A student carried out the synthesis of aspirin as described using 3.0 g or salicylic acid and 6.0 ml of sccetic anhydide and abtained 1.306 g of asprin Calculate the theoreteical yield of aspirin Calculate the percent yield of aspirin.

Q: For Questions 20-24 consider the following scenario: A 0.8390 g of an unknown sample containing…

A:

Q: percent NaOH

A:

Q: Silver dichromate, Ag2Cr2O7, is insoluble.  It forms a brick red precipitate.  Calculate the mass of…

A:

Q: Given the mole ratio of HCl to NaOH is 1:1 in the balanced acid base reaction A 15.52mL sample of…

A: HCl   +   NaOH   →   NaCl   +  H2OMolarity of NaOH = 0.976 MVolume of NaOH = 32.08 mL = 0.03208 L

Q: Calcium bydroxide may be used to neutralize (completely react with) aqueous hydrochlcric acid.…

A: The balanced reaction will look like, 2HCl + Ca(OH)2 → CaCl2 + 2H2O It is given that,amount of solid…

Q: A 0.6L of a solution is prepared by dissolving 110g of NaF in it. The molecular weight of NaF is…

A: Given, Volume of NaF solution = 0.6 L Mass of NaF = 110 g Molecular weight of NaF = 41.9 g/mol

Q: When aqueous solutions of AgNO3 and NaCl are mixed together, the precipitate that will form is…

A: The answer to the following question is-

Q: When 12.00 mL of 0.183 M BaCl2 were mixed with 10.00 mL of 0.352 M of Na2C2O4, a student collected…

A:

Q: A 10.0 mL sample of household ammonia solution required 25.10 mL of 0.245 M HNO3 for neutralization.…

A: Formula used:  Molarity = 103* no of mole / V in L  So number of mole = MV  V = Volume    So the…

Q: During a tuning test an automobile engine consumes 4.40 × 10−3 mol of octane and 5.50 × 10−2 mol of…

A: A question based on mole concept, which is to be accomplished.

Q: Describe the properties andcomposition of various kinds ofsolutions.

A: Given :  To determine the properties and composition of various kinds of solution.

Q: If 121 grams of calcium chloride (CaO ere added to water to make 2 L of

A: Molarity is defined as number of moles of solute dissolved per liter.

Q: What is the mass (g) of the solute for the following: (a) 15.6 ml of 0.155m NaOH

A:

Q: Heat of Neutralization = Q/moles of limiting reactant = Q/moles of NaOH titrated at neutralization =…

A:

Q: One of the main components of hard water is CaCo,. When hard water evaporates, some of the CaCO, is…

A: Given, 1.00 × 102   mg of CaCO3

Q: Silver in an ore is determined gravimetrically by precipitating the silver as silver chloride. What…

A:

Q: Ibuprofen, widely used as a pain reliever, has a limited solubilityin water, less than 1 mg>mL.…

A: The considered chemical compound is ibuprofen.

Q: The following neutralization reaction occurs in the         classroom.HCl  +  KOH  -->  H2O  +  KCl…

A: Given: Volume of KOH = 25.0mL Molarity of KOH = 0.5 M Volume of HCl = 15.0 mL

Q: A 6.221-g sample containing magnesium chloride and sodium chloride was dissolved in sufficient water…

A:

Q: A solution is prepared by dissolving 23.0 g of KCI in 100.0 mL of water. Assuming the density of…

A:

Q: A Study of Intermolecular Forces of Attraction rofessor Rowan is preparing for his experiment in…

A: Intermolecular forces of attraction are the forces which helds between two molecules.

Q: What mass of AgNO3 can be dissolved in 250g of water if the solubility is 2.22x105g/L?

A: Mass of water= 250 g  Solubility = 2.22 x 105 g/L The density of water = 1 g/mL The volume of water…

Q: A sample of 7.75 g of Mg(OH)2 is added to 25.0 mL of0.200 M HNO3. (a) Write the chemical equation…

A: (a) The chemical equation for the reaction that occurs when a sample of 7.75 g of Mg(OH)2 is added…

Q: CALCULATE THE NEW MOLARITY (M) WHEN 250. ML OF WATER IS ADDED TO 5.25L OF 0.101 M HNO3 (DILUTION)

A: Dilution :-  When a solution of molarity M1 and volume V1 is diluted by adding water to form a…

Q: Suppose 30.0 ml. of 0.100 M Pb(NO-h is added to 60.0 ml. of 0.150 M KI. How many grams of Pbl2 will…

A: Solutions-  Given data- 0.100M Pb(NO3)2, 0.150M KI, Volume = 30.0 ml Pb(NO3)2, 60.0 ml of KI.

