A vertical tube open to the atmosphere is connected to the vein in the arm of an emergency patient. The height that the blood rises in the tube is to be determined. See figure 7. The mass density of the blood is 1040kg/m³ and the gage pressure was read to be 120 mm of mercury. How heigh should an I.V. plastic tube be raised to force a fluid into the vein of the patient? a.0.57 m d. none of the above b.1.57 m c. 1.24 m

A vertical tube open to the atmosphere is connected to the vein in the arm of an emergency patient. The height that the blood rises in the tube is to be determined. See figure 7. The mass density of the blood is 1040kg/m³ and the gage pressure was read to be 120 mm of mercury. How heigh should an I.V. plastic tube be raised to force a fluid into the vein of the patient? a.0.57 m d. none of the above b.1.57 m c. 1.24 m

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter9: Mass And Mass-related Variables In Engineering

Section: Chapter Questions

Problem 37P

See similar textbooks

Similar questions

1. A 50 mm by 25 mm Venturi meter is installed in a 50 mm diameter horizontal pipe to measure the flow of a certain liquid (sp. gr. 1.30). A differential manometer connected with the inlet and throat of the Venturi meter contains a liquid substance (sp. gr. 2.5) in the lower part of the tube, the remainder of the tube being filled with the certain liquid. The difference in height of substance columns in the two legs of the manometer is 25 cm. If the coefficient of the meter is 0.96, compute the actual discharge and the headloss in the Venturi meter. 2. A 50 mm Venturi meter (C = 0.96) is installed in a 100 mm diameter horizontal pipe carrying oil having a specific gravity of 0.82. If the recorded actual flow in the Venturi meter was 15 liters per second, what could have been the deflection of water in the differential manometer connected between the inlet and the throat? Determine the headloss in the Venturi meter. 3.A fire pump delivers water through a 100 mm main to a hydrant…
A pressure in a given tank reads 265 mm of Hg. Determine the equivalentheight of a certain fluid in m with sp. gr = 3.44.
Pitot PipeBy connecting a mercury pressure gauge to a vertical pipeline through which water is transmitted, speed measurement is performed with a pitot tube. Since the deviation from the pressure gauge column is 15 cm, calculate the speed of the water in the pipe. (Pmercury=13560 kg/m3, Pwater=1000 kg/m3) (Answer is V2=6.08 m/s)
1.) What is the mass (lbm) of an object that has a base area of 4 inch2 which exerts a pressure of 25 psi? 2.) Determine the dynamic viscosity (Pa-sec) and kinematic viscosity (m2/s) of water with a specific weight of 9.81 kN/m3, if a Falling Sphere Viscosimeter test is conducted using an aluminum sphere that has a diameter of 10 mm and a specific weight of 28.06 kN/m3. The theoretical terminal velocity of the sphere is 0.650 m/s. Round off your answer to 3 decimal places. 3.) Given the water tank A in an orifice setup that transfers water to tank B, determine the theoretical and actual velocity and flow rate if the time it takes to fill up tank B is 20 sec. 4.) Given the computed velocities and flow rates in Question 3, determine the coefficient of contraction, velocity, and discharge. Assume the diameter of vena contracta to be 4mmø.
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3.
3.) Given the water tank A in an orifice setup that transfers water to tank B, determine the theoretical and actual velocity and flow rate if the time it takes to fill up tank B is 20 sec. 4.) Given the computed velocities and flow rates in Question 3, determine the coefficient of contraction, velocity, and discharge. Assume the diameter of vena contracta to be 4mmø.
Water flows through a horizontal pipe at a rate of 2.4 gallons per second. The pipe consists of two section of diameters 4 inches and 2 inches in a reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects and taking the specific gravity of mercury as 3.56, determine the manometer reading h.
The pressure difference between two points as measured with a manometer is given as ?2 − ?1 = ??ℎ The following figure shows a single U-tube manometer for measuring pressure difference between points “A” and “B”. By determining the pressure at point “a” through the left leg and then through the right leg, show that the difference in pressure between point “A” ?? and “B” ?? is approximately given by ?? − ?? ≅ ?(ℎ2 − ℎ1)(??2?)
A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined inan internal reservoir inside the closed tank, the height of mercury is 450mm. An openmanometer is placed on the bottom left part of the tank with liquid “X” as its gage liquid , thedeflection from the gage liquid shows 800mm. Determine the following:a) Height of the oil from point A up to point c if height A to C is 5 times the height of y.b) Pressure at point B in kPa. c) Pressure at point C in psi.
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
. A Pitot tube in the pipe in which air s flowing is connected to a manometer containingwater as shown in the figure. If the difference in water levels in the manometer is 87.5mm,what is the velocity of the flow in the pipe, assuming a tube coefficient, CP = 0.99?
The discharge through a 75-mm diameter orifice at the bottom af a large tank was measured be 1.734 liters in 1 minute. if the head over the orifice rermain constant at 5.5 meter, compute the coefficient of diicharge.