(a) What is the characteristic time constant (in s) of a 25.5 mH inductor that has a resistance of 4.15 Q?(b) If it is connected to a 12.0 V battery, what is the current (in A) after 12.5 ms?A

Answered: Image /qna-images/answer/c9d6a77a-6df4-4190-8d2b-4e376e48ced4.jpg

Answered: a) What is the characteristic time…

a) What is the characteristic time constant (in s) of a 25.5 mH inductor that has a resistance of 4.15 0? b) If it is connected to a 12.0 V battery, what is the current (in A) after 12.5 ms? A

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 42P: The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the...

See similar textbooks

Related questions

Q: A 12.0 V battery is connected into a series circuit containing a 14.0 2 resistor and a 1.90 H…

Q: (a) If an inductor carrying a 1.70-A current stores an energy of0.300 mJ, what is its inductance?…

A: The energy stored by an inductor is,

Q: 1. A 0.250 H inductor carries transient current i=0.124cos 2407t.(a) Find the expression for the…

A: Given:Inductor,L=0.250HCurrent,I=0.124cos(240π)t ......(1)Now,A) Induced emf,ee=-Ldidt…

Q: A 24.0-V battery is connected in series with a resistor and an inductor, with R = 5.60 N and L =…

Q: A 14.8-mH inductor carries a current i = Imax sin wt, with Imax = 5.20 A and f = w/2n = 60.0 Hz.…

A: Given: Inductance L = 14.8mH Imax= 5.20 A f=ω2π=60.0Hz or ω=120π Step1:…

Q: A 12.0-V battery is connected into a series circuit containing a 20.0-Ω resistor and a 2.90-H…

A: Given thatResistor R= 20.0-Ω Inductor L= 2.90-H

Q: Two ideal inductors, L1 and L2, have zero internal resistance and are far apart, so their magnetic…

Q: Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 MΩ. (a)…

A: a) Characteristic time constant, τ=LR20×10-9=L5×106L=0.1H

Q: A 521-turn solenoid has a radius of 7.00 mm and an overall length of 15.0 cm. (a) What is its…

A: Given: No. of Turns (N) = 521 Radius (r) = 7 mm = 0.007 m; Length (l) = 15 cm = 0.15 m

Q: Consider a 27.5 mH inductor that has a resistance of 4.25 Ω. a) What is the time constant, τ, of…

Q: A 25.0 H inductor has 100 A of current turned off in 1.00 ms.(a) What voltage is induced to oppose…

Q: a L A current I is flowing through an inductor. At time t = 0, the current is zero and at time t 1s…

A: Answer option(c) point a

Q: The battery terminal voltage in the figure below is E = 7.10 V and the current I reaches half its…

Q: Show that NΦm /I and ε/(dI/dt), which are both expressions for self-inductance, have the same units.

Q: The switch in the figure has been in position 1 for a long time. It is changed to position 2 at t =…

A: a)Charge on the circuit will be,

Q: 20) S. iz R2 R L An inductor with inductance L = 0.5 H and negligible resistance is connected to a…

Q: An inductor in the form of a solenoid contains 410 turns and is 15.0 cm in length. A uniform rate of…

Q: A 14.8-mH inductor carries a current i = Iay sin wt, with I = 4,80 A and f = w/2n = 60.0 Hz. What is…

Q: An inductor that has an inductance of 14.0 H and a resistance of 40.0 is connected across a 100 V…

Q: The 5.16 A current through a 1.50 H inductor is dissipated by a 1.912 resistor in a circuit like…

Q: What capacitance (in pF) do you need to produce a resonant frequency of 2.00 GHz, when using a 5.00…

Q: Suppose a 57.5 cm long, 11.5 cm diameter solenoid has 1000 loops. Part (a) Calculate the…

A: Answer:- Given The length of the solenoid(xo) = 57.5 cm = 0.575 m The diameter of the…

Q: A 1.65 H inductor in an RL circuit (with resistance 1.8 Ω) is initially carrying a current of 4.95…

A: Given that:- Inductance of inductor=L=1.65H

Q: I Review To determine the inductance of an unmarked inductor, you set up the circuit shown in the…

A: L= 3.03 mH

Q: In the shown below circuit, the switch closes at t=0. 50 10 V 5 mH a) What is the difference of…

A: To determine,Part aThe difference of potential(V) on the resistor after a long time.part bThe…

Q: An inductor (L = 20 mH), a resistor (R = 100 and a battery (E = 10 V) are connected in series. Find…

A: The inductance of the inductor is L=20 mH The resistance of the resistor is R=100Ω The voltage of…

Q: A 510-turn solenoid has a radius of 7.95 mm and an overall length of 13.2 cm. (a) What is its…

A: Given : Number of turns, N = 510 radius, r = 7.95 mm Length, l = 13.2 cm = 132 mm Area , A = πr2…

Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. (a) What is its…

Q: A powdered iron (Bsat = 1 T) toroid core has µ = 25µ0 (µ0 = 4π × 10-7 H/m). The outside diameter is…

A: The inductance of the toroid be defined as, Where, r be defined as the toroid radius to centreline…

Q: A series RLCcircuit consists of a 75 Ω resistor, a 0.19 H inductor, and a 25 μFcapacitor. It is…

A: Resistance, R = 75 Ω Inductance , L = 0.19 H Capacitance , C = 25 μF Frequency , f = 60 Hz VRMS =…

Q: I need help with this question

Q: A 15.0-mH inductor carries a current i = Imay sin wt, with Imay = 5.40 A and f= w/2n 60.0 Hz. What…

A: Inductance = L = 15×10-3 H Current = i=Imaxsinωt Maximum current = Imax=5.4 A Frequency = f = 60 Hz…

Q: A circuit consists of 18 volts battery, a 72 mH inductor and two 50 ohms resistors connected in…

Q: An inductor that has an inductance of 19.0 H and a resistance of 26.0 N is connected across a 100 V…

Q: A 19.0 mH inductor, an 6.00 Ω resistor, and a 9.00 V battery are connected in series. The switch is…

A: For a DC voltage supply the the net resistance of the inductor is zero. So net resistance in the…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

(a) What is the characteristic time constant (in s) of a 25.5 mH inductor that has a resistance of 4.15 Q?
(b) If it is connected to a 12.0 V battery, what is the current (in A) after 12.5 ms?
A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
In an oscillating RLC circuit with L = 10 mH, C = 1.5 F , and R = 2.0 , how much time elapses before the amplitude of the oscillations drops to half its initial value?
The current I(t) through a 5.0-mH inductor varies with time, as shown below. The resistance of the inductor is 5.0 . Calculate the voltage across the inductor at t = 2.0 ms, r = 4.0 ms, and t = 8.0 ms.
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?