Q: calculate for the standardized concentration of sodium hydroxide  (MM of KHP = 204.2 g/mol) using…

A:

Q: A generic salt, AB3, has a molar mass of 253 g/mol and a solubility of 8.70 g/L at 25 °C. What is…

A:

Q: Complete the table below by deciding whether a precipitate forms when aqueous solutions A and B are…

A: SOLUTION  A SOLUTION  B PRECIPITATE FORMATION EMPIRICAL FORMULA SODIUM SULFIDE  ZINC SULFATE…

Q: The titration of 0.9297 g of KHP (molar mass=204.227 g/mol) requires 41.02 mL of NaOH solution, What…

A: Given: Mass of KHP = 0.9297 g Volume of NaOH = 41.02 mL Molar mass of KHP = 204.227 g/mol

Q: Suppose a 250. mL flask is filled with 1.3 mol of SO, and 1.6 mol of SO3. This reaction becomes…

A: The concentration of the substance is equivalent to the ratio of the moles of substance to the…

Q: How many moles of precipitate will be formed when 70.0 mL of .150 M AgNO3

A: You have molarity of AgNO3 = 0.15 M Volume  of AgNO3 = 70.0 mL = 0.07 L You know that Precipitation…

Q: Calculate the mass (g) of HC2H3O2 in vinegar (moles HC2H302 X Molar Mass HC2H302) mol Calculate %…

A:

Q: Complete the table:                                        A                  +      2B…

A: Assuming x moles of A is reacting in the above reaction. Since from the balanced reaction, we can…

Q: A solution was prepared by dissolving 38.0 g of KCl in 225 g of water. Calculate the mole draction…

A: Calculate number of moles of KCl and water:

Q: when solutions of Na2S and FeCI3 are mixed, What is the for the solid formed?

A: When solutions of Na2S and FeCI3 are mixed, then Fe2S3 is in solid form and NaCl in aqueous form.

Q: Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a…

A:

Q: A www-awn.aleks.com odic table -.. O Favorites - YouT... TV fuboTV - Watch... ALEKS - Caliyah... G…

A: Given  Molarity = 0.744 M Volume = 485 ml

Q: The reaction between 50.0 mL of 0.325M solution of potassium sulfide and 50.0 mL of 0.125 M…

A: Given: Volume of potassium sulfide = 50.0 mL Concentration of potassium sulfide = 0.325 M Volume of…

Q: 25.0g of iron III hydroxide is mixed with 125 mL of water which is the solute

A: In a solution the solute is present in less amount than the solvent.

Q: A 25.190 g sample of aqueous waste leaving a fertilizer manufacturer contains ammonia. The sample is…

A: Since you have posted multiple questions, the answer for first question is given below. Kindly…

Q: "hat is the molarity of a barium chloride solution prepared by dissolving 2.50 g of BaCl2-2H2O in…

A: Introduction :  Molarity (M) is defined as the number of moles of solute dissolved in one litre of a…

Q: Suppose a 250. mL flask is filled with 0.50 mol of H, and 0.90 mol of Hl. This reaction becomes…

A: Given: Volume of flask = 250 mL = 0.250 L                                     (Since 1 L = 1000 mL)…

Q: Write molecular and net ionic egquetins for the following reactions. CInclude state symbpls, balan…

A: Interpretation-  To write the molecular and net ionic equation for the following reactions -  When…

Q: ml of sodium carbonate solution 250 contains 2.65g of Na2CO3. If 10 ml of the solution is diluted…

A:

Q: Write a balanced equation for the double-replacement precipitation reaction described, using the…

A: Calcium chloride is CaCl2 and potassium sulfate is K2SO4. In a double displacement reaction, ions…

Q: How many milligrams of sodium sulphide are needed to completely react with 25.0 mL of a 0.0100 M…

A: Balanced chemical reaction between sodium sulphide and cadmium nitrate is given by,

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.