(a) What is the function of Digital to Analog Converter (DAC? Mention its types. Write the truth table of 4 bit DAC L

Q: Q3: what is the output of the successive-approximation register SAR of the Successive- Approximation…

A: We need to find the output of the successive approximation ADC in which analog input voltage given…

Q: Consider a 12-bit ADC with a reference voltage of 3.3 V operating in single-ended mode. If it…

A:

Q: (II) Consider a rather coarse 4-bit analog-to-digital conversion where the maximum voltage is 5.0 V.…

A: Given: Voltage= 5.0 V.

Q: What are the values of Aυ, Rin, Rout, and Ai for the common-gate stage shown operating with gm = 0.6…

A: Given gm= 0.6 mS, RI = 50 ohm, R4 = 3 KΩ, RL = 82 KΩ Calculating input resistance of common gate…

Q: (a) Discuss, 1) the major differences between ficld programmable gate arrays (FPGAS) and…

A: (a) FPGA is a digital logic chip that can be programmed to do almost any kind of digital function.…

Q: Design a 4 input multiplexer using logic diagram and truth table.

A: The basic structure of the 2 into 1 multiplexer consists of four inputs, there are also two select…

Q: Derive the state table and the state graph for the following logic circuit: A' B' B DA Clock Clock X…

A: The solution is given below

Q: 5. What is the function of the digital circuit shown below? Describe its operation briefly and find…

A: Digital Circuits: A digital circuit is created by combining several logic gates on a single…

Q: What is the main difference between combinational and sequential logic circuits.

A: 1 Combinational  Circuit is the circuit in which output is independent of time and only dependent on…

Q: In Assembely Language design the ALU that perform the following functionalities: using emu 8086.

A: The Answer :

Q: What is a differential input combined with a single-ended output? What is an inverted differential…

A: Types of differential amplifier based on input and output  Singal input unbalanced output…

Q: Include memory elements and combinational circuit Integrated circuit O Sequential network…

A: Given: Combinational circuit

Q: Write an 8088/8086 assembly program that counts the length of a null terminated string that starts…

A: Microprocessor Programming : The "jargon" of directions which a specific microchip chip has is…

Q: 1. How many resistors and switches would be required to implement a 6-bit resistor-string DAC?.

A: As per the guidelines of bartleyby I need to answer only first question.So kindly repost other…

Q: is it possible to connect the outputs of a comparator to a logic gate (connected to an led)? The led…

A: Steps Let both inputs are low or high at a time and find output of comparator Apply K-Map concept…

Q: What is the reason for using CRT used instead of LCD or LED displays? a) To meet the required…

A: Given: CRT: CRT stands for cathode ray tube. It is a vacuum tube containing one or more electron…

Q: What is a TTL circuit? What are their main characteristics? (Input voltage and current, output…

A: TTL Circuit It is abbreviated as Transistor-Transistor Logic. It comes under the category of the…

Q: Draw 8259A interfacing connections with 8086 at the address 0744H.

A: The 8259A interfacing connection with 8086 at address 0744h is shown below:

Q: Draw the circuit schematic for a three-input CML XOR gate.

A: Given: The three-input CML XOR gate circuit diagram is shown as:

Q: A 5-bit ADC has the following reference values Vref = -2V and 12 V.  What is the voltage represented…

A: GIVEN Vref = -2V and 12 V sequence =01010 n=5 bit

Q: a) Derive the state diagram, describe the meaning of each state clearly. Specify the type of the…

A: The Given data is n0+1710=abcdefg2 To design a synchronous sequence detector circuit that detects '…

Q: Determine at least three contemporary tools that may aid in the design of digital logic circuits.…

A: A digital circuit is often made up of logic gates, which are miniature electrical circuits that may…

Q: Q5. Design a code converter circuit that converts 2 bits binary number system to Gray code.

A:

Q: Design a system of OpAmps using a summer and inverter that produces the output 3v1 - 7v2

A: Given, A Op amps using a summer and inverter that produces the output Vo=3V1-7V2

Q: Which of these 12 bit converters is the fastest at converting an analog signal to a digital signal?…

A: The fastest type of converter is one which takes very less time in conversion of the analog signal…

Q: A 12-bit D/A converter has VREF = 5.12 V. What is the output voltage for a binary input code of…

A: Given binary input code (101010101010)2 Converting given input binary code into decimal code…

Q: Suppose a 10-bit DAC is built using the inherently monotonic circuit technique as shown. (a) If the…

A: Concept: A measure of the opposition to current flow in an electrical circuit is defined as…

Q: Consider a 12 -bit ADC and full scale voltage measurement range of – 12V to + 12V. Find the…

A:

Q: Given a 5-bit ADC with the following reference values Vref= -2V and 12V, what is the voltage…

A: The solution is given below.

Q: Q2) Derive the NOT gate and then sketch the MUX equivalen?

A:

Q: Write the equivalent Logic equation of the circuit Vcc 3 1 24

A: Given gate is OR gate whose output given by Y= w+x

Q: 2- Discuss the advantages and disadvantages of the counter-type ADC. 3- Is the conversion time of…

A: Question 2 Advantages of counter-type ADC:   (1) It is a one-bit quantizer. (2) In counter-type ADC…

Q: Q1:What is the equivalent circuit using AND, OR and invertor? then write the logical expression of…

A: To find the logical expression of the circuit and also draw the equivalent diagram

Q: Based from your own insight, what is a logic gate and what is the importance it brings in the field…

A:

Q: What’s the difference between sequential and combinational circuits? Also explain what’s the…

A:

Q: Q2) A) Express the decimal number (- 30 ) as an 8-bit number in 2's complement form, and verifying…

A:

Q: How can I implement 4035 ic as a parallel input and serial output?

A: For implementation of 4035 IC as a parallel inputs we have to use pin number 9, 10, 11, 12 or Pin…

Q: Examine the output of the 8 bit DAC converter whose output range is 0 to first two digits of VTU…

A:

Q: In the 5-state state diagram in the figure, use the symbols X for input and Y and Z for outputs,…

A:

Q: Givean example of biomedical sensor that uses MEMS technology. Briefly describe the sensor, its…

A:

Q: 1. How many resistors and switches would be required to implement a 6-bit resistor-string DAC?

A: Number of resistors = 64 Number of switches = 63 Go through below for the explanation

Q: A8 bit ADC has generated a digital representation of 11001100 using the successive approximation…

A:

Q: Compare the maximum conversion times of a 8-bit digital-ram p ADC and a 8-bit successive-…

A:

Q: What is Grey Coding?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: one method of eliminating contact bounce wherein it triggers on the first contact bounce instead of…

A: To select proper answers from options.

Q: a) Sketch a 4-bit R/2R DAC circuit and explain briefly the operating principle b) What should be the…

A: According to the question, we need to explain the 4-bit R-2R ladder DAC circuit.

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.