cm 5.00 cm D1 D2 m/s. The speed of the water flowing in the Smaller channel with diameter D2 is

A: Here given the diagram with height of liquid. In first tube height is 10 cm and in second 5 cm. We…

Q: Water flows through a pipe at a rate of 0.58 m/s. If the pipe has a cross sectional area of 0.03142…

A: Apply volumetric flow formula.

Q: The mass flow rate and the volume flow rate are always the same value in a closed pipe. What is the…

A: Mass flow rate = density x volume flow rate

Q: A stream moving with a speed of 3.0 m/s reaches a point where the cross-sectional area of the stream…

Q: Water flows through a pipe shown below at the rate of 30 liters per second. The absolute pressure at…

Q: (8c14p65) A tank is filled with water to a height H, 40 m. A hole is punched in one of the walls at…

A: (a) H = 40 m, h =8.4 m voy =0ay =g From kinematic equation along y direction S =voy+(1/2)ayt^2 H -h…

Q: As water flows from a low elevation to a higher elevationthrough a pipe that changes in diameter,(a)…

Q: Calculate the radius of the horizontal pipe.

A: Poiseuille's Equation The volume per second V of a fluid of coefficient of viscosity η flowing…

Q: Water is flowing in a pipe with a cross-sectional area of 8m2 with a pressure of 210 000 Pa and…

A: The situation of the pipe is shown below.

Q: Water (η = 1.00E-3 Pa·s) is flowing through a horizontal pipe with a volume flow rate of 0.0132…

A: Find the gauge pressure.

Q: ....…...... A cylindrical bucket sitting on the edge of a table has a 3.20 mm diameter hole near the…

A: Solution:-

Q: A soft drink (mostly water) flows in a pipe at a beverage plant with a mass flow rate that would…

A: Part A Mass flow rate = density ×volume rate…

Q: Water flows through a horizontal pipe with a cross sectional area of 4m^2 at a speed of 5m/s with a…

Q: A stream moving with a speed of 1.2 m/s reaches a point where the cross-sectional area of the stream…

Q: Water flows through a pipe of cross-sectional area, A, at a rate of 4 kg/s. The pipe then narrows to…

Q: A cylindrical bucket sitting on the edge of a table has a 3.50 mm diameter hole near the bottom.…

Q: Water flows through a horizontal pipe with cross-sectional area of 4m^2 at a speed of 5m/s with a…

A: Given: Cross sectional area at point A, a1=4 m2 Speed of water flow at point A, v1=5 m/s Pressure at…

Q: The inside diameters of the larger portions of the horizontal pipe depicted in the figure below are…

Q: A liquid with a density of 1500kg/m flows in a horizontal pipe 11.5m long. The entrance pipe with a…

Q: Water flows in a horizontal pipe from wide to narrow portion. The wider portion area is 8 cm square…

Q: What is the pressure at the bottom of a dam if the water is 74 meters deep? remember what is on top…

A: Given that Depth of dam h=74m Atmospheric pressure P0=1.013×1055Pa

Q: The figure shows a stream of water in a steady flow from a kitchen faucet. At the faucet, the…

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

Q: The mattress of a water bed is 2.00 m long by 2.00 m wide and 30.0 cm deep.(A) Find the weight of…

A: Given data The length is, l=2.00 m The width is w =2.00 m The depth is d=30.0 cm Step 1 The volume…

Q: Fluid flows in a pipe of different radii: point A - 3 cm; point B – 1 cm; point C - 5 cm. If the…

A: the equation of continuity says,A1v1=A2v2where, A1=cross-sectional area of region 1 v1=flow velocity…

Q: Water flows to a pipe network as shown in the figure below. D1= 0.15 m V1= 2 m/s; D2 = 0.25 m V2 =…

Q: A tank filled with a water to a depth h . A hole of cross-section a at the bottom allows water to…

A: According to the equation of continuity, the speed of the water flows.

Q: Please help!

A: A=3.14 x 0.0025²=1.96x10^(-5)m²Then, speed of water through hose is given by…

Q: 2. Ethanol with a density of 789 kg/m? flows in the horizontal pipe 11.5m long. The entrance pipe…

Q: The intake in the figure has cross-sectional area of 0.84m ^ 2 and water flow at 0.35 m/s . At the…

A: Inlet cross sectional area is A1=0.84 m2 and water flow v1=0.35 m/s Outlet cross sectional area is…

Q: 10. Water flows at a rate of 730.0 liters/min through a horizontal 5.80-cm diameter pipe under a…

A: 10. Apply equation of continuity for the initial condition, then Q=A1v1730 ltr/min×1.66×10-5 m3/s1…

Q: 4. Aninclined pipe 10 cm in radius has a smooth reduction to a pipe 5 cmin radius as shownin figure.…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Use the equation of continuity for fluid flow

VIEW

Calculation to find the new speed.

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
, Water flows straight down from an open faucet (Figure 4.55). The cross-sectional area of the faucet is 1.8 10-4 ma, and the speed of the water as it leaves me faucet is 0.85 m/s. Ignoring air resistance, find the cross-sectional area of the water stream at a point 0.10 m below the faucet opening.
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the top, the cross-sectional area is 0.400 m2, and the pipe gradually widens so that its area near the ground is 0.800 m2. Water leaves the pipe at a speed of 16.8 m/s. What is the difference in the water pressure between the top and bottom of the pipe?
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
What force must exerted on the master cylinder of a hydraulic lift to support the weight of a 2000-kg car (a large car) resting on a second cylinder? The master cylinder has a 2.00-cm diameter and second cylinder has 24.0-cm diameter.
Why is it difficult to swim under water in the Great Salt Lake?
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?
Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to the atmosphere, even if the tubes are of different diameters.
Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is the flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
What force must be exerted on the master cylinder of a hydraulic lift to support the weight of a 2000-kg car (a large car) resting on the slave cylinder? The master cylinder has a 2.00-cm diameter and the slave has a 24.0-cm diameter.