A uniform rod is set up so that it can rotate about an axis at perpendicular to one of its ends. The length and mass of the rod are 0.893 m and 1.19 kg, respectively. A force of constant magnitude F acts on the rod at the end opposite the rotation axis. The direction of the force is perpendicular to both the rod's length and the rotation axis. Calculate the value of F that will accelerate the rod from rest to an angular speed of 6.31 rad/s in 8.87 s.

Q: Part A. Compute the torque developed by an industrial motor whose output is 175 kW at an angular…

A: PART AGiven that the power of the motor is 175kW, and the angular speed is 5000rev/min. The…

Q: A disk of mass 2.00 kg and diameter 50.0 cm is rotating without slipping across a level floor at a…

A:

Q: A water wheel with radius Rw = 1.1 m and mass Mw = 1.7 x 103 kg is used to power a grain mill next…

A:

Q: Re As shown below, a hollow cylinder with a mass 0.354 kg and an inner radius of 20 cm and an outer…

A: Moment of inertia of a hollow cylinder of mass M with inner radius "a" and outer radius "b" is given…

Q: A bowling ball has a mass 4 kg, a moment of inertia of 1.6 x 10-2 kg x m2 and a radius of 0.1 m. If…

A: Total energy is sum of rotational and translational energy ETot=ERot+ETran=12Iω2+12mv2=12Ivr2+12mv2…

Q: A turntable with a moment of inertia of 0.028 kg∗m^2 rotates freely at 3.3 rad/s. A circular disk of…

A: Given data The initial moment of inertia of the turntable is Ii_t = 0.028 kgm2 The initial angular…

Q: A uniform rod is set up so that it can rotate about an axis at perpendicular to one of its ends. The…

A: L = 0.877 m m = 1.23 kg Initial angular velocity = 0 rad/secFinal angular velocity = 6.61 rad/sec…

Q: A uniform, solid sphere with a radius of 0.20 m and a mass of 0.50 kg rolls without slipping on a…

A: The formula for the moment of inertia of a solid sphere is: The formula for the total kinetic…

Q: A disk of mass 2.00 kg and diameter 50.0 cm is rotating without slipping across a level floor at a…

A:

Q: Rigid rods of negligible mass lying along the y axis connect three particles. The system rotates…

A: Total kinetic energy is,

Q: three 0.0100 kg particles have been glued to a rod of length L= 6.00 cm and negligible mass and can…

A:

Q: Two wheels of moment of inertia 8.6 kg.m and 13 kg m² are set in rotation with angular speed 2.1…

A: The situation provided in the question reassembles the condition of inelastic collision. Thus, apply…

Q: While spinning down from 500.0 rpm to rest, a solid uniform flywheel does of work 51 KJ. If the…

A: initial angular speed (ω) = 500 rpm= 500×2π60 = 52.36 radsec final angular speed (ωf) = 0 rpm work…

Q: A heavy swing door has a mass of  m = 8,000 kg,  a width  w = 1.0 m,  and a height  H = 3.9 m.…

A: a) The required net torque is,

Q: Two uniform solid cylinders, each rotating about its central (longitudinal) axis, have the same mass…

A:

Q: A 5 kg ball with a 0.4 meter radius is rolling on a horizontal surface at 3 m/s. The rotational…

A: This question is based on law of conservation of energy and pure rolling motion.

Q: E) 4.32 kJ

A: Ans: E) 4.32 KJ Refer attachment

Q: In the figure here, a solid brass ball of mass 0.284 g will roll smoothly along a loop-the-loop…

A:

Q: 9.0 kg 1.0 m 1.2 kg 2.0 m 2.5 kg

A:

Q: propeller is modeled as five identical uniform rods extending radially from its axis. The length and…

A: Length l = 0.705 m Mass m = 2.91 kg  Angular speed = 553 rpm                 = 553 × 2π /60…

Q: A uniform rod is set up so that it can rotate about an axis at perpendicular to one of its ends. The…

A: Length of rod = 0.873 m  Mass of rod = 1.11 kg  Initial angular velocity = 0 rad/sec  Final angular…

Q: A torque of 170 N.m does 3420 J of work on a rotating flywheel. If the flywheels initial kinetic…

A:

Q: A centrifuge has a rotational inertia of 5.50 × 10−3 kg m2. How much energy must be supplied to…

A:

