A Y-connected balanced 3 phase source with z-0.2+j0. 1/phase is connected to a Y-connected balanced load with z= 30 + j29 /phase. The line joining the source and the load has z = 0.9+ j0.1/phase. Assuming a + sequence for the source voltages and that Van= 110 L 20 V, find the line voltage and Q 4: current.

A Y-connected balanced 3 phase source with z-0.2+j0. 1/phase is connected to a Y-connected balanced load with z= 30 + j29 /phase. The line joining the source and the load has z = 0.9+ j0.1/phase. Assuming a + sequence for the source voltages and that Van= 110 L 20 V, find the line voltage and Q 4: current.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.24MCQ: Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line...

See similar textbooks

Similar questions

Figure 2.33 gives the general -Y transformation. (a) Show that the general transformation reduces to that given in Figure 2.16 for a balanced three-phase load. (b) Determine the impedances of the equivalent Y for the following impedances: ZAB=j10,ZBC=j20, and ZCA=j25. ZAB=ZAZB+ZBAC+ZCZAZCZA=ZABZCAZAB+ZBC+ZCAZBC=ZAZB+ZBAC+ZCZAZAZB=ZABZBCZAB+ZBC+ZCAZCA=ZAZB+ZBAC+ZCZAZBZA=ZCAZBCZAB+ZBC+ZCA
Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line currents as well as the neutral current are always zero. (a) True (b) False
Having a phase impedance of 23.7 + j17.1 Ω at 50 Hz given in Figure Δ-connected load, Y-joint source resulting in 400 V and 50 Hz with impedance 0.1 + j0.3 Ω on each line fed by. According to this, a) Find the line flow and load voltage. b) Find the load-arm currents. c) There are active and protective forces produced by the source.
A balanced, positive-sequence, Y-connected voltage source with Eab = 480∠0o volts is applied to abalanced-∆ load with Z∆ = 30 ∠40o Ω. The line impedance between the source and load is ZL = 1 ∠850 Ω.for each phase. Calculate the line currents, the ∆ -load currents, and the voltages at the load terminals.Recall that ZY = Z∆/3
It is powered from a grounded Y-balanced three-phase source. The installations have four balanced three-phase loads: Load 1: 150 kVA Y with pf 0.8 (+), Load 2: 100 kW ∆ with pf 1.0, Load 3: 120 kW Y with pf 0.6 (-), Load 4: 80 kW and 95 kVAR (inductive - ∆). If the line impedance is 0.02 + j0.05 Ω per phase and the line voltage across the loads is 480 V, find the magnitude of the line and phase voltages at the source. Draw the phasor diagram of the voltages.
A balanced three-phase source with grounded neutral has line-to-neutral voltages of 132.7906 volts with an-bn-cn sequence. This source has an internal series impedance of 0.2+j2.5 ohms per phase. It supplies power to an unbalanced three-phase wye, neutral grounded, load with impedances: Zan = 18-j10; Zbn = 15+j25; Zcn = 20+j30 ohms. If line a is open creating a series fault at line load-side, what is the magnitude of the line current in line b in amperes?
The one-line diagram of a three-phase power system is as shown in the figure attached. Impedances are marked in per unit on a 100-MVA, 400-kv base. The load at bus 2 is S(sub 2) = 15.93 MW - j33.4 Mvar, and bus 3 is S(sub 3) = 77MW + j14 Mvar. I tis required to hold the voltage at bus 3 at 400 angle 0 degrees kV. Working in per unit, determine the voltage at buses 2 and 1.
Using two wattmeter method, w2 is connected in line a while w1 is conencted in line c. This is a balanced three-phase inductive load connected in delta and to a 100V abc source. If w2 reads 900W and pf = 0.8, find a. line currents b. reading of w1 c. show the power triangle illustration of the load
Star connected source with 3-phase balanced positive phase sequence feeds the delta connected system. The source phase voltage is given as Van=120∠80Vrms. If the line impedance is given as RL=0.2+j0.5 and the impedance of each phase of the balanced load is Z=6+j8 a) Find the amplitude of the current in the delta load? b) Find the amplitude of the voltage VA? c) Find the angle of voltage VA? d) Write the angle of the IAB current in degrees?
A balanced three-phase source with grounded neutral has line-to-neutral voltages of 132.7906 volts with an-bn-cn sequence. This source has an internal series impedance of 0.2+j2.5 ohms per phase. It supplies power to an unbalanced three-phase wye, neutral grounded, load with impedances: Zan = 18-j10; Zbn = 15+j25; Zcn = 20+j30 ohms. If there is a line-to-line fault at lines b and c load-side, what is the magnitude of the fault current in amperes?
2. A balanced three-phase source furnishes power to the following three loads: Load 1: 8 kVA at 0.83 pf lagging Load 2: unknown Load 3: 10 kVA at 0.7071 pf leading If the line current is 72 Arms, the line voltage at the load is 221 Vrms, and the combined load has a 0.8 pf lagging, determine the unknown load.
The following three-phase circuit is symmetrical, with line voltage 220 V, 60 Hz, direct phase sequence, isolated neutral and the value of the impedances of the loads in the three phases are: Zan = 10 ohms Zbn = -10j ohm Zcn = -10j Ohm Find:a) Phase voltages on the load;b) Line and phase currents;c) The power supplied to the load. Consider the phase voltage in the reference(Va voltage angle equal to 0)