A student doing Young’s experiment finds that the distance between the central bright fringe and the 11th nodal line is 4.2 cm. If the screen is located 3.3 m from the two slits, whose separation is 3.3 x10-4 m, what is the wavelength of the light measured in nm?

A student doing Young’s experiment finds that the distance between the central bright fringe and the 11th nodal line is 4.2 cm. If the screen is located 3.3 m from the two slits, whose separation is 3.3 x10-4 m, what is the wavelength of the light measured in nm?

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter3: Interference

Section: Chapter Questions

Problem 31P: In a double-slit experiment, the fifth maximum is 2.8 cm from the central maximum on a screen that...

See similar textbooks

Related questions

Q: 16 Light of wavelength 659.0 nm is emitted by a star. The wavelength of this light as measured on…

A: The objective of this question is to determine the velocity of the star with respect to Earth using…

Q: 3. A projectile is launched at an angle of 22° and lands 45seconds later on the floor. (a) What is…

A: Launch angle is Time taken by object to reach the floor or time of flight of projectile motion is…

Q: Problem 1 (25%) An infinite plane slab of thickness 2d (the slab is located between z=-d and z=d)…

A: The objective of the question is to find the electric field as a function of z inside and outside…

Q: The first active volcano observed outside the Earth was discovered in 1979 on lo, one of the moons…

Q: 13. What is the magnetic force (in Newtons) on the CF segment of the current loop given in the…

Q: proton moves in a helical path at speed v = 5.90 × 107 m/s high above the atmosphere, where Earth’s…

Q: A person is sitting at the very back of a canoe of length L, when the front just bumps into the…

Q: 4. In one type of mass spectrometer, ions having the same velocity move through a uniform magnetic…

A: The objective of the question is to find the diameter of the orbit of C-14+ ions in a mass…

Q: week 5 # 8 In a heat engine, 2.40 mol of a monatomic ideal gas, initially at 4.00 atm of pressure,…

A: The objective of the question is to find the heat flow into or out of the gas during the third…

Q: A door weighing 310.0 N measures 2.00 m x 3.00 m and is of uniform density; that is, the mass is…

A: The value of P is 7.50.The value of Q is 310.0.The position of forces acting on the door is shown…

Q: 1.9µE capositor ared a 6.0µE capositor are connected in parallel across a 240V potential difference.…

A: Capacitor 1 = C1 = 1.9 uF = 1.9 × 10-6 FCapacitor 2 = C2 = 6.0 uF = 6× 10-6F V = 240 V

Q: At which of the following times is the acceleration of the object in Fig. 2.1 negative? Select One…

A: Option (d) is correct answer.

Q: Question 4: Consider the double-slit experiment setup shown in the figure below. Determine the value…

Q: Problem 4 For the parts the below question, fill in the empty boxes with your answer (YOUR ANSWER…

A: The refractive index of soybean film nso= 1.473 Thickness d = 1180 nm

Q: An escape lane is an emergency area to slow down a vehicle in case of a brake failure. The following…

A: Mass of the truck , m=2500 kgInclination of ramp 10°Distance covered by truck , s=196 mAcceleration…

Q: The zoo is building a new polar bear exhi swimming tank. (Note: picture is not to sw

Q: A cannon ball is fired upwards from the ground at a speed of 30ms-¹. (c) What will be the speed at a…

A: Initial speed of the ball is u = 30 m/s.Let the final speed of the ball is v m/s.Height is given h =…

Q: What is the smallest thickness & of an optical coating whose nda of refraction is n coating = 1.38…

Q: How many meters are there in 3.2 light year (s), if the speed of light is 3 x 108 m/s. This number…

Q: Alan leaves Los Angeles at 8:00 a.m. to drive to San Francisco, 400 mi away. He travels at a steady…

Q: A voltmeter indicates that the potential at a location between two parallel conducting plates is 7.7…

A: The objective of this question is to find the distance of the measurement location from the negative…

Q: 1. Piston A has a cross section of 1,600 cm³ while that of B is 950 cm². B is higher that A by 2.6…

A: Cross-section of piston A is Cross-section of piston B is Height difference between piston A and B…

Q: 2. A 1.5 μC charge, with a mass of 8.2 x10-¹3 kg is shot through a 10 cm long parallel plate…

Q: A very long cylindrical pipe of radius R is cut into two halves lengthwise as shown in the figure.…

A: Potential of upper half of cylinder ispotential of lower half of cylinder is

Q: The mass defect associated with a fusion reaction is 3.20 x10 the amount of energy,in MeV, released…

A: The objective of this question is to calculate the amount of energy released in a fusion reaction…

Q: What is the magnitude of the vector coordinates (-5, 12)? a. 13 b. 12 c. 11 E. Other: d. 10

Q: Question 3 If the magnitude of the resultant force acting on the bracket is 2.1 kN directed along…

Q: State, in both words and equations, the two conditions that must be satisfied for a rigid body to be…

A: The objective of the question is to identify the two conditions that must be met for a rigid body to…

Q: what are the possible features of a smart shoes that can detect pace factor?

A: The question asks about the possible features of smart shoes that can detect pace factor. It's…

Q: Practice 2

A: The objective of the question is to find the induced electromotive force (emf) across the…

Q: Can you help me find the slope of the image I'll attach below?