Q: As shown below, a hollow cylinder with a mass 0.318 kg and an inner radius of 20 cm and an outer…

A:

Q: A uniform rod of mass 0.7 kg and length 2.1 m is free to rotate about one end. If the rod is…

A: The center of mass of the rod (H) is located above the horizontal. The equation of center of mass of…

Q: Three point masses ma, mB and mc are located in the x-y plane at points A, B and C as shown in…

A:

Q: At one instant, a force acts on a 0.5 kg object that has a position vector r⃗ = (3.0 î− 2.0 k̂) m…

A:

Q: A uniform disk of mass 15.0 kg and radius 0.200 m is spinning around an axis through its center and…

A: Given quantities: mass of the disk (m) = 15.0 kg radius of the disk (r) = 0.200 m w(t) = 3t + t2…

Q: A simple pendulum is formed of a rope of length L = 1.6 m and a bob of mass m. When the pendulum…

A: Length of the rope,l=1.6 m Angle=10⁰ Speed of the bob = 2 m/s

Q: The rigid body shown in the figure consists of three particles connected by massless rods. It is to…

A:

Q: A propeller is modeled as five identical uniform rods extending radially from its axis. The length…

A: The moment of inertia of the rod is, I=mL2=2.59 kg0.745 m2=3.72 kg·m2 The angular speed of the…

Q: a solid brass ball of mass 0.280 g will roll smoothly along a loop-the-loop track when released from…

A:

Q: A 2.60-kg hoop 1.60 m in diameter is rolling to the right without slipping on a horizontal floor at…

A:

Q: In the figure, two blocks, of masses 2.00 kg and 3.00 kg, are connected by a light string that…

A: Moment of Inertia: moment of inertia is defined as the property of a body that resists the angular…

Q: A 5.00 kg disk of radius 1.20 m initially rotated at 2.00 rad/s relative to a fixed axis passing…

A: The energy possessed by an object that is in motion, with velocity v is known as the kinetic energy…

Q: Consider a basketball player spinning a ball on the tip of a finger. If a player performs 1.99 J of…

A: The given data are: E=1.99 JC=0.749 mM=0.624 kg Here, E denotes the energy, C denotes the…

Q: A uniform cylindrical grindstone has a mass of 10 kg and a radius of 12 cm. (a) What is the…

A: a) The expression for find rotational kinetic energy is KEr=12Iω2=12Mr222πr602 Plugging values in…

Q: A heavy swing door has a mass of m = 5,000 kg, a width w = 1.9 m, and a height H = 3.3 m. The door…

A:

Q: In a satellite model for a science project, given the masses of the three satellites m=2.2 kg, mR =3…

A:

Q: A uniform solid sphere, of radius R = 1.0 m and mass M = 5.0 kg, rotates freely with a constant…

A: Given : Radius →R=1.0 m Mass →M=5.0 kg  Angular speed →ω=2.0 rad/s

Q: A 4.00 m length of lightweight cord from the spool with a constant acceleration of magnitude 3.00…

A: Length of chord = 4m Radius of cylinder pool = 0.5 m acceleration of chord = 3.0m/s2 Mass = 1.28kg…

Q: A frictionless pulley has the shape of a uniform solid disk of mass 2.50 kg and radius 20.0 cm. A…

A: Given: The mass of the disk is 2.5 kg. The radius of the pulley is 20 cm. The mass of the stone is…

Q: Which of the following increases the rotational inertia of a solid diet about its axis, without…

A: We want to increase the rotational inertia (moment of inertia ) of a solid diet about it's axis,…

Q: A thin, 20-gram hoop with a radius of 2 meters is rolling without slipping, initially along a level…

A: A thin 20gram hoop with a radius  of2m. Centre of mass is moving at 20m/s and rotational speed is…

Q: Trucks can be run on energy stored in a rotating flywheel, with an electric motor getting the…

A: Kinetic energy of a rotating body is given as K.E=12Iω2, where I is moment of inertia of object and…

Angular speed, acceleration and displacement

Angular acceleration is defined as the rate of change in angular velocity with respect to time. It has both magnitude and direction. So, it is a vector quantity.

Angular Position

Before diving into angular position, one should understand the basics of position and its importance along with usage in day-to-day life. When one talks of position, it’s always relative with respect to some other object. For example, position of earth with respect to sun, position of school with respect to house, etc. Angular position is the rotational analogue of linear position.