A tube-well of 20 cm of diameter fully penetrate a horizontal, homogeneous and isotropic confined aquifer of infinite horizontal extent. The aquifer is of 30 m uniform thickness. A steady pumping at the rate of 40 litres/s from the well for a long time results in a steady drawdown of 4 m at the well face. The subsurface flow to the well due to pumping is steady, horizontal and Darcian and the radius of influence of the well is 245 m. The hydraulic conductivity of the aquifer (in m/day, round off to integer) is

A tube-well of 20 cm of diameter fully penetrate a horizontal, homogeneous and isotropic confined aquifer of infinite horizontal extent. The aquifer is of 30 m uniform thickness. A steady pumping at the rate of 40 litres/s from the well for a long time results in a steady drawdown of 4 m at the well face. The subsurface flow to the well due to pumping is steady, horizontal and Darcian and the radius of influence of the well is 245 m. The hydraulic conductivity of the aquifer (in m/day, round off to integer) is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A confined aquifer of 10 m thickness, and 16.43 m/day hydraulic conductivity is fully penetrated by a pumping well of 0.5 m radius operating at Q = 245 m/day. Determine the draw-down under steady state conditions in the pumping well and 50 m away from the well. Take the radius of influence of the pumping as 300 m
In a confined aquifer, a 50-cm diameter well fully penetrates the aquifer. The hydraulic conductivity of the aquifer was approximately 0.8 m/day. Originally the piezometric head was 300 m above the top of the aquifer, which is 30 m. thick. If 0.8 m³ / min. is pumped from the well, what should be the depth of water in the well? What will the height of the piezometric head be ( above the top of the aquifer ) at a distance of 50 m. from the well? Assume the radius of influence to be 1000 ft.
An uncontined aquifer of(1000)m length having a(k) value of (0.7)m/d is subjected to two sources,the totle head of which are (60)m (at x=0)and (50)m at x=1000m Determine q per unit width of aquifer velocity of flow at x=500m and the heigth of the water table surface at x=500m
5.Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic jump upstream depth 0.2 m. Determine :the rate of energy loss due to hydraulic jump.
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic metres per minute is pumped out of the aquifer through a tubewell till the water level in the tubewell becomes steady. Two observation wells at distances of 15 m and 70 m from the tubewell show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability in mm/s of the aquifer. a.3.28 x 10^-1 b.4.68 x 10^-1 c.2.58 x 10^-1 d.1.18 x 10^-1
Consider a confined aquifer with a thickness of 12 m and hydraulic conductivity of 20 m/day. This aquifer is fully penetrated by a pumping well having a radius of 0.4 m and is operating at a discharge of 550 m3/day. Calculate the drawdown under steady-state condition in the pumping well and at a point located 41 m away from the well. Assume the radius of influence of the pumping is 310 m.
3b A confined aquifer 12.0m thick has a piezometric surface 25.0 m above the bottom confining layer. Groundwater is being extracted from a 0.2 m diameter fully penetrating well. The pumping rate is 0.150 m3/min. The aquifer is relatively sandy and has a hydraulic conductivity of 230 m/d. Steady-state drawdown of 1.8 m is observed in a monitoring well 4.0 m from the pumping well. Calculate: i. The drawdown in the pumping well ii. The radius of influence of the pumping well
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic meters per minute is pumped out of the aquifer through a tube well till the water level in the tube well becomes steady. Two observation wells at distances of 15 m and 70 m from the tube well show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability of the aquifer (mm/s).
2. A confined aquifer has a thickness of 85 ft. An 86-in diameter well drilled to the bottom of the aquifer, as shown in fig 3-10, if the hydraulic conductivity of the aquifer is 10 ft / day, and if water is originally 170 ft deep in the well, calculate approximately the maximum rate of flow that can be pumped from the well without dewatering any part of the aquifer. Assume 1000 ft reasonable value for the radius of influence. What will be the average velocity ( Darcy velocity ) of flow in the aquifer at a distance 20 ft from the center of the well?
A concrete dam is 30 m long from upstream side to downstream end. The dam is situated on a 15-m-thick stratum of soil that has a coefficient of permeability equal to 0.5 m per day. Firm, hard clay and rock underlies thedescribed soil stratum. The base of the dam is installed at a level 2 m below the natural soil surface. Draw the flow net for seepage occurring beneath the dam, and compute the seepage in cubic meters per day per meter ofdam width (perpendicular to the paper), for the condition where the reservoir water against the upstream face of the dam is 18 m above the soil surface and the water level at the downstream end is at the soil surface.
Calculate the transmissivity of the confined aquifer if the flow is along the strata consist of a 3 layers. The upper layer consist of gravel of 400 cm having hydraulic conductivity of 2.0 cm/sec. The middle layer consists of the fine sand of thickness 300 cm, having hydraulic conductivity of 0.002 cm/sec. The bottom layer consists of coarse sand of thickness 400 cm, having hydraulic conductivity of 0.01 cm/sec.
A confined aquifer is recharged by a continuous supply of water from the certain source. The average thickness of the aquifer was determined to be 25 m and the average width is 4 km. The hydraulic conductivity of the aquifer was obtained at 40 m/day and its void ratio is 0.3333. The piezometer heads in two wells 1.325 km apart are 65 meters and 60 meters from a common reference datum. Determine the rate of flow in cubic meters per day.