Q: A circular loop of radius 10 cm carries a current of 2 A. Calculate the magnetic field at the center…

A: Radius of the circular loop (r) =10 cm =0.1m Current through the loop (I) = 2A

Q: A 5.0 μC point charge is placed in an external uniform electric field that has a magnitude of 63000…

A: Write the given values with the suitable variables.Here, q and E are the charge and the magnitude of…

Q: A solenoid has a length of 0.5 meters, 200 turns, and carries a current of 3 amperes. Calculate the…

A: Length of solenoid (L): 0.5 metersNumber of turns per unit length (n) : This information is not…

Q: A satellite in orbit around Earth is exposed to radiation from the Sun. This radiation may cause the…

A: The objective of the question is to determine which of the given wavelengths of light would cause a…

Q: For which of the following explanations did the diffraction of high-speed electrons provide…

A: The question is asking for which theory the diffraction of high-speed electrons provides…

Q: The best rebounder in basketball has a vertical leap of about 114.06 cm. What is his total time in…

A: The vertical height attained by the object is Note:Find:Total time of object in the air.

Q: a wooden cube of unknown density, measured 10x10x10 cm across is pushed down by a force of 5N down…

Q: Section (A): Type of forces, Newton's third law, Free body diagram : A-1. Which type of forces does…

A: Note: “Since you have posted a question with multiple sub parts, we will provide the solution only…

Q: It is possible to charge a balloon to several thousand volts using electrostatics, for example, by…

A: It is possible to charge a balloon to several thousand volts using electrostatics, for example, by…

Q: Two identical blocks, A and B, are released from rest at the same height, as shown in the figure…

A: The objective of this question is to determine the speed of two blocks, A and B, as they slide down…

Q: 2. Determine the angular momentum of the Earth (a) about its rotation axis (assume that the Earth is…

A: Average translational speed of Earth around Sun is: 30,000 m/s.We know that angular momentum =

Q: MIXING PRoblem FOR Mixing E.C. on Dec 14th. I COR6: Mix: 20kg H₂O(l) at 80°C with 1.0kg at 20°c. T₁…

A: The equation for heat transfer is given by the formula:where: is the heat transfer, is the mass of…

Q: Kinetic energy is 0.111T, Mass is 100,000kg. Calculate the speed

A: The objective of the question is to calculate the speed of an object given its kinetic energy and…

Q: How many cm in half a meter ?

A: The metric system is a decimal-based system of measurement where units are related by powers of 10.…

Q: Determine whether each of the following equations is dimensionally CORRECT or INCORRECT. Show your…

Q: What is the difference between velocity and acceleration, and how are they related?

A: The dynamics of motion are distinguished by velocity and acceleration, two essential notions in…

Q: with Tow Force pull the box, the first forc 5₁-400N angle 25 and the seconed force F₂ = 200 N with…

Q: 78° 60° 45° 30° Which of the following angles has the highest vertical distance? a. 30° b. 45° c.…

A: Since you have asked multiple question, we will answer the first question for you. If youwant any…

Q: Consider the symmetrically arranged charges in the figure, in which qa= qb= -3.65 µC and qe = qd =…

Question

A student doing Young’s experiment finds that the distance between the central bright fringe and the 11th nodal line is 4.2 cm. If the screen is located 3.3 m from the two slits, whose separation is 3.3 x10^-4 m, what is the wavelength of the light measured in nm?

Video Video

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Calculation of the wavelength

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Consider a single-slit diffraction pattern for =589 nm, projected on a screen that is 1.00 m from a slit of width 0.25 mm. How far from the center of the pattern are the centers of the first and second dark fringes?
For 600-nm wavelength light and a slit separation of 0.12 mm, what are the angular positions of the first and third maxima in the double slit interference pattern?
Monochromatic light is incident on a pair of slits that are separated by 0.200 mm. The screen is 2.50 m away from the slits. a. If the distance between the central bright fringe and either of the adjacent bright fringes is 1.67 cm, find the wavelength of the incident light. b. At what angle does the next set of bright fringes appear?
If the separation between the first and the second minima of a single-slit diffraction pattern is 6.0 mm, what is the distance between the screen and the slit? The light wavelength is 500 nm and the slit width is 0.16 mm.
Eight slits equally separated by 0.149 mm is uniformly illuminated by a monochromatic light at =523 nm. What is the width of the central principal maximum on a screen 2.35 m away?
Using the result of the problem two problems prior, find the wavelength of light that produces fringes 7.50 mm apart on a screen 2.00 m from double slits separated by 0.120 mm.
What is the angular width of the central fringe of the interference pattern of (a) 20 slits separated by d=2.0103 mm? (b) 50 slits with the same separation? Assume that =600 nm.
A beam of monochromatic green light is diffracted by a slit of width 0.550 mm. The diffraction pattern forms on a wall 2.06 m beyond the slit. The distance between the positions of zero intensity on both sides of the central bright fringe is 4.10 mm. Calculate the wavelength of the light.
Eight slits equally separated by 0.149 mm is uniformly illuminated by a monochromatic light at =523 nm. What is the intensity of a secondary maxima compared to that of the principal maxima?
At what angle is the first-order maximum for 450-nm wavelength blue light falling on double slits separated by 0.0500 mm?
Consider the single-slit diffraction pattern for =600 nm, D=0.025 mm , and x=2.0 m. Find the intensity in terms of Io at =0.5 , 1.0°, 1.5°, 3.0°, and 10.0°.
In Figure P27.7 (not to scale), let L = 1.20 m and d = 0.120 mm and assume the slit system is illuminated with monochromatic 500-nm light. Calculate the phase difference between the two wave fronts arriving at P when (a) = 0.500 and (b) y = 5.00 mm. (c) What is the value of for which the phase difference is 0.333 rad? (d) What is the value of for which the path difference is /4?