I need help. A string is wrapped around a pulley with moment of inertia 0.35 kg-m2. The pulley rotates withoutfriction about a fixed axis. The string is pulled to give a constant torque of 3.1 kg-m²/s². If thepulley starts from rest, what is the instantaneous power, in W, being applied to the pulley after thestring has been pulled for 2.8 s?O 7769O 35O 2538

Moment of inertia = 0.35 kg-m2Torque = 3.1 kg-m2s2Using, torque = moment of inertia × angular…

A string is wrapped around a pulley with moment of inertia 0.35 kg-m2. The pulley rotates without friction about a fixed axis. The string is pulled to give a constant torque of 3.1 kg-m2/s?. If the pulley starts from rest, what is the instantaneous power, in W, being applied to the pulley after the string has been pulled for 2.8 s? O 77 O 69 O 35 O 25 O 38

A string is wrapped around a pulley with moment of inertia 0.35 kg-m2. The pulley rotates without friction about a fixed axis. The string is pulled to give a constant torque of 3.1 kg-m2/s?. If the pulley starts from rest, what is the instantaneous power, in W, being applied to the pulley after the string has been pulled for 2.8 s? O 77 O 69 O 35 O 25 O 38

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section8.2: Rotational Dynamics

Problem 29PP

See similar textbooks

Similar questions

A cylinder with rotational inertia I1=2.0kgm2 rotates clockwise about a vertical axis through its center with angular speed 1=5.0rad/s . A second cylinder with rotational inertia I2=1.0kgm2 rotates counterclockwise about the same axis with angular speed 2=8.0rad/s . If the cylinders couple so they have the same rotational axis what is the angular speed of the combination? What percentage of the original kinetic energy is lost to friction?
The blades of a wind turbine are 30 m in length and rotate at a maximum rotation rate of 20 rev/min. (a) If the blades are 6000 kg each and the rotor assembly has three blades, calculate the angular momentum of the turbine at this rotation rate. (b) What Is the torque require to rotate the blades up to the maximum rotation rate in 5 minutes?
Consider two objects with m1 m2 connected by a light string that passes over a pulley having a moment of inertia of I about its axis of rotation as shown in Figure P10.44. The string does not slip on the pulley or stretch. The pulley turns without friction. The two objects are released from rest separated by a vertical distance 2h. (a) Use the principle of conservation of energy to find the translational speeds of the objects as they pass each other. (b) Find the angular speed of the pulley at this time.
A bug of mass 0.020 kg is at rest on the edge of a solid cylindrical disk (M=0.10kg,R=0.10m) rotating in a horizontal plane around the vertical axis through its center. The disk is rotating at 10.0 rad/s. The bug crawls to the center of the disk. (a) What is the new angular velocity of the disk? (b) What is the change in the kinetic energy of the system? (c) If the bug crawls back to the outer edge of the disk, what is the angular velocity of the disk then? (d) What is the new kinetic energy of the system? (e) What is the cause of the increase and decrease of kinetic energy?
A cylinder with moment of inertia I1 rotates with angular velocity 0 about a frictionless vertical axle. A second cylinder, with moment of inertia I2, initially not. rotating, drops onto the first cylinder (Fig. P8.73). Because the surfaces are rough, the two cylinders eventually reach the same angular speed . (a) Calculate . (b) Show that kinetic energy is lost in this situation, and calculate the ratio of the final lo the initial kinetic energy. Figure P8.73
A baseball catcher extends his arm straight up to catch a fast ball with a speed of 40 m/s. The baseball is 0.145 kg and the catcher’s arm length is 0.5 m and mass 4.0 kg. (a) What is the angular velocity of the arm immediately after catching the ball as measured from the arm socket? (b) What is the torque applied if the catcher stops the rotation of his arm 0.3 s after catching the ball?
Suppose you start an antique car by exerting a force of 300 N on its crank for 0.250 s. What is the angular momentum given to the engine if the handle of the crank is 0.300 m from the pivot and the force is exerted to create maximum torque the entire time?
A particle has mass 0.5 kg and is traveling along the line x=5.0m at 2.0 m/s In the positive y-direction. What is the particle’s angular momentum about the origin?
The axis of Earth makes a 23.5 angle with a direction perpendicular to the plane of Earth’s orbit. As shown below, this axis precesses, making one complete rotation in 25,780 y. (a) Calculate the change in angular momentum in half this time. (b) What is the average torque producing this change in angular momentum? (c) If this torque were created by a pair of forces acting at the most effective point on the equator, what would the magnitude of each force be?
A diver off the high board imparts an initial rotation with his body fully extended before going into a tuck and executing three back somersaults before hitting the water. If his moment of inertia before the tuck is 16.9kgm2 and after the tuck during the somersaults is 4.2kgm2 , what rotation rate must he impart to his body directly off the board and before the tuck if he takes 1.4 s to execute the somersaults before hitting the water?
The reel shown in Figure P10.71 has radius R and moment of inertia I. One end of the block of mass m is connected to a spring of force constant k, and the other end is fastened to a cord wrapped around the reel. The reel axle and the incline are frictionless. The reel is wound counterclockwise so that the spring stretches a distance d from its unstretched position and the reel is then released from rest. Find the angular speed of the reel when the spring is again unstretched. Figure P10.71
A long, thin rod of mass m = 5.00 kg and length = 1.20 m rotates around an axis perpendicular to the rod with an angularspeed of 3.00 rad/s. a. What is the angular momentum of therod if the axis passes through the rods midpoint? b. What is theangular momentum of the rod if the axis passes through a pointhalfway between its midpoint and its end?