A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.

A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.3P: A transmission-line cable with a length of 2 km consists of 19 strands of identical copper...

See similar textbooks

Similar questions

One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for commercial bare-aluminum electrical conductors lists a 60 Hz resistance of 0.0080 ohm per kilometer at for a 793-MCM AAC conductor. Determine the cross-sectional conducting area of this conductor in square meters. Find the 60 Hz resistance of this conductor in ohms per kilometer at 50C.
A transmission-line cable with a length of 2 km consists of 19 strands of identical copper conductors, each 1.5 mm in diameter. Because of the twist of the strands, the actual length of each conductor is increased by 5. Determine the resistance of the cable if the resistivity of copper is 1.72-cm at 20C.
Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All strands have the same radius r.
Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.
What are the colors of the conductors in nonmetallic-sheathed cable for a. 2-wire cable? _______________, _______________ b. 3-wire cable? _______________, _______________, _______________
A 60-Hz, single-phase two-wire overhead line has solid cylindrical copper conductors with a 1.5 cm diameter. The conductors are arranged in a horizontal configuration with 0.5 m spacing. Calculate in mH/km (a) the inductance of each conductor due to internal flux linkages only, (b) the inductance of each conductor due to both internal and external flux linkages, and (c) the total inductance of the line.
Does r=e14r=0.788r, which comes in calculation of inductance, play a role in capacitance computations? Yes No
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please
Derives and analyse relation of capacitance for 3-core cables ? proper explanation in details
Determine the inductance per unit length of a coaxial cable with an inner radius a andouter radius b
Besides the number of turns and the legth of active conductor, whit of the following is?are a factor which affects the amount of emf(voltage) induced in a coil? A) how fast the conductor is moving through the field(rate of incidence), B) the strength of the magtnetic field(flux density), C) the angle at which the conductor is cutting the magnetic field( angle of incidence), D) all of the above What is mean by genarator regulation? A) it is the percentage rise in terminal voltage from no-load to full-load, B) it is the percentage rise in terminal voltage full-load to no-load, C) it is the amount of control one has over the terminal voltage by way of the field excitation, D) none How are transformer components indetified? The algebraic symboly for the number of kilovolt-amperes on the load side of the transformer is_____. A) KVAh, B) KVAx, C) KVA-primary, D) KVA-secondary
Theoretically solve an unknown resistance for Transmission line conductor by using any two methods (for example: Wheatstone bridge, Kelvin bridge, Potentiometer method etc). And then compare them and state that between in this two used methods which one is better and why. [Note: You can choose any practical value for ratio arms]