A wheel of radius 0.4 m consists of a ring of mass 1.2 kg and two rods of length 0.8m and mass 0.4 kg each attached to the ring as shown in the diagram. The wheel is free to rotate about an axis through the center. Determine the angular acceleration of the wheel when 12 N tangential force is applied on the wheel 12 N

A wheel of radius 0.4 m consists of a ring of mass 1.2 kg and two rods of length 0.8m and mass 0.4 kg each attached to the ring as shown in the diagram. The wheel is free to rotate about an axis through the center. Determine the angular acceleration of the wheel when 12 N tangential force is applied on the wheel 12 N

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter12: Rotation I: Kinematics And Dynamics

Section: Chapter Questions

Problem 20PQ: A wheel starts from rest and in 12.65 s is rotating with an angular speed of 5.435 rad/s. a. Find...

See similar textbooks

Similar questions

Given the disk and density in Problem 11, derive an expression for the rotational inertia of this disk around an axis at theedge of the disk and perpendicular to the disks surface.
Suppose a child gets off a rotating merry-go-round, Does the angular velocity of the merry-go-round increase, decrease, or remain the same if: (a) He jumps off radially? (b) He Jumps backward to land motionless? (c) He jumps straight up and hangs onto an overhead tree branch? (d) He jumps off forward, tangential to the edge? Explain your answers. (Refer to Figure 10.34).
Consider the 12.0 kg motorcycle wheel shown in Figure 10.38. Assume it to be approximately an annular ring with an inner radius of 0.280 m and an outer radius of 0.330 m. The motorcycle is on its center stand, so that the wheel can spin freely. (a) If the drive chain exerts a force of 2200 N at a radius of 5.00 cm, what is the angular acceleration of the wheel? (b) What is the tangential acceleration of a point on the outer edge of the tire? (c) How long, starting from rest, does it take to reach an angular velocity of 80.0 rad/s? Figure 10.38 A motorcycle wheel has a moment of inertia approximately
The angular velocity of a flywheel with radius 1.0 m varies according to (t)=2.0t . Plot ac(t) and at(t) from t=0 to 3.0 s for r=1.0m . Analyze these results to explain when acat and when acat for a point on the flywheel at a radius of 1.0 m.
Calculate the rotational kinetic energy of a 12-kg motorcycle wheel if its angular velocity is 120 rad/s and its inner radius is 0.280 m and outer radius 0.330 m.
A rod of length 20 cm has two beads attached to its ends. The rod with beads starts rotating from rest. If the beads are to have a tangential speed of 20 m/s in 7 s, what is the angular acceleration of the rod to achieve this?
Suppose a child walks from the outer edge of a rotating merry-go-round to the inside. Does the angular velocity of the merry-go-round increase, decrease, or remain the same? Explain your answer. Assume the merry-go-round is spinning without friction.
An electric sander consisting of a rotating disk of mass 0.7 kg and radius 10 cm rotates at 15 rev/sec. When applied to a rough wooden wall the rotation rate decreases by 20 . (a) What is the final rotational kinetic energy of the rotating disk? (a) How much has its rotational kinetic energy decreased?
A potters wheela thick stone disk of radius 0.500 in and mass 100 kgis freely rotating at 50.0 rev/min. The potter can stop the wheel in 6.00 s by pressing a wet rag against the rim and exerting a radially inward force of 70.0 N. Find the effective coefficient of kinetic friction between wheel and rag.
CHECK and THINK Our results give us a way to think about how a person might steer a unicycle. Consider the person, the unicycle, and the Earth as the system. No net torque acts on the system. Ignoring the motion of the Earth, Figure 13.37A shows the initial angular momentum of the system with the unicycle in motion: Li=Ltire. The person leans to his left so that the angular momentum of the tire rotates downward. The total angular momentum must still point to the right (Fig. 13.37B), so the angular momentum of the person must be upward to compensate. The persons angular velocity therefore points upward (parallel to his own angular momentum), and he is able to make a turn. Another way to analyze this situation is to exclude the Earth from the system and calculate the torque done by gravity. This approach is left as a homework problem. FIGURE 13.37 C Reanalyze the unicycles motion in Example 13.15 (page 382). This time, leave the Earth out of the system and explain how the torque exerted by gravity causes the unicycle to turn. Your explanation should involve a diagram.
A clay cylinder of radius 20 cm on a potter’s wheel spins at a constant rate of 10 rev/s. The potter applies a force of 10 N to the clay with his hands where the coefficient of friction is 0.1 between his hands and the clay. What is the power that the potter has to deliver to the wheel to keep it rotating at this constant rate?
This problem considers additional aspects of example Calculating the Effect of Mass Distribution on a Merry-Go-Round. (a) How long does it take the father to give the merry-go-round an angular velocity of 1.50 rad/s? (b) How many revolutions must he go through to generate this velocity? (c) If he exerts a slowing force of 300 N at a radius of 1.35 m, how long would it take him to stop